PONTIAC Recalls

Jun 23, 2004 – CERTAIN PASSENGER VEHICLES HAVE A CONDITION WHERE THE FRONT FRAME REAR BODY MOUNT BRACKET MAY FRACTURE.

Jun 23, 2004 – CERTAIN PASSENGER VEHICLES FAIL TO CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 210, 'SEAT BELT ASSEMBLY ANCHORAGES.' THE PASSENGER-SIDE REAR SAFETY BELT MAY HAVE BEEN INSTALLED WITH AN INCORRECT NUT AND BOLT.

Apr 08, 2004 – CERTAIN MINIVANS FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 213, "CHILD RESTRAINT SYSTEMS." THESE VEHICLES DO NOT HAVE TEXT AND FORMATTING ON THE WARNING LABEL ATTACHED TO THE AVAILABLE SECOND-ROW INTEGRAL CHILD RESTRAINT AS SPECIFIED BY AMENDMENTS TO THE STANDARD.

Feb 24, 2004 – ON CERTAIN PASSENGER VEHICLES EQUIPPED WITH 3800 V6 (L36) ENGINES AND CERTAIN DELPHI FUEL PRESSURE REGULATORS, THE REGULATORS HAVE A MUCH HIGHER THAN USUAL RATE OF FUEL LEAKS. A LEAK CAN ALLOW FUEL TO ENTER THE INTAKE MANIFOLD THROUGH A VACUUM LINE. IF THE ENGINE DOES NOT START WHEN CRANKED, THE FUEL FROM THE LEAKING REGULATOR AND A MISTIMED SPARK CAN CAUSE A BACKFIRE.

Jan 27, 2004 – ON CERTAIN PASSENGER VEHICLES. IF THE ENGINE FAILS TO START AND THE DRIVER HOLDS THE KEY IN THE "START" POSITION FOR AN EXTENDED PERIOD, HIGH CURRENT FLOWS THROUGH THE IGNITION SWITCH, AND SOMETIMES PRODUCES ENOUGH HEAT TO MELT INTERNAL SWITCH PARTS.

Dec 11, 2003 – CERTAIN PASSENGER VEHICLES HAVE LOWER PINION BEARINGS IN THE POWER RACK AND PINION ASSEMBLY IN WHICH THE RETAINER TABS WERE NOT CRIMPED PROPERLY. THESE RETAINERS COULD FAIL AND PERMIT THE BALL BEARINGS TO ESCAPE.

Nov 10, 2003 – ON CERTAIN PASSENGER VEHICLES, A WELD BETWEEN THE FUEL TANK INLET CHECK VALVE AND THE FUEL TANK CAN FAIL.

Sep 12, 2003 – CERTAIN PASSENGER VEHICLES FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 135, "PASSENGER CAR BRAKING SYSTEMS." ON SOME OF THESE VEHICLES, THE RIGHT REAR BRAKE HOSE FITTING MAY NOT BE TIGHTENED PROPERLY, AND A BRAKE FLUID LEAK COULD OCCUR.

Aug 28, 2003 – CERTAIN PASSENGER VEHICLES HAVE HAZARD WARNING SWITCHES THAT MAY EXPERIENCE SOLDER JOINT CRACKING CAUSED BY RAPID TEMPERATURE TRANSITIONS AND THE SOLDERING PROCESS. IF SOLDER JOINT CRACKING OCCURS AND RESULTS IN AN OPEN CIRCUIT, THE TURN SIGNALS/HAZARD LAMPS BECOME INTERMITTENT OR INOPERATIVE.

Jul 15, 2003 – CERTAIN MINIVANS, PASSENGER AND SPORT UTILITY VEHICLES FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 225, "CHILD RESTRAINT ANCHORAGE SYSTEM." THE OWNER'S MANUAL DOES NOT EXPLAIN THE MEANING OF THE LOCATION SYMBOLS FOR THE CHILD RESTRAINT LOWER UNIVERSAL ANCHORAGE SYSTEM.