INTERNATIONAL 8600 Recalls

Nov 25, 2025 – International Motors, LLC (International) is recalling certain 2016 7600, 2016-2023 Lonestar, 2018 8600, 2018-2023 LT, 2021-2026 MV, 2022-2023 RH, 2023-2026 HX, and 2025-2026 HV vehicles. Electrical noise and low signal to the power line carrier may cause the ECU to incorrectly process commands or stop working.

May 18, 2023 – Navistar, Inc. (Navistar) is recalling certain 2000-2003 International 8100, 2001-2003 International 9100i, 2001-2007 International 9400i, 2001-2010 International 9200i, 2002-2007, 2009 International 8500, 2003-2007, 2013 International 9900i, 2003-2018 International 8600, 2004, 2007 International 9900iX, 2008-2018 International ProStar, 2010-2011, 2013, 2016 International LoneStar, 2011-2012, 2016 International 4400, 2017-2024 International LT, 2018-2024 International RH, 2019-2021 International LS, 2019-2024 International MV vehicles. The back-up lights offer low visibility when the vehicle is in reverse and bobtail mode. Also, the vehicles have not been equipped with additional unobstructed back-up lights. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard number 108, "Lamps, Reflective Devices, and Associated Equipment."

Sep 20, 2012 – Navistar is recalling certain model year 2013 International 8600, 2012 and 2013 Durastar, 2011-2013 ProStar, and 2012 WorkStar trucks, manufactured from November 23, 2010, through April 02, 2012, and equipped with piston spring brake feature code 04EVP. The piston bore area of the parking brake chamber may have an air leak could result in the parking brake not fully releasing.

Jun 14, 2010 – NAVISTAR IS RECALLING CERTAIN MODEL YEAR 2010 AND 2011 INTERNATIONAL 4300M, 8600, LONESTAR AND PROSTAR BRAND TRUCKS MANUFACTURED FROM MAY 6, 2009 THROUGH MAY 25, 2010. THE FASTENER THAT CLAMPS THE PITMAN ARM TO THE STEERING GEAR SHAFT MAY HAVE BEEN UNDERTORQUED UPON ASSEMBLY. AN UNDER TORQUE CONDITION MAY CAUSE WEAR OF THE INTERCONNECTING SPLINES OF THE ARM AND THE SHAFT POSSIBLY ALLOWING THE PITMAN ARM TO SLIP OVER THE SHAFT RESULTING IN A REDUCTION OF STEERING CONTROL.

Mar 18, 2010 – NAVISTAR HAS NOTIFIED NHTSA OF A DEFECT ON CERTAIN MODEL YEAR 2008-2011 INTERNATIONAL TRUCKS EQUIPPED WITH AN OPTIONAL JUMP START STUD. CORROSION AT THE BASE OF THE STUD MAY CAUSE AN ELECTRICAL SHORT BETWEEN THE STUD AND BATTERY BOX.

Aug 22, 2007 – ON CERTAIN HEAVY DUTY CLASS 8 TRUCKS BUILT WITH CUMMINS ISM C876 ENGINES, THE ELECTRONIC CONTROL MODULE FAILS TO RECOGNIZE INPUTS OF THE VEHICLE ELECTRONIC CONTROL UNIT OR FROM A DRIVER ACTUATED DASH SWITCH THEREBY INCREASING THE RISK OF UNINTENDED (OR UNEXPECTED) ELEVATED EXHAUST TEMPERATURES.

Jul 24, 2007 – ON CERTAIN 6X4 OR 6X6 TRUCKS WITH AIR BRAKES OR TRACTORS WITH AIR BRAKES AND EQUIPPED WITH BENDIX SR-7 SPRING BRAKE MODULATING VALVES, THE INTERNAL RUBBER CHECK VALVE MAY LEAK CAUSING A DELAY IN THE APPLICATION OF THE SPRING BRAKES TO PARK THE VEHICLE AFTER THE OPERATOR PULLS THE DASH VALVE BUTTON.

Apr 24, 2007 – ON CERTAIN TRUCKS, ONE OR BOTH REAR AXLE HOUSINGS MAY CONTAIN THINNER MATERIAL THAN WHAT IS NECESSARY FOR NORMAL VEHICLE OPERATION. OVER TIME, THIS THINNER MATERIAL MAY RESULT IN A FATIGUE FAILURE OF THE REAR AXLE HOUSING, POSSIBLY IN THE LOCATION OF THE BRAKE FLANGE.

Apr 24, 2007 – ON CERTAIN TRUCKS EQUIPPED WITH DAVCO FUEL PRO 382 HEATED FUEL FILTERS, WHEN THE KEY IS IN THE 'ON' POSITION, THE PRE-HEATER, LOCATED IN THE FUEL FILTER BASE, IS ENERGIZED.

Dec 21, 2005 – ON CERTAIN HEAVY DUTY TRUCKS EQUIPPED WITH CATERPILLAR DIESEL ENGINES, THE ENGINE ELECTRICAL GROUND CABLE THAT CONNECTS THE ENGINE BLOCK WITH THE STARTER MAY BE ROUTED IN A WAY THAT COULD CAUSE CHAFING AGAINST THE STARTER'S POSITIVE BATTERY CABLES.