MAZDA MPV Recalls

Oct 31, 2019 – Mazda North American Operations (Mazda) is recalling certain 2003-2008 Mazda6, 2004-2005 MPV, 2004 RX-8, and 2006-2007 Mazdaspeed6 vehicles. These vehicles had their passenger frontal air bag inflators previously replaced under a prior recall using inflators of the same design. The inflators may explode due to propellant degradation occurring after long-term exposure to high absolute humidity, temperature and temperature cycling.

Jun 15, 2018 – Mazda North America Operations (Mazda) is recalling certain 2003-2008 Mazda6, 2006-2007 Mazdaspeed6 and 2004 MPV vehicles nationwide. Mazda is also recalling 2005-2006 MPV vehicles in Alabama, Arizona, Arkansas, California, Delaware, the District of Columbia, Florida, Georgia, Hawaii, Illinois, Indiana, Kansas, Kentucky, Louisiana, Maryland, Mississippi, Missouri, Nebraska, Nevada, New Jersey, New Mexico, North Carolina, Ohio, Oklahoma, Pennsylvania, South Carolina, Tennessee, Texas, Virginia, West Virginia, Puerto Rico, American Samoa, Guam, the Northern Mariana Islands (Saipan), and the U.S. Virgin Islands. On July 9, 2019 this recall was expanded to include certain 2004-2011 RX-8 vehicles that were previously recalled under 16V-354 but have not yet been repaired. These vehicles are equipped with certain air bag inflators assembled as part of the passenger frontal air bag modules, and used as original equipment or replacement equipment. In the event of a crash necessitating deployment of the passenger frontal air bag, these passenger air bag inflators may explode due to propellant degradation occurring after long-term exposure to absolute humidity and temperature cycling.

Jun 15, 2018 – Mazda North America Operations (Mazda) is recalling certain 2005-2006 Mazda MPV vehicles sold, or ever registered, in the states of Alaska, Colorado, Connecticut, Idaho, Iowa, Maine, Massachusetts, Michigan, Minnesota, Montana, New Hampshire, New York, North Dakota, Oregon, Rhode Island, South Dakota, Utah, Vermont, Washington, Wisconsin, and Wyoming. On July 9, 2019 this recall was expanded to include certain 2005-2009 RX-8 vehicles that were previously recalled under 17V-011 but have not yet been repaired. These vehicles are equipped with certain air bag inflators assembled as part of the passenger frontal air bag modules used as original equipment or replacement equipment. In the event of a crash necessitating deployment of the passenger frontal air bag, these inflators may explode due to propellant degradation occurring after long-term exposure to absolute humidity and temperature cycling.

Oct 19, 2015 – Mazda North American Operations (Mazda) is recalling certain model year 1989-1998 MPV, 1990-1995 323, 1990-1998 Protege, 1992-1993 MX-3, 1993-1995 929, 1993-1997 MX-6, and 1993-1998 626 vehicles. In the affected vehicles, grease applied to the contact points inside the ignition switch may become conductive and overheat.

Jun 10, 2004 – THE TIRE INFLATION PRESSURE INDICATED ON THE VEHICLE CERTIFICATION LABEL IS NOT CORRECT. THE LABELS SHOW THE MAXIMUM TIRE PRESSURE AS 240 KPA/32 PSI WHEN IT SHOULD BE SHOWN AS 240 KPA/35 PSI. AS A RESULT OF THIS ERROR, THE LOAD RATIOS FOR THE 205/65R15 94H AND THE 215/60R16 95H TIRES EXCEED THE LEVELS PERMITTED BY FMVSS 120.

May 19, 2004 – ON CERTAIN MINIVANS EQUIPPED WITH CRUISE CONTROL, THE CRUISE CONTROL ACTUATOR CABLE MAY BE BROKEN DUE TO INSUFFICIENT STRENGTH (GROUP 1). ALSO INCLUDED ARE CERTAIN 2000-2001 MINIVANS EQUIPPED WITH CRUISE CONTROL BUILT BETWEEN MARCH 31, 1999 AND MARCH 31, 2001, THAT HAVE HAD THE CRUISE CONTROL REPAIRED AND POSSIBLY HAD A DEFECTIVE CABLE INSTALLED DURING THAT REPAIR (GROUP 2).

Mar 09, 2004 – CERTAIN MINIVANS FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 208, "OCCUPANT CRASH PROTECTION." SOME OF THESE VEHICLES WERE PRODUCED WITH AIR BAG WARNING LABELS INTENDED FOR THE CANADIAN MARKET. THUS, THE LABELS CONTAIN WARNINGS IN BOTH ENGLISH AND FRENCH. AS A RESULT, THE AREA OF THE ENGLISH WARNING IS ONLY 16 SQUARE CENTIMETERS, AS OPPOSED TO THE 30 SQUARE CENTIMETERS REQUIRED BY THE STANDARD.

Feb 17, 2004 – AS A RESULT OF AN NCAP TEST, CERTAIN MINIVANS FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 208, "OCCUPANT CRASH PROTECTION." THE FRONT PASSENGER SEAT AIR BAG WAS NOT CORRECTLY WIRING.

Jun 05, 2003 – ON CERTAIN MINI VANS AND PASSENGER VEHICLES, THE SOCKET HOLDER IN THE FOG LIGHTS IS INSTALLED IN THE LAMP CASING USING PRESSURE. DURING OPERATION OF THE FOG LIGHT, THE HEAT FROM THE BULB CAN EXPAND THE SOCKET HOLDER. THE EXPANSION CAN FORCE THE SOCKET HOLDER REARWARD. AFTER REPEATEDLY BEING SUBJECT TO THIS EXPANSION, IF THE FOG LIGHT IS ALSO SUBJECTED TO VIBRATION DURING VEHICLE OPERATION, THE SOCKET HOLDER WITH THE BULB HOLDER AND THE WIRING HARNESS MAY SEPARATE FROM THE FOG LIGHT CASING.

Feb 13, 2003 – ON CERTAIN MINI VANS EQUIPPED WITH FRONT FOG LIGHTS,THE FOG LIGHT BULB SOCKET MAY HAVE BEEN INSTALLED IMPROPERLY.