NAVISTAR 9200 Recalls

Jan 24, 2000 – VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS. THE ANTILOCK TRACTION RELAY VALVES WERE INCORRECTLY ASSEMBLED BY THE SUPPLIER. AN EXTRA CHECK VALVE WAS INSTALLED WHICH WILL NOT ALLOW THE TRACTION CONTROL SYSTEM TO FUNCTION PROPERLY.

Dec 14, 1999 – VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS. THE CHECK VALVES IN THE AIR BRAKE SYSTEM ON THESE VEHICLES DO NOT MEET THE REQUIREMENTS OF FMVSS NO. 121, "AIR BRAKE SYSTEMS."

Aug 03, 1999 – VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS EQUIPPED WITH STEERING COLUMNS SUPPLIED BY DOUGLAS AUTOTEC. THE STEERING COLUMNS ON THESE VEHICLES MAY HAVE A DEFECTIVE OR DISLOCATED WELD.

Jul 15, 1999 – VEHICLE DESCRIPTION: TRUCKS ASSEMBLED WITH SKF LEVEL 2 TRUCK HUB UNITS (THU) RECEIVED FROM MERITOR. THESE HUBS CAN FATIGUE CRACK.

May 04, 1999 – VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS EQUIPPED WITH DANA/SPRAGUE WINDSHIELD WIPER ASSEMBLIES. THE KNURLED PIVOT SHAFT (WHICH OPERATES THE WINDSHIELD WIPER ARM) IS WELDED TO A LEVER, WHICH CONNECTS TO LINKAGE FROM THE WIPER MOTOR. THE WELD AT THE PIVOT SHAFT TO LEVER CAN FAIL.

Mar 16, 1999 – VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS, TRANSIT AND SCHOOL BUSES, EQUIPPED WITH MERITOR AIR BRAKE AUTOMATIC SLACK ADJUSTERS. SOME OF THE AUTOMATIC SLACK ADJUSTERS HAD INSUFFICIENT TORQUE APPLIED TO THE GUIDE PAWL CAP SCREW.

Mar 15, 1999 – VEHICLE DESCRIPTION: CLASS 8 HEAVY DUTY TRUCK CHASSIS EQUIPPED WITH 16,000 LB., 18,000 LB., OR 20,000 LB. HEAVY DUTY STEERING AXLES. THE INNER WHEEL BEARING CONE FOR THE STEERING AXLE WHEEL HUB ASSEMBLY DOES NOT PROPERLY FIT ONTO THE NAVISTAR STEERING AXLE SPINDLE ASSEMBLY. IMPROPER FIT OF THE BEARING TO THE SPINDLE INCREASES THE STRESS LEVELS TO THE STEERING AXLE SPINDLE WHICH COULD CAUSE SPINDLE FAILURE.

Nov 09, 1998 – VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS EQUIPPED WITH SPICER SPL170 55MM CENTER BERING PACKAGE. THE END YOKE RETAINING NUT CAN LOOSEN.

May 27, 1998 – VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS EQUIPPED WITH PROSLEEPER BUNKS. A MICRO RELAY LOCATED BEHIND THE HVAC CONTROL PANEL IN THE BUNK CAN CORRODE FROM MOISTURE.

Mar 25, 1998 – VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS EQUIPPED WITH CATERPILLAR C-10 OR C-12 ENGINES. A BRACKET OR P-CLAMP AT THE REAR OF THE ENGINE THAT SUPPORTS THE COMPRESSOR DISCHARGE LINE WAS OMITTED.