WESTERN STAR Recalls

Mar 08, 2004 – ON CERTAIN TRUCKS AND TRUCK-TRACTORS EQUIPPED WITH TRW DRAG LINK ASSEMBLIES, THE REPLACEMENT CLAMP AND DRAG LINK ASSEMBLIES CONTAIN A POTENTIALLY DEFECTIVE 5/8-11-GRADE B PREVAILING TORQUE HEX NUT. IF THE FINAL TIGHTENING IS LESS THAN 65 LB.-FT., THE CLAMP LOAD WOULD BE UNACCEPTABLY LOW AND COULD COMPROMISE THE INTEGRITY OF THE DRAG LINK.

Jun 17, 2003 – ON CERTAIN TRUCK TRACTORS EQUIPPED WITH JOST INTERNATIONAL JSK 37U SERIES FIFTH WHEELS, A FATIGUE CRACK CAN DEVELOP IN THE BRACKET PIN WELD UNDER CERTAIN LOADING CONDITIONS.

Mar 21, 2003 – ON CERTAIN TRUCKS EQUIPPED WITH TRUCK HUB UNITS MANUFACTURED BY SKF EXCLUSIVELY FOR USE ON ARVINMERITOR'S FF98X SERIES NON-DRIVE STEER AXLES, THE HUB UNIT BEARINGS CAN WEAR PREMATURELY.

Dec 17, 2002 – ON CERTAIN TRUCK-TRACTOR MODEL VEHICLES EQUIPPED WITH CONMET SIMPLEX STATIONARY OR SLIDING FIFTH-WHEEL, THE CLINCH PINS THAT RETAIN THE FIFTH-WHEEL PIVOT PINS MAY NOT BE FULLY INSTALLED.

Mar 20, 2002 – ON CERTAIN TRUCKS, A CAPACITOR IN THE POWER LINE CONTROL (PLC) FILTER COULD OVERHEAT AND/OR IGNITE WHEN SUBJECTED TO REVERSE POLARITY ELECTRICAL SPIKES.

Dec 17, 2001 – ON CERTAIN TRUCKS EQUIPPED WITH CATERPILLAR 3406E AND C-15 ENGINES, INTERFERENCE BETWEEN THE POSITIVE BATTERY CABLE AND STUD MOUNTING ELECTRONIC CONTROL MODULE (ECM) TO THE ENGINE EXISTS. CHAFING CAN WEAR THROUGH THE BATTERY CABLE INSULATION TO ALLOW CONTACT BETWEEN THE BATTERY CABLE AND THE STUD.

Jun 14, 2001 – VEHICLE DESCRIPTION: VEHICLES EQUIPPED WITH CERTAIN HALDEX BRAKE SYSTEM TWO AND FOUR PORT RELAY VALVES. THE VALVE MAY STICK OPEN WHEN A HIGH-PRESSURE APPLICATION IS RELEASED.

May 14, 2001 – VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS EQUIPPED WITH CHALMERS 1000 AND 800 SERIES SUSPENSION KITS. THESE SUSPENSION KITS MAY HAVE INSUFFICIENT PENETRATION OF THE WELD ATTACHING THE TORQUE ROD EYE TO THE TORQUE ROD TUBE.

Feb 21, 2001 – VEHICLE DESCRIPTION: TRUCKS, SCHOOL BUS AND MOTOR HOME CHASSIS, AND TRANSIT BUSES EQUIPPED WITH TIE ROD ASSEMBLIES MANUFACTURED BY TRW. THE SUSPECT TIE RODS CONTAIN 24-DL MODEL BALL SOCKETS. CERTAIN OF THE TIE ROD BALL-SOCKET BEARINGS HAVE A BELOW-SPECIFICATION CASE DEPTH AND/OR HARDNESS, WHICH CAN LEAD TO PREMATURE WEAR OF THE SOCKET.

Oct 11, 2000 – VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS EQUIPPED WITH TRW 20-EDL BALL-SOCKET ASSEMBLIES. CERTAIN OF THE BALL-SOCKET BEARINGS HAVE A BELOW SPECIFICATION CASE DEPTH AND/OR HARDNESS WHICH CAN LEAD TO PREMATURE WEAR OUT OF THE SOCKET. THESE BEARINGS WERE PRODUCED BETWEEN JULY 5 AND OCTOBER 3, 1999.