INTERNATIONAL 9900I Recalls

Aug 25, 2004 – ON CERTAIN TRUCKS, ONLY EIGHT (8) BOLTS WERE INSTALLED IN THE BRAKE GROUP CONNECTION TO THE REAR AXLES. THE BRAKE GROUP, AN ASSEMBLY THAT INCLUDES THE BRAKE SHOES, AIR CHAMBERS, SLACK ADJUSTERS, AND SPIDER, IR NORMALLY ATTACHED TO THE AXLE HOUSING WITH NINE (9) BOLTS.

Aug 25, 2004 – ON CERTAIN TRUCKS, THE FRONT, NON-DRIVE AXLE, COTTER KEYS AND SPINDLE NUT RETAINERS WERE NOT INSTALLED. THE COTTER KEY AND SPINDLE NUT RETAINER PREVENT THE SPINDLE NUT FROM LOOSENING AND THUS AID IN WHEEL RETENTION.

Jun 30, 2004 – ON CERTAIN HEAVY DUTY TRUCKS, THE ENGINE ELECTRICAL HARNESS CAN CHAFE AGAINST SHARP EDGES ON THE ENGINE.

Feb 27, 2004 – ON CERTAIN CONVENTIONAL TRUCKS EQUIPPED WITH PRO-SLEEPER BERTHS, WATER INTRUSION CAN BE FOUND IN THE BUNK CONTROL PANEL AREA AND POOL IN THE TOPS OF THE DOME LIGHT, TV/VCR, AND OR REFRIGERATOR POWER SWITCHES.

Jul 28, 2003 – ON CERTAIN HEAVY DUTY TRUCKS, THE DRAG LINK WILL INTERFERE WITH THE FRONT, DRIVER'S SIDE, BRAKE CHAMBER AND SLACK ADJUSTER. THIS INTERFERENCE COULD CAUSE DAMAGE TO THE SLACK ADJUSTER AND RENDER IT INOPERABLE.

Mar 06, 2003 – ON CERTAIN HEAVY DUTY TRUCKS BUILT WITH A DETROIT ENGINE AND A LEECE NEVILLE ALTERNATOR. THE ELECTRICAL TERMINAL AT THE ALTERNATOR END OF THE CABLE THAT RUNS FROM THE STARTER TO THE BATTERY STUD ON THE ALTERNATOR MAY BREAK OFF, DUE TO VIBRATION IN THE CABLE.

Nov 15, 2002 – ON CERTAIN HEAVY DUTY TRUCKS, THE BOLTS AND LOCKING NUTS USED TO HOLD THE BRAKE SPIDERS OR BRAKE ANCHOR PLATES TIGHT TO THE AXLES WERE UNDER-TORQUED ON THE RIGHT SIDE OF THE VEHICLES. IF THE CLAMP LOAD ON THE BOLTS IS NOT SUFFICIENT, THE ANCHOR PLATE MAY MOVE WHEN THE BRAKE IS APPLIED IN EITHER THE FORWARD OR REVERSE DIRECTION.

Feb 01, 2001 – VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS EQUIPPED WITH AIR BRAKE HALDEX AUTOMATIC SLACK ADJUSTERS, LONG STROKE BRAKE CHAMBERS, AND DANA BRAKES. THE AUTOMATIC SLACK ADJUSTER ANCHOR BRACKETS CAN FAIL DUE TO FATIGUE FRACTURE AND COMPLETELY SEPARATE, CAUSING THE SLACK ADJUSTERS TO FUNCTION AS MANUAL SLACK ADJUSTERS.

Jun 06, 2000 – VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS EQUIPPED WITH EATON AUTOSHIFT GEN II TRANSMISSION ASSEMBLIES. DUE TO A SOFTWARE PROBLEM IN THE TRANSMISSION ASSEMBLIES, THE TRANSMISSION WILL SELECT THE WRONG GEAR.

May 23, 2000 – VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS BUILT WITH INTERNATIONAL CODE 16SCH (LOWER BUNK WEBBING RESTRAINT). INCORRECT BOLTS WERE USED TO HOLD THE BUNK WEBBING RESTRAINT LATCH BRACKETS TO THE BUNK BASE.