STERLING Recalls

Mar 25, 2008 – DAIMLER TRUCKS IS RECALLING 28,764 MY 2001 THROUGH 2008 FCCC B2 AND FS65 SCHOOL BUS CHASSIS, FCCC FB65 CONVENTIONAL BUSES, AND STERLING ACTERRA, FREIGHTLINER FLN, AND BUSINESS CLASS M2 HEAVY TRUCKS, BUILT FROM JANUARY 26, 2000, THROUGH MARCH 24, 2008, MANUFACTURED WITH ARVINMERITOR OR AXLE ALLIANCE COMPANY 6,000 THROUGH 8,000 POUND FRONT AXLES UTILIZING A FOUR PIECE SPINDLE-NUT SET. THESE AXLE ASSEMBLIES MAY HAVE BEEN PRODUCED WITH A THIN SPINDLE NUT WHICH MAY LEAD TO INCORRECT END PLAY, CONE SPIN, EXCESSIVE HEAT, DEGRADATION OF LUBRICATION, WEAR OF THE SPINDLE NUT AND BEARING JOURNAL, OIL CONTAMINATION WITH METAL SHAVINGS, AND PREMATURE BEARING FAILURE.

Mar 11, 2008 – DAIMLER TRUCKS IS RECALLING 62,000 MY 2005-2007 FREIGHTLINER BUSINESS CLASS, CENTURY CLASS, COLUMBIA, CORONADO, FLD, CLASSIC, STERLING A-LINE, L-LINE, AND WESTERN STAR 4900 TRUCKS. A FRACTURED FUEL LINE COULD LEAK DIESEL FUEL.

Feb 25, 2008 – ZIMMERMAN IS RECALLING 1 MY 2006 STERLING LT 8500 EQUIPPED WITH A WATSON & CHALIN AUXILIARY AXLE. THE LOWER CAST ARMS COULD FRACTURE WHICH COULD AFFECT THE SUSPENSION'S ABILITY TO LIFT THE AXLE WHEN IT IS NOT NEEDED.

Dec 21, 2007 – ON CERTAIN TRUCKS EQUIPPED WITH TRW STEERING GEARS, MODELS TAS85 AND RCS85, THESE STEERING GEARS CONTAIN POTENTIALLY DEFECTIVE SECTOR SHAFTS WITH AN INCORRECT GEAR TOOTH WHICH MAY INTERFERE WITH THE RACK-PISTON TEETH, RESULTING IN A STICK OR BIND CONDITION.

Nov 13, 2007 – ON CERTAIN TRUCK-TRACTORS EQUIPPED WITH HOLLAND SIMPLEX SE OR SE II FIFTH WHEELS, THE LATCH LEVER PIVOT BOLT ASSEMBLY MAY HAVE BEEN OVER-TIGHTENED WHICH COULD DISTORT THE PIVOT BOLT SPACER SLEEVE. CORROSION OR CONTAMINATES IN THE PIVOT MAY CAUSE IT TO BIND AND PREVENT THE FIFTH WHEEL JAW FROM LATCHING SECURELY AROUND THE TRAILER KING PIN.

Aug 02, 2007 – ON CERTAIN TRUCKS, A MANUFACTURING ERROR IN THE FUEL-WATER SEPARATOR PREHEATER THERMOSWITCH MAY PREVENT THE FUEL PREHEATER FROM TURNING OFF IF THE IGNITION IS LEFT ON. IF THE IGNITION SWITCH IS LEFT ON WHEN FUEL IS ADDED TO THE FUEL- WATER SEPARATOR AT THE FACTORY OR DURING A FILTER ELEMENT CHANGE, A SMALL FLAME MAY OCCUR INSIDE THE FILTER COVER.

Aug 01, 2007 – ON CERTAIN TRUCKS BUILT WITH AXILOK REAR WHEEL SPINDLE NUTS, THE NUTS MAY HAVE BEEN IMPROPERLY INSTALLED, WITH ONE OR BOTH LOCKING CLIP TABS NOT PROPERLY ENGAGED OR DAMAGED.

Jul 24, 2007 – ON CERTAIN TRUCKS EQUIPPED WITH TUFTRAC REAR SUSPENSIONS, THE CENTER CASTING BRACKETS MAY BE OUT OF SPECIFICATION. AN OUT OF SQUARE CASTING MAY HAVE UNACCEPTABLE STRESS IN THE BRACKET WHEN IT IS INSTALLED AND MAY CAUSE IT TO CRACK IN SERVICE.

Jul 18, 2007 – FREIGHTLINER IS RECALLING CERTAIN SCHOOL BUS CHASSIS, HEAVY TRUCKS, VAN CHASSIS, RV MOTORHOME CHASSIS MANUFACTURED FROM JANUARY 5 TO MAY 17, 2007, EQUIPPED WITH AXLE ALLIANCE COMPANY (AAC) FRONT AXLES. DURING THE FRONT AXLE ASSEMBLY, THE FASTENERS THAT ATTACH THE STEERING ARM OR TIE ROD ARMS TO THE SPINDLE MAY BE OVER OR UNDER TIGHTENED.

Jul 16, 2007 – CERTAIN FREIGHTLINER SCHOOL BUS CHASSIS, HEAVY TRUCKS, AND THOMAS BUILT SCHOOL BUSES MANUFACTURED BETWEEN JULY 2002 AND JULY 3, 2007, EQUIPPED WITH BENDIX SR-7 SPRING BRAKE CONTROL VALVES. THE PARKER SCV BRASS 90 DEGREE SINGLE CHECK VALVES (SCV) WHICH ATTACH TO THE SUPPLY PORT OF A BENDIX SR-7 SPRING BRAKE MODULATING VALVE CAN BREAK APART. PIECES OF THE PARKER SCV CAN BECOME LODGED INSIDE THE SR-7 SPRING BRAKE MODULATING VALVE, POTENTIALLY CAUSING EITHER LEAKAGE OUT OF THE SR-7 VALVE OR PREVENTING AIR FROM PROPERLY EXHAUSTING FROM THE SR-7 VALVE. ALSO, DUE TO A MANUFACTURING DEFECT IN THE INTERNAL RUBBER CHECK VALVE INSIDE THE SR-7 SPRING BRAKE MODULATING VALVES, THE VALVES CAN BECOME DEFORMED AND NOT SEAT PROPERLY.