SPARTAN K2 Recalls

Jun 10, 2013 – Spartan Motors, Inc. (Spartan) is recalling certain model year 2012-2013 K2, K3, and MM motor homes manufactured March 2, 2012, through July 30, 2012 and equipped with a 1660 independent front suspension supplied by Reyco Granning. The motor homes may have incorrect wheel bearings installed in the front suspension.

May 08, 2013 – Spartan Motors Chassis (Spartan) is recalling certain model year 2006-2011 K2, and K3 and 2006-2010 MM motorhome chassis manufactured July 20, 2005, through December 17, 2010. The steering gear mounting brackets may crack and detach resulting in a loss of steering.

Dec 06, 2012 – Spartan Motors Chassis is recalling certain model year 2013 K2, K3, and MM motorhome chassis, manufactured July 23, 2012, through November 7, 2012 and equipped with an independent front suspension that has the ABS modulator valve mounted in a forward position. The front brake hoses or the ABS sensor cable may be damaged as a result of contact with the swaybar.

Sep 04, 2012 – Spartan is recalling certain model year 2008-2013 K2 and MM motor home chassis, equipped with a Hendrickson independent front suspension. The front brake chambers may contact the upper control arm of the independent front suspension. Continued contact may result in damage sufficient enough to inhibit the full release of the brakes. If the brakes do not fully release, as they drag, heat could be generated causing the brakes to engage even further.

Mar 23, 2012 – SPARTAN IS RECALLING CERTAIN MODEL YEAR 2012 K2 AND MG CHASSIS MANUFACTURED FROM DECEMBER 15, 2011, THROUGH JANUARY 31, 2012, AND EQUIPPED WITH 3030 BRAKE CHAMBERS. THESE VEHICLES FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NUMBER 121, ?AIR BRAKE SYSTEMS? BECAUSE THEY DO NOT MEET THE PARK BRAKE AND DRAW BAR REQUIREMENTS.

Dec 06, 2011 – SPARTAN IS RECALLING CERTAIN MODEL YEAR 2011-2012 K2 RECREATIONAL VEHICLES MANUFACTURED FROM SEPTEMBER 30, 2010, THROUGH NOVEMBER 22, 2011, RATED AT 52,000 LBS AND EQUIPPED WITH 3030 BRAKE CHAMBERS. THESE VEHICLES FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NUMBER 121, ?AIR BRAKE SYSTEMS? BECAUSE THEY DO NOT MEET THE PARK BRAKE AND DRAW BAR REQUIREMENTS.

Oct 17, 2011 – SPARTAN IS RECALLING CERTAIN MODEL YEAR 2010 AND 2011 INCOMPLETE RECREATIONAL VEHICLE CHASSIS MANUFACTURED FROM JANUARY 4, 2010, THROUGH JANUARY 26, 2011, EQUIPPED WITH AN ELECTRONIC CONTROL MODULE, PART NUMBER 2791-NN2E-001 OR 2791-NN2E-002. WHEN THE BRAKE IS APPLIED, THE CRUISE CONTROL MAY NOT CANCEL. ADDITIONALLY, THESE VEHICLES MAY EXHIBIT AN INADVERTENT, MODERATE INCREASE IN VEHICLE SPEED UNTIL THE VEHICLES REACHES ITS GOVERNED SPEED AFTER THE VEHICLE'S CRUISE CONTROL IS SET.

Aug 17, 2011 – SPARTAN IS RECALLING CERTAIN MODEL YEAR 2010, 2011, AND 2012 RECREATIONAL VEHICLES, MODELS MM, K2, K3, BUS, FURION, GLADIATOR, AND METRO STAR, MANUFACTURED FROM SEPTEMBER 29, 2010, THROUGH JUNE 20, 2011, EQUIPPED WITH A CUMMINS ISB, ISC, ISL, OR ISX DIESEL ENGINE. THE V-BAND CLAMP ASSEMBLY, PART NUMBERS Q187684, Q187685, AND Q187686, USED TO CONNECT THE INLET AND OUTLET CONE SECTIONS TO THE DIESEL OXIDATION CATALYST (DOC)/DIESEL PARTICULATE FILTER (DPF) INCLUDE A T-BOLT WHICH CAN FRACTURE AND FAIL WHEN SUBJECTED TO STRESS OR LOAD. A FRACTURE OR FAILURE OF THE T-BOLT MAY CAUSE THE CLAMP TO LOOSEN AND THE INLET OR OUTLET SECTIONS ATTACHED TO THE DOC/DPF HOUSING TO DISCONNECT.

Aug 11, 2011 – Spartan Motors Chassis, Inc. (Spartan Chassis) is recalling certain 2011 SU and 2011 through 2012 model year MM, K2, and K3 recreational vehicle chassis manufactured from January 28, 2011, through June 28, 2011, equipped with air gauges supplied by Ametek. An incorrect value may have been used in the formula for calculating the sweep angle of the dial. This may have resulted in the accuracy of the gauge varying as much as eleven percent from the cutout pressure as opposed to the maximum allowable of +/- seven percent. Consequently, these chassis fail to conform to the requirements of Federal Motor Vehicle Safety Standard No. 121, "Air Brake Systems."

Dec 16, 2009 – SPARTAN IS RECALLING CERTAIN MODEL YEAR 2008 THROUGH 2010 MM, K2, AND K3 MOTORHOME CHASSIS MANUFACTURED FROM APRIL 27, 2007 AND AUGUST 11, 2009, EQUIPPED WITH PNEUMATIC AND HYDRAULIC ADJUSTABLE BRAKE PEDAL ASSEMBLIES P/NOS. 6562618, 6565118, 77025-001, 77025-002, 77025-501, 77050-004, SUPPLIED BY KONGSBERG AUTOMOTIVE. SOME ASSEMBLIES COULD CONTAIN A DRIVE PIN THAT IS BELOW SPECIFICATION AND MAY BECOME DISENGAGED FROM THE BRAKE ARM CAUSING SEPARATION OR LOOSENING OF THE PEDAL FROM THE REMAINDER OF THE ASSEMBLY.