VOLVO WXR Recalls

Nov 25, 2002 – ON CERTAIN HEAVY DUTY CLASS 8 TRUCKS WITH VOLVO B-RIDE REAR SUSPENSION, THE FORWARD AND/OR REAR DRIVE AXLE UPPER AXLE SEAT COULD BREAK ALLOWING THE AFFECTED AXLE TO SHIFT OUT OF ALIGNMENT.

May 08, 2001 – VEHICLE DESCRIPTION: HEAVY DUTY, CLASS 8, TRUCKS EQUIPPED WITH TIE ROD ASSEMBLIES CONTAINING 24-DL MODEL BALL SOCKETS AND MANUFACTURED BY TRW. CERTAIN OF THE TIE ROD BALL-SOCKET BEARINGS HAVE A BELOW-SPECIFICATION CASE DEPTH AND/OR HARDNESS, WHICH CAN LEAD TO PREMATURE WEAR OF THE SOCKET.

Aug 22, 2000 – VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS BUILT WITH BENDIX AIR ABS WITH AN EC-17 1030R ELECTRONIC CONTROL UNIT (ECU), THERE HAVE BEEN REPORTS OF UNWANTED ABS ACTIVATION AT LOW SPEEDS CAUSED BY 1) CHAFED ABS WHEEL SPEED SENSOR WIRES ON ROTATING PARTS OR 2) A DAMAGED COMPONENT AT THE WHEEL END THAT GENERATES A CERTAIN TYPE OF ERRATIC SENSOR SIGNAL.

May 19, 1998 – VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS EQUIPPED WITH AFTERMARKET ALUMINUM DUAL WHEELS, 22.5X8.25, ONE-PIECE, TUBELESS, SUPPLIED BY ACCURIDE/AKW. CERTAIN DESIGN REVISIONS COMBINED WITH PROCESS CONDITIONS CAUSED FATIGUE CRACKS IN THESE WHEELS.

Nov 17, 1997 – VEHICLE DESCRIPTION: CLASS 8 HEAVY DUTY TRUCKS. THE STEER AXLE WHEEL BEARING JAM NUT LOCK WASHER MAY NOT HAVE BEEN BENT OVER THE JAM NUT AFTER THE WHEEL BEARINGS WERE ADJUSTED.

Dec 08, 1995 – THE TILT CAB, WHEN RAISED TO ITS FULLEST UP POSITION, CAN CAUSE THE STEERING SHAFT TO BIND AGAINST THE STEERING GEAR.