JEEP Recalls

Dec 14, 1992 – THE RETAINER CLIP WHICH SECURES THE MASTER CYLINDER INPUT ROD TO THE BRAKE PEDAL WAS NOT INSTALLED PROPERLY, AND COULD WORK LOOSE.

Oct 14, 1992 – ON 1987 THROUGH EARLY 1990 MODELS, BOTH FRONT BRAKE HOSES CAN WEAR DUE TO DIRECT CONTACT WITH THE WHEEL OPENING SPLASH SHIELDS. ON THE LATE 1990 THROUGH 1992 MODELS, PERIODIC RUBBING CONTACT OF THE LEFT FRONT BRAKE HOSE CAN OCCUR DUE TO MOVEMENT OF THE SPLASH SHIELD IN CERTAIN VEHICLE OPERATING CONDITIONS.

Oct 02, 1991 – THERE MAY BE HYDRAULIC FLUID CONTAMINATION FROM CONDENSATION FORMATION THAT CAN PLUG THE ABS BRAKE BOOSTER PUMP FILTER; STRESS CORROSION OF THE MASTER CYLINDER SNAP RING HAS BEEN TRACED TO CHLORINE LEAKING FROM THE LOW PRESSURE HYDRAULIC HOSE WHICH MAY CAUSE IT TO BREAK; FRONT BRAKE HOSE TO TIRE INTERFERENCE WHICH MAY CAUSE FAILURE OF THE BRAKE HOSE.

Apr 15, 1991 – IMPROPER INSERTION/CRIMPING OF THE HOSE-TO-END FITTINGS OF THE HIGH PRESSURE HOSE ON THE ANTI-LOCK BRAKE SYSTEM CAN CAUSE DETACHMENT OF THE HOSE FROM THE ABS SYSTEM, AND DISCHARGE OF HYDRAULIC FLUID.

Feb 11, 1991 – IMPROPERLY INSTALLED BRAKE FLUID TUBE MAY ALLOW THE TUBE TO CONTACT THE STEERING INTERMEDIATE SHAFT DAMAGING THE TUBE.

Dec 18, 1990 – SUSPENSION JOUNCE BUMPER COULD CONTACT LEFT REAR WHEEL BRAKE TUBE WHEN SUSPENSION IS AT FULL JOUNCE (BOUNCE).

Oct 03, 1990 – CERTIFICATION LABEL DOES NOT CONTAIN REQUIRED TIRE AND WHEEL INFORMATION.

Oct 02, 1990 – MALFUNCTION OF FUEL INJECTION SYSTEM THROTTLE POSTITION SENSOR COULD CAUSE INTERMITTENT HIGH ENGINE IDLE SPEED IMMEDIATELY AFTER STARTING ENGINE.

Sep 20, 1990 – IN A REAR IMPACT COLLISSION, FUEL TANK MAY LEAK FUEL IN EXCESS OF AMOUNT ALLOWED BY FMVSS 301 BECAUSE OF MISBUILT FUEL TANK SKID PLATES.

Nov 21, 1989 – TIRE RESERVE LOAD LABEL MAY NOT HAVE BEEN INSTALLED.