INTERNATIONAL 7500 Recalls

Nov 17, 2010 – NAVISTAR IS RECALLING CERTAIN MODEL YEAR 2011 INTERNATIONAL 7300, 7400, AND 7500 VEHICLES MANUFACTURED FROM JUNE 30, 2010, THROUGH OCTOBER 13, 2010. THESE VEHICLES WERE BUILT WITH AN INCORRECT STEERING SYSTEM DRAGLINK.

Oct 05, 2010 – NAVISTAR IS RECALLING CERTAIN MODEL YEAR 2011 INTERNATIONAL 7300, 7400, 7500, VEHICLES FOR FAILING TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108,DS"'LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT." THESE VEHICLES ARE INSTALLED WITH IMPROPER HEADLIGHT HEIGHT OF 55.5 INCHES AND THE CORRECT HEIGHT SHOULD BE 54 INCHES.

Mar 18, 2010 – NAVISTAR HAS NOTIFIED NHTSA OF A DEFECT ON CERTAIN MODEL YEAR 2008-2011 INTERNATIONAL TRUCKS EQUIPPED WITH AN OPTIONAL JUMP START STUD. CORROSION AT THE BASE OF THE STUD MAY CAUSE AN ELECTRICAL SHORT BETWEEN THE STUD AND BATTERY BOX.

Mar 30, 2009 – NAVISTAR IS RECALL 7,521 MY 2009 INTERNATIONAL MODEL TRUCKS AND MY 2009 AND 2010 IC SCHOOL AND TRANSIT BUSES MANUFACTURED FROM APRIL 1, 2008 TO DECEMBER 12, 2008, EQUIPPED WITH A HORTON 2-SPEED FAN DRIVE, IDENTIFIED BY FEATURE CODE 12THT. THE FASTENERS THAT CONNECT THE MAGNET BRACKETS TO THE AIR CHAMBER HOUSING OF THE 2-SPEED ENGINE FAN COULD FAIL RESULTING IN THE MAGNET BRACKET BEING THROWN FROM THE FAN DRIVE AND THE VEHICLE AT HIGH SPEED.

Feb 27, 2008 – INTERNATIONAL IS RECALLING 34,993 MY 2006-2008 SCHOOL AND TRANSIT BUSES AND HEAVY DUTY TRUCKS/TRACTORS MANUFACTURED BETWEEN JUNE 1, 2006 AND JUNE 28, 2007, EQUIPPED WITH INTERNATIONAL DT466 OR DT570 ENGINES. THE BASE PLATE OF THE ENGINE OIL COOLER MAY CRACK ALLOWING PRESSURIZED OIL TO LEAK INTO THE ENGINE COMPARTMENT.

Jul 24, 2007 – ON CERTAIN 6X4 OR 6X6 TRUCKS WITH AIR BRAKES OR TRACTORS WITH AIR BRAKES AND EQUIPPED WITH BENDIX SR-7 SPRING BRAKE MODULATING VALVES, THE INTERNAL RUBBER CHECK VALVE MAY LEAK CAUSING A DELAY IN THE APPLICATION OF THE SPRING BRAKES TO PARK THE VEHICLE AFTER THE OPERATOR PULLS THE DASH VALVE BUTTON.

Jun 04, 2007 – ON CERTAIN TRUCKS, THE REAR-REAR AXLE BRAKE SLACK ADJUSTERS MAY CONTACT THE REAR AXLE HOUSING PREVENTING THE BRAKES FROM BEING FULLY APPLIED POSSIBLY CAUSING EXTENDED STOPPING DISTANCES.

Apr 24, 2007 – ON CERTAIN TRUCKS, ONE OR BOTH REAR AXLE HOUSINGS MAY CONTAIN THINNER MATERIAL THAN WHAT IS NECESSARY FOR NORMAL VEHICLE OPERATION. OVER TIME, THIS THINNER MATERIAL MAY RESULT IN A FATIGUE FAILURE OF THE REAR AXLE HOUSING, POSSIBLY IN THE LOCATION OF THE BRAKE FLANGE.

Oct 11, 2006 – ON CERTAIN TRUCKS EQUIPPED WITH CHALMERS REAR SUSPENSIONS, THE ADJUSTABLE TORQUE ROD END CASTINGS MAY BE BRITTLE. A BRITTLE ROD END CASTING MAY FRACTURE WITHOUT WARNING, CAUSING THE VEHICLES' REAR AXLES TO BECOME MISALIGNED.

Jun 28, 2006 – ON CERTAIN TRUCKS EQUIPPED WITH SR-7 BENDIX BRAKE VALVES, THE CHECK VALVE INSIDE THE VALVE CAVITY MAY NOT PROPERLY SET, CAUSING INTERNAL AIR LEAKAGE. IF THE CHECK VALVE DOES NOT PROPERLY SEAT, THE RESULTING LEAKAGE CAN CAUSE A DELAY IN THE APPLICATION OF THE SPRING BRAKES TO PARK THE VEHICLE AFTER OPERATOR PULLS THE DASH VALVE BUTTON.