VOLVO WX Recalls

Nov 20, 2000 – VEHICLE DESCRIPTION: HEAVY DUTY CLASS 8 VEHICLES EQUIPPED WITH ARVINMERITOR AXLE ASSEMBLIES WHICH MAY HAVE BEEN MANUFACTURED WITH TRW MODEL 20EDL BALL SOCKETS. THE TIE ROD BALL-SOCKET BEARINGS HAVE A BELOW SPECIFICATION CASE DEPTH AND/OR HARDNESS WHICH CAN LEAD TO PREMATURE WEAR OUT OF THE SOCKET IN SOME APPLICATIONS.

Oct 24, 2000 – VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS EQUIPPED WITH TRW 20-EDL BALL-SOCKET ASSEMBLIES. CERTAIN OF THE BALL-SOCKET BEARINGS HAVE A BELOW SPECIFICATION CASE DEPTH AND/OR HARDNESS WHICH CAN LEAD TO PREMATURE WEAR OUT OF THE SOCKET. THESE BEARINGS WERE PRODUCED BETWEEN JULY 5 AND OCTOBER 3, 1999.

Aug 22, 2000 – VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS BUILT WITH BENDIX AIR ABS WITH AN EC-17 1030R ELECTRONIC CONTROL UNIT (ECU), THERE HAVE BEEN REPORTS OF UNWANTED ABS ACTIVATION AT LOW SPEEDS CAUSED BY 1) CHAFED ABS WHEEL SPEED SENSOR WIRES ON ROTATING PARTS OR 2) A DAMAGED COMPONENT AT THE WHEEL END THAT GENERATES A CERTAIN TYPE OF ERRATIC SENSOR SIGNAL.

Feb 24, 2000 – VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS EQUIPPED WITH HALDEX MANIFOLD DASH VALVES (MDV) USED IN TRACTOR AND TRAILER PARKING BRAKES. THESE VALVES DO NOT MEET THE REQUIREMENTS OF FMVSS NO. 121, "AIR BRAKE SYSTEMS." A LOSS OF THE ISOLATION OF THE TWO BRAKE SYSTEM CIRCUITS CAN RESULT IN THE LOSS OF SERVICE BRAKES WHEN THERE IS ANOTHER FAILURE OF ONE OF THE TWO BRAKE CIRCUITS.

Jan 18, 2000 – VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS EQUIPPED WITH A STEEL FUEL TANK. THE CLOSURE ONLY FUEL TANK CAP, INSTALLED ON THE STEEL FUEL TANK, FAILED WHEN THE TANK WAS DROPPED FROM A 10' HEIGHT AS REQUIRED BY FMVSS NO. 393, "LIQUID FUEL TANKS."

Aug 30, 1999 – VEHICLE DESCRIPTION: DUAL STEER CLASS 8 HEAVY DUTY TRUCKS. THE FRONT STEER AXLE BRAKES DO NOT COMPLY WITH THE REQUIREMENTS OF FMVSS NO. 121, "AIR BRAKE SYSTEMS."

May 10, 1999 – VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS EQUIPPED WITH MERITOR AIR BRAKE AUTOMATIC SLACK ADJUSTERS. SOME OF THE AUTOMATIC SLACK ADJUSTERS HAD INSUFFICIENT TORQUE APPLIED TO THE GUIDE PAWL CAP SCREW.

Mar 16, 1999 – VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS. THE STEERING SLIP SHAFT CONNECTING THE STEERING COLUMN TO THE STEERING GEAR INPUT SHAFT MIGHT BE TOO LONG.

Oct 14, 1998 – VEHICLE DESCRIPTION: CLASS 8 HEAVY DUTY TRUCKS. THE AIR SUSPENSION CONTROL VALVE SUPPLY LINE WAS NOT PLUMBED THROUGH AN AIR PRESSURE PROTECTION VALVE. IN THE EVENT OF A FAILURE, THERE WOULD BE LOSS OF AIR PRESSURE IN THE 'B' SYSTEM AIR RESERVOIR THAT SUPPLIES AIR PRESSURE FOR THE FRONT STEER AXLE BRAKES.

May 19, 1998 – VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS EQUIPPED WITH AFTERMARKET ALUMINUM DUAL WHEELS, 22.5X8.25, ONE-PIECE, TUBELESS, SUPPLIED BY ACCURIDE/AKW. CERTAIN DESIGN REVISIONS COMBINED WITH PROCESS CONDITIONS CAUSED FATIGUE CRACKS IN THESE WHEELS.