MACK R Recalls

Dec 29, 1981 – THE RIGHT HAND CLEARANCE LAMP IS OBSCURED, FROM CERTAIN ANGLES OF VISION, BY THE IN-LINE PRECLEANER AIR CLEANER CAP. THE INVOLVED VEHICLES FAIL TO CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT".

Dec 29, 1981 – THE PITMAN ARM RETAINING BOLT MAY NOT HAVE BEEN TIGHTENED TO THE REQUIRED SPECIFICATIONS DUE TO A DESIGN CHANGE. INADEQUATE RETENTION OF THE BOLT TO THE OUTPUT SHAFT COULD ALLOW THE PITMAN ARM TO LOOSEN.

Jul 08, 1981 – THE INVOLVED TRUCKS HAVE PITMAN ARMS WITH TIMING MARKS AND SERRATIONS LOCATED 8 DEGREES OUT OF PROPER ALIGNMENT. WHEN THE CHASSIS IS RAISED TO THE MAXIMUM CONDITION WITH THE WHEELS SUSPENDED OR DROPPED INTO A DEEP HOLE, THE PITMAN ARM AND DRAG LINK CAN GO INTO TOGGLE POSITION.

Jul 08, 1981 – THE RETAINING PIN FOR THE BRAKE CONTROL KNOB HAS BEEN MISALIGNED (OFF THE CENTER LINE OF THE VALVE PLUNGER HOLE). THIS CAUSES THE KNOB TO BE OVERSTRESSED AT THE RETAINING PIN HOLE AREA CAUSING IT TO SEPARATE FROM THE VALVE.

Dec 10, 1980 – THE WELD ON THE UPPER STEERING SHAFT WHERE THE FEMALE SPLINE CONNECTS TO THE TUBE ASSEMBLY MAY HAVE BEEN INCORRECTLY POSITIONED AND ACTUALLY MISSED THE SEAM.

May 06, 1980 – ON CERTAIN VEHICLES, THE KNOB THAT OPERATES THE TRACTOR PARK VALVE MAY BREAK OFF, RENDERING THE VALVE INOPERABLE.

May 06, 1980 – THE STEERING ARM MAY DEVELOP CRACKS DUE TO INSUFFICIENT FATIGUE LIFE IN THE MACHINE RADIUS OF THE TAPER AT THE STEERING KNUCKLE END.

May 06, 1980 – THE PREFABRICATED PINCH BOLT CLAMP AT THE LOWER STEERING SHAFT LOWER YOKE MAY NOT PERFORM ADEQUATELY WHEN TIGHTENED TO SPECIFICATIONS. THE CLAMP MAY THEN DEFORM AND LOSS OF CLAMPING FORCE AND STEERING SHAFT DISENGAGEMENT MAY RESULT.

Jul 12, 1979 – THE SPRING SEAT PLATE, LOCATED BETWEEN THE AXLE HOUSING AND THE SUSPENSION SPRINGS, MAY DEFORM DUE TO SPRING BENDING. AS A RESULT, THE CLAMPING FORCE IN THE ASSEMBLY MAY BE REDUCED. LOSS OF CLAMPING FORCE COULD CAUSE SPRING FAILURE AND THE AXLE WILL DISLOCATE. ALSO, THE TIRE COULD COME INTO CONTACT WITH THE SPRING.

Jul 09, 1979 – THE FLANGE HEAD PINCH BOLTS USED IN THE YOKES OF THE STEERING SHAFT ASSEMBLIES MAY HAVE BEEN OVERSTRESSED DUE TO THE BOLTS NOT BEING TIGHTENED TO SPECIFICATIONS. AS A RESULT, THE PINCH BOLTS COULD BREAK WHILE IN SERVICE.