MACK Recalls

Jan 17, 1986 – THE ACCELERATOR ROD HOLE CLEARANCE IS NOT ADEQUATE AND CAN CAUSE THE ACCELERATOR LINKAGE TO BIND. CONSEQUENCE OF DEFECT: IF BINDING OCCURS WHILE IN A FULL THROTTLE POSITION, ACCELERATOR CONTROL WOULD BE LOST WITHOUT WARNING AND AN ACCIDENT COULD OCCUR.

Jan 17, 1986 – LEFT OR RIGHT CAB STEP MAY CRACK IN ITS WELDED AREA DUE TO FLEXING OF THE STEP DURING ENTERING AND EXITING. CONSEQUENCE OF DEFECT: AS THE CRACKS EXTEND, THE TUBULAR STEP COULD PARTIALLY COLLAPSE AND BREAK WITHOUT WARNING TO THE USER, AND COULD RESULT IN PERSONAL INJURIES.

Jan 14, 1986 – INCORRECT INNER WHEEL BEARINGS WERE INSTALLED IN THE REAR AXLES WHICH WEARS A GROOVE IN THE SPINDLE DUE TO A POOR FIT. CONSEQUENCE OF DEFECT: A DEEP GROOVE COULD CAUSE THE AXLE HOUSING TO BREAK AND RESULT IN A VEHICLE CRASH WITHOUT PRIOR WARNING.

Nov 26, 1985 – THE SPLINED STEERING SHAFT MAY NOT BE SUFFICIENTLY ENGAGED AS DESIGNED DUE TO INACCURATE DRILLING OF THE HOLES IN THE FRAME TO WHICH THE CAB FRONT MOUNT MEMBER IS BOLTED. UNDER CERTAIN CONDITIONS THE STEERING SHAFT MAY DISENGAGE. CONSEQUENCE OF DEFECT: A JARRING IMPACT MIGHT CAUSE DISENGAMENT OF THE SPLINED SHAFT RESULTING IN LOSS OF STEERING CONTROL AND POSSIBLY AN ACCIDENT.

Nov 26, 1985 – THE QUICK RELEASE VALVE SUPPORT BRACKET MOUNTED ON THE AXLE MAY CRACK. THIS CAUSES FATIGUE FAILURE OF THE STEEL AIR LINES LEADING TO THE REAR PARKING BRAKES AND CHASSIS SERVICE BRAKES RESULTING IN SUDDEN LOSS OF AIR PRESSURE. CONSEQUENCE OF DEFECT: THIS SUDDEN LOSS OF AIR TO THE BRAKE CHAMBERS WILL RESULT IN AUTOMATIC ACTUATION OF REAR PARKING BRAKE CAUSING SUDDEN REAR WHEEL LOCKUP WHICH MAY CONTRIBUTE TO AN ACCIDENT.

Sep 17, 1985 – THE DUAL DOUBLE CHECK VALVE MAY NOT RELEASE THE PROPER AIR VOLUME TO THE BRAKE SYSTEM, CAUSING A SLIGHT TIMING DELAY BETWEEN THE TRACTOR AND THE TRAILER BRAKE SYSTEM. CONSEQUENCES OF DEFECT: IF THE BRAKES ARE SUDDENLY APPLIED, THE TRAILER COULD JACKKNIFE WITHOUT WARNING TO THE OPERATOR, WHICH COULD RESULT IN A VEHICLE CRASH.

May 03, 1985 – THE DRAG LINKS MAY HAVE BEEN INSTALLED INCORRECTLY ALLOWING DRAG LINK CLAMP BOLT TO AXLE BEAM INTERFERENCE. CONSEQUENCE OF DEFECT: DURING A TURNING MANEUVER, INCREASED STEERING EFFORT OR COMPLETE LOCKUP OF STEERING COULD OCCUR WITHOUT WARNING. THIS COULD RESULT IN LOSS OF TRUCK CONTROL AND A CRASH.

May 01, 1985 – THE FLIP OUT STEP CLEVIS ON THE BUMPER MAY FAIL AND BREAK UNDER THE WEIGHT OF THE PERSON STANDING ON THE STEP TO SERVICE THE FRONT AREA OF THE VEHICLE. CONSEQUENCE OF DEFECT: THIS SUDDEN BREAK WILL CAUSE THE PERSON STANDING ON THE STEP TO FALL, WITHOUT WARNING, AND COULD RESULT IN INJURIES.

Nov 07, 1984 – DUE TO IMPROPER AND INADEQUATE WELDING PRACTICES, THE FIFTH WHEEL ON THE INVOLVED VEHICLES IS DEFECTIVE. FRAME MOUNTED SUPPORTS MAY HAVE INCOMPLETE OR POOR QUALITY WELDS. THE WELDS COULD SUBSEQUENTLY FAIL ALLOWING SEPARATION OF THE TRACTOR FROM THE TRAILER.

Nov 07, 1984 – THE DOOR LATCHES MAY BE DEFECTIVE BECAUSE A PAWL SPRING WAS NOT MANUFACTURED TO SPECIFICATIONS. THE PAWL SPRING DOES NOT CREATE PROPER TENSION ON THE PAWL, (A PART OF THE DOOR LATCH MECHANISM). THIS CONSTITUTES A NON-COMPLIANCE WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 206, "DOOR LATCHES AND DOOR RETENTION COMPONENTS".