PETERBILT 520 Recalls

Jan 19, 2026 – PACCAR Incorporated (PACCAR) is recalling certain 2026 Kenworth L770 and 2024-2026 Peterbilt 520 vehicles. The right-hand stand-up (RHSU) configuration on the steering cross-shaft may become stressed and fail.

Jun 26, 2025 – PACCAR Incorporated (PACCAR) is recalling certain 2024-2026 Kenworth T480, T680, T880, W990, Peterbilt 520, 536, 537, 548, 567, 579, 589, 2025 Kenworth T180, Peterbilt 535, 2025-2026 Kenworth T280, T380 and L770 vehicles. The tail brake light, upper and lower beam headlights, reverse light, and turn signal may not illuminate as intended. In addition, the lift axles, if lowered, may revert to a raised position, or oscillate up and down when the signal warning lights are activated. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard (FMVSS) number 108, "Lamps, Reflective Devices and Associated Equipment."

Mar 24, 2025 – PACCAR Incorporated (PACCAR) is recalling certain 2022-2025 Peterbilt 520, 579, and 2021-2025 Kenworth T680 trucks. The high voltage (HV) contactors may open, causing a sudden loss of high voltage and a loss of drive power.

Dec 09, 2024 – PACCAR Incorporated (PACCAR) is recalling certain 2021-2025 Peterbilt and Kenworth vehicles, equipped with Bendix EC80 Advanced Electronic Control Units (ECU). Please see the recall report for a complete list of models. Electrical noise and low signal to the power line carrier may cause the ECU to incorrectly process commands or stop functioning.

Dec 03, 2024 – PACCAR Incorporated (PACCAR) is recalling certain 2024 Peterbilt 367, 389, 548, Kenworth T480, T800, 2024-2025 Peterbilt 520, 567 and Kenworth T880 vehicles with PACCAR 20k steer axles. The steering arm and/or tie rod bracket fasteners may fail, resulting in a loss of steering control.

Jun 12, 2024 – PACCAR Incorporated (PACCAR) is recalling certain 2025 Kenworth K270, K370, L770, T280, T380, T480, T680, T880, W900, W990, 2025 Peterbilt 220, 520, 536, 537, 548, 567, 579, and 589 trucks. The tie rod or drag link assembly may contain an improperly heat-treated ball stud, causing the ball stud to break.

Jan 25, 2024 – PACCAR Incorporated (PACCAR) is recalling certain 2024 Peterbilt 367, 389, 520, 567, and Kenworth T800, T880, W900, and W990 trucks. The bearing journals may not be fully seated in the steering knuckle assemblies, preventing the proper installation of the wheel end hub assemblies.

Jan 25, 2024 – PACCAR Incorporated (PACCAR) is recalling certain 2024-2025 Kenworth T280, T380, T480, T680, T880, L770, W990, and 2024-2025 Peterbilt 389, 520, 535, 536, 537, 548, 567, 579, 589 trucks. The steering gear assemblies may have been assembled incorrectly with fewer recirculating balls than are required, which may result in a loss of steering control.

Nov 07, 2023 – PACCAR Incorporated (PACCAR) is recalling certain 2024 Peterbilt 520 vehicles. The rear lifting bracket that attaches to the engine cylinder head may be insufficiently secured, which can allow it to detach.

Dec 16, 2022 – PACCAR Incorporated (PACCAR) is recalling certain 2015-2023 Peterbilt 320 and 520 refuse trucks equipped with Haulmaax/EX suspensions. The suspension tracking rod brackets may fail and detach from the forward drive axle, causing the axle to become unstable.