MACK Recalls

Apr 05, 1983 – ON THE INVOLVED VEHICLES THE FLOORBOARD OPENING AND THE STEERING COLUMN SEAL BRACKET DO NOT HAVE SUFFICIENT CLEARANCE TO ALLOW THE SHAFT TO TURN FREELY. THIS CAUSES THE PINCH BOLT TO BIND OR LOCK AGAINST THE SEAL BRACKET.

Dec 21, 1982 – DUE TO THE HIGH STRAIN WITHIN THE FAN BLADES OF THE COOLING FAN, CRACKS MAY DEVELOP IN THE FAN. THESE CRACKS MAY LEAD TO COMPLETE FRACTURE OF THE COOLING FAN, PROPELLING THE FAN AND PIECES OF THE FAN BLADES OUTSIDE THE FAN SHROUD.

May 24, 1982 – THE CIRCUIT WIRING ON THESE VEHICLES IS ARRANGED SO THAT A SHORT CIRCUIT IN THE REAR TAILLIGHTS WILL ALSO RESULT IN LOSS OF POWER TO THE HEADLAMPS. FOR SAFETY REASONS THE LIGHTING SYSTEM WIRING SHOULD BE INDEPENDENT.

Mar 02, 1982 – CERTAIN VEHICLES MAY BE SUBJECT TO STEERING SHAFT SEPARATION DUE TO LOOSE SET SCREWS IN THE DASH SHEET BEARING WHICH MAY ALLOW THE SHAFT TO MOVE.

Dec 29, 1981 – THE RIGHT HAND CLEARANCE LAMP IS OBSCURED, FROM CERTAIN ANGLES OF VISION, BY THE IN-LINE PRECLEANER AIR CLEANER CAP. THE INVOLVED VEHICLES FAIL TO CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT".

Dec 29, 1981 – THE FLOORBOARD OPENING AND THE STEERING COLUMN SEAL BRACKET MAY NOT ALLOW SUFFICIENT CLEARANCE FOR THE SHAFT TO TURN FREELY IN THE CENTER OF THE BRACKET/SEAL. THE PINCH BOLT IN THE COLUMN YOKE MAY BIND OR LOCK THE COLUMN AGAINST THE BRACKET, ALLOWING LITTLE OR NO WHEEL RETURN.

Dec 29, 1981 – THE PITMAN ARM RETAINING BOLT MAY NOT HAVE BEEN TIGHTENED TO THE REQUIRED SPECIFICATIONS DUE TO A DESIGN CHANGE. INADEQUATE RETENTION OF THE BOLT TO THE OUTPUT SHAFT COULD ALLOW THE PITMAN ARM TO LOOSEN.

Dec 29, 1981 – WHEN THE IGNITION KEY IS IN THE "ON" POSITION AND THE HEATER IS OPERATING AT THE "LOW" OR "MEDIUM" SETTING, THE HEATER SWITCH WIRING WILL OVERLOAD IN THE EVENT THE HEATER MOTOR SEIZES.

Jul 14, 1981 – HOLES DRILLED IN THE REAR AXLE YOKES TO BALANCE THEM COULD CAUSE A FAILURE OF THE YOKE.

Jul 08, 1981 – THE INVOLVED TRUCKS DO NOT COMPLY WITH FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 208, "OCCUPANT CRASH PROTECTION", IN THAT THE EXTENDED RIDER"S SEAT WAS NOT EQUIPPED WITH A SEAT BELT AS REQUIRED.