JEEP Recalls

Jan 04, 1981 – THE TRANSMISSION THROTTLE CONTROL ROD SPRING MAY HAVE BEEN IMPROPERLY INSTALLED. THIS MAY CAUSE THE THROTTLE TO CLOSE MORE SLOWLY THAN NORMAL. VEHICLES MAY RETURN TO IDLE SLOWLY.

Dec 05, 1980 – SOME OF THE INVOLVED VEHICLES WERE ASSEMBLED WITH TONGUE-END REAR SEAT BELT ASSEMBLIES INSTEAD OF THE BUCKLE END AND TONGUE-END ASSEMBLIES. WITHOUT THE BUCKLE END ASSEMBLIES, THE REAR SEAT BELTS CANNOT BE FASTENED.

Mar 05, 1980 – THE RIGHT AND LEFT REAR WHEEL BEARINGS MAY HAVE BEEN DAMAGED DURING ASSEMBLY. A DAMAGED BEARING COULD RESULT IN AXLE AND WHEEL DISENGAGEMENT FROM THE VEHICLE WHILE IN MOTION.

Oct 30, 1979 – INCORRECT HEADLAMPS MAY HAVE BEEN INSTALLED ON THE INVOLVED VEHICLES. THESE HEADLAMPS HAVE BEEN APPROVED FOR EXPORT ONLY AND DO NOT MEET U.S. REQUIREMENTS.

Oct 30, 1979 – SOME OF THE INVOLVED VEHICLES MAY HAVE INCORRECT UNIVERSAL JOINT FASTENERS. THESE FASTENERS MAY LOOSEN AND ALLOW THE PROPELLER SHAFT TO DISCONNECT FROM THE AXLE OR TRANSFER CASE.

Mar 14, 1979 – CERTAIN VEHICLES MAY HAVE AN INCORRECT GASKET BETWEEN THE TRANSMISSION AND THE TRANSFER CASE. AN INCORRECT GASKET MAY INTERFERE WITH THE NORMAL FLOW OF LUBRICANT. THIS CONDITION COULD CAUSE THE TRANSMISSION TO BECOME DAMAGED AND INOPERATIVE.

Dec 09, 1978 – THE THROTTLE LINKAGE CONTROL SPRING MAY NOT CLOSE RAPIDLY WHEN THE ACCELERATOR PEDAL IS RELEASED. IF THE THROTTLE DOES NOT CLOSE AS RAPIDLY AS EXPECTED, THE VEHICLE WILL NOT DECELERATE PROPERLY. THIS FAILS TO COMPLY WITH FEDERAL MOTOR VEHICLE SAFETY STANDARD NO.124, "ACCELERATOR CONTROL SYSTEMS".

Nov 06, 1978 – THE CLAMP BOLTS ON THE ADJUSTER TUBE THAT FASTENS THE CONNECTING ROD TO THE PITMAN ARM END ASSEMBLY MAY BE LOOSE. THESE LOOSE BOLTS COULD CAUSE SHIFTING OF THE STEERING WHEEL POSITION, RELATIVE TO THE STRAIGHT-AHEAD-FRONT WHEEL POSITION, AND LOSS OF STEERING.

Mar 31, 1978 – VEHICLES WERE BUILT WITH WIRE CONNECTORS THAT FAIL TO ALLOW THE CURRENT FLOW NEEDED TO SUPPORT THE ELECTRONIC CONTROL OF THE ENGINE IGNITION.

Mar 09, 1978 – THE COUPLING WHICH ATTACHES THE INTERMEDIATE STEERING SHAFT TO THE STEERING GEAR MAY HAVE OVERSIZED SERRATIONS WHICH COULD PREVENT THE COUPLING FROM BEING PROPERLY TIGHTENED IN THE STEERING GEAR SHAFT WHEN THE STEERING WHEEL IS TURNED. THIS MAY ALSO CAUSE FREE PLAY IN THE STEERING WHEEL.