VOLVO Recalls

Dec 13, 2007 – CERTAIN SPORT UTILITY VEHICLES FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 120, "TIRE SELECTION AND RIMS FOR MOTOR VEHICLES OTHER THAN PASSENGER CARS." THE WHEEL INFORMATION LABEL LOCATED ON THE REAR DRIVER'S SIDE DOOR PILLAR WAS PRINTED MISSING THE WHEEL SIZE (RIM) INFORMATION.

Dec 12, 2007 – ON CERTAIN SPORT UTILITY VEHICLES, UNDER CERTAIN CONDITIONS, THE CLIMATE CONTROL MODULE (CCM) MAY RECEIVE A 'SHUT-DOWN SIGNAL' FROM THE ENGINE CONTROL MODULE (ECM) AFTER IGNITION KEY INSERTION. IF THIS CONDITION OCCURS, THE CLIMATE CONTROL FUNCTIONS WILL NOT BE AVAILABLE (INCLUDING THE DEFROSTER) DURING THAT DRIVING CYCLE.

Nov 19, 2007 – ON CERTAIN TRUCKS, THE BOLTS THAT ATTACH THE STEERING GEAR TO THE FRAME MAY NOT HAVE BEEN TIGHTENED TO THE SPECIFIED TORQUE.

Oct 26, 2007 – IN CERTAIN VEHICLES, TWO SOFTWARE ERRORS HAVE BEEN FOUND IN THE SUPPLEMENTAL RESTRAINT SYSTEM (SRS) CONTROL UNIT SOFTWARE. THIS MAY RESULT IN A LATE DEPLOYMENT OF THE INFLATABLE CURTAIN (IC) AND SIDE IMPACT PROTECTION SYSTEM (SIPS) AIR BAGS IN CERTAIN SIDE IMPACT CRASH SITUATIONS. IN ADDITION, THIS SOFTWARE ERROR MAY ALSO CAUSE THE 'SRS AIRBAG - SERVICE URGENT' MESSAGE AND SRS WARNING LIGHT TO ILLUMINATE.

Oct 23, 2007 – ON CERTAIN TRUCKS EQUIPPED WITH A SAF HOLLAND SIMPLEX FIFTH WHEEL, THE LEVER ARM PIVOT BOLT MAY HAVE BEEN OVER TIGHTENED. AN OVER TIGHTENED PIVOT BOLT CAN DISTORT THE PIVOT BOLT SPACER SLEEVE, WHICH MAY PREVENT THE FIFTH WHEEL LATCH JAW FROM CLOSING AND LATCHING SECURELY AROUND THE TRAILER KING PIN.

Sep 10, 2007 – ON CERTAIN TRUCKS, THE HOOD RESTRAINT CYLINDER DOES NOT CONTAIN ENOUGH DAMPENING TO ADEQUATELY RESTRAIN THE HOOD.

Aug 07, 2007 – ON CERTAIN TRUCKS, AN UNPROTECTED LEAD IN THE THERMOSWITCH OF THE HEATER MAY MAKE CONTACT WITH ANOTHER POST POSSIBLY CREATING A SHORT CIRCUIT, WHICH CAN RESULT IN CONTINUOUS OPERATION OF THE HEATING ELEMENT.

Jul 24, 2007 – ON CERTAIN TRUCKS, THE NUT USED TO RETAIN THE STEERING SHAFT MAY OR MAY NOT BE A LOCK NUT THAT HAS THE LOCKING FEATURE. A LOCK NUT IS REQUIRED TO PROVIDE ADDITIONAL RESISTANCE TO ENSURE THAT THE NUT DOES NOT COME LOOSE.

Jun 05, 2007 – ON CERTAIN PASSENGER VEHICLES, THE FUEL PRESSURE SENSOR LOCATED ON THE LEFT END OF THE FUEL RAIL MAY, AT TIMES, TRANSMIT INCORRECT SIGNAL REGARDING THE FUEL PRESSURE TO THE ENGINE CONTROL MODULE. IF THE SIGNAL IS OUTSIDE OF THE PRE-PROGRAMMED ALLOWABLE LIMITS, A DIAGNOSTIC TROUBLE CODE MAY BE SET AND THE CHECK ENGINE LIGHT WILL COME ON. THE SOLDERED JOINTS ON THE CIRCUIT BOARD OF THE FUEL PRESSURE SENSOR MAY CRACK DUE TO TEMPERATURE CHANGES AND EXCESSIVE VIBRATIONS.

May 25, 2007 – ON CERTAIN PASSENGER VEHICLES, IT HAS BEEN DETERMINED THAT WHILE DOING BATTERY MAINTENANCE THE JACK'S CRANK HANDLE CAN BE MISPLACED UNDER A BRACKET WHICH RETAINS THE BATTERY.