NISSAN FRONTIER Recalls

Nov 12, 2002 – ON CERTAIN PICKUP TRUCKS AND SPORT UTILITY VEHICLES EQUIPPED WITH A SUPERCHARGER, UNDER CERTAIN CONDITIONS, SUCH AS FULL THROTTLE IN LOW GEAR WHEN THE ENGINE IS NOT FULLY WARMED UP AND AT COLD AMBIENT TEMPERATURE, THE AMOUNT OF INTAKE AIR FLOW THROUGH THE AIR FLOW METER MAY EXCEED THE MAXIMUM PRESET DIAGNOSIS LIMIT VALUE.

Nov 12, 2002 – ON CERTAIN PICKUP TRUCKS AND SPORT UTILITY VEHICLES, WATER MAY ENTER THE REAR AXLE HOUSING DUE TO INADEQUATE SEALING OF THE ANTI-LOCK BRAKING SYSTEM (ABS) SENSOR.

Nov 12, 2002 – ON CERTAIN PICKUP TRUCKS AND SPORT UTILITY VEHICLES, THE FUEL TANK INLET SHUTTER VALVE DOES NOT MEET THE SEALING PERFORMANCE SPECIFICATION.

Oct 02, 2000 – VEHICLE DESCRIPTION: PICKUP TRUCKS AND SPORT UTILITY VEHICLES EQUIPPED WITH AUTOMATIC TRANSMISSIONS FAIL TO COMPLY WITH THE REQUIREMENTS OF FMVSS NO. 102, "TRANSMISSION SHIFT LEVER SEQUENCE, STARTER INTERLOCK, AND TRANSMISSION BRAKING EFFECT. " THESE VEHICLES COULD HAVE A SHIFT CABLE LOCK PLATE THAT IS TOO BRITTLE AND CAN BREAK. THE GEAR SHIFT LEVER AND THE "PRNDL" INDICATOR MAY MOVE, BUT THE TRANSMISSION WILL NOT SHIFT OUT OF THE PARK POSITION. OVER A PERIOD OF TIME, THE TRANSMISSION COULD SHIFT OUT OF THE PARK POSITION, BUT THE GEAR INDICATED ON THE DISPLAY MAY DIFFER FROM THE GEAR ENGAGED IN THE TRANSMISSION.

Dec 20, 1999 – VEHICLE DESCRIPTION: MINIVANS AND LIGHT DUTY TRUCKS. THE TAIL LIGHT SOCKET MAY HAVE BEEN IMPROPERLY MOLDED, RESULTING IN THE LOCKING TAB HAVING INSUFFICIENT FORCE TO RETAIN THE BULB.

Mar 25, 1998 – VEHICLE DESCRIPTION: LIGHT DUTY PASSENGER TRUCKS EQUIPPED WITH AUTOMATIC TRANSMISSIONS. A SECURING PIN INSIDE THE AUTOMATIC TRANSMISSION CONTROL DEVICE ASSEMBLY CAN COME LOOSE ALLOWING THE SHIFT LEVER TO BE INADVERTENTLY MOVED OUT OF THE PARK POSITION WITH THE KEY IN THE IGNITION.

Mar 25, 1998 – VEHICLE DESCRIPTION: LIGHT DUTY PASSENGER TRUCKS EQUIPPED WITH BUCKET SEATS. IN CERTAIN FRONTAL CRASHES, THE FRONT SEAT BELT CAN SLIP BETWEEN THE SEAT BOTTOM FINISHER AND THE SEAT BACK PLASTIC RECLINER HANDLE WHERE IT CAN BE CUT BY THE SHARP EDGE OF THE METAL PORTION OF THE RECLINER LEVER.