CHEVROLET IMPALA Recalls

Oct 15, 1980 – THE INVOLVED VEHICLES MAY HAVE INSUFFICIENT CLEARANCE BETWEEN THE FRONT BRAKE PIPE AND THE ENGINE OIL PAN. THIS CONDITION COULD CAUSE THE BRAKE PIPE TO CONTACT THE LEFT HAND FRONT EDGE OF THE OIL PAN, RESULTING IN WEAR AND, EVENTUALLY, DAMAGE TO THE BRAKE PIPE. THIS COULD LEAD TO A LOSS OF BRAKE FLUID AND SUBSEQUENT LOSS OF BRAKES.

Oct 14, 1980 – VEHICLES MAY NOT CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 110, "TIRE SELECTION AND RIMS". THE TIRE RIM SIZE WAS OMITTED ON THE EXISTING LABEL.

Sep 25, 1980 – THE INVOLVED VEHICLES MAY HAVE BEEN ASSEMBLED WITH A BRAKE PEDAL SUPPORT BRACKET WHICH WAS DESIGNED FOR USE IN DIESEL ENGINE VEHICLES. THE INCORRECT BRACKET MAY CAUSE THE SERVICE BRAKES TO REMAIN PARTIALLY APPLIED, RESULTING IN BRAKE OVERHEATING AND REDUCED BRAKING EFFECTIVENESS.

Nov 13, 1979 – THE HEADS MAY BREAK OFF THE FRONT OUTBOARD SEAT BELT ANCHOR BOLTS DURING NORMAL VEHICLE OPERATION EVEN UNDER NO LOAD CONDITIONS. THIS IS DUE TO THE COMBINATION OF BOLTS USED, HIGH INSTALLATION TORQUE AND ARRANGEMENT OF THE BODY ANCHORAGE.

Jul 02, 1979 – A CHILD COULD OPEN THE REAR SIDE COMPARTMENT DOOR AND ENTER THIS COMPARTMENT. THE CHILD COULD BECOME ENTRAPPED IF THE DOOR WERE TO CLOSE, AS IT CANNOT BE UNLATCHED FROM THE INSIDE.

Jun 06, 1979 – ON THE INVOLVED VEHICLES THE BRAKE STOPLIGHT AND CRUISE CONTROL SWITCH WHICH IS OPERATED BY THE BRAKE PEDAL MAY HAVE BEEN ASSEMBLED WITH AN INCORRECT LUBRICANT ON THE ACTUATING PLUNGER. THIS CAN CAUSE THE REAR BRAKE STOPLIGHTS TO BECOME INOPERATIVE AND THE CRUISE CONTROL, IF ACTIVATED, TO STAY ELECTRICALLY ENGAGED.

Aug 16, 1978 – THE INVOLVED VEHICLES DO NOT CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 207, "ANCHORAGE OF SEATS", IN THAT THE FRONT SEAT ADJUSTER ASSEMBLIES HAVE LOCK BARS WHICH MAY NOT REMAIN ENGAGED WHEN TEST PROCEDURE FORCES ARE APPLIED TO THE SEAT.

Nov 16, 1977 – THE REAR WHEEL MOUNTING BOLTS ON THE AFFECTED VEHICLES, ARE BRITTLE AND THEREFORE MAY FRACTURE. THIS BRITTLENESS IS DUE TO IMPROPER HEAT TREATMENT DURING MANUFACTURE. IF THE BOLTS BREAK, THE TIRE AND WHEEL ASSEMBLY MAY SEPARATE FROM THE VEHICLE.

Jan 24, 1973 – THE POSSIBILITY EXISTS THAT DRIVING ON UNPAVED ROAD SURFACES, PARTICULARLY ROADS WHICH ARE HEAVILY GRAVELED AND WHICH ARE EXTREMELY WAVY OR FILLED WITH CHUCKHOLES, AT SPEEDS WHICH CAUSE THE CAR TO PITCH EXCESSIVELY, THE FRONT CROSSMEMBER MAY SCOOP UP LOOSE STONES OR GRAVEL AND COULD BE THROWN INTO THE ENGINE COMPARTMENT. IT IS POSSIBLE FOR ONE OF THESE STONES TO LODGE BETWEEN THE STEERING COUPLING AND THE FRAME AND CAUSE INCREASED STEERING EFFORT OR INTERFERENCE WITH STEERING CONTROL OF THE CAR WHEN STEERING WHEEL IS TURNED TO THE LEFT.

Dec 29, 1971 – THERE IS A POSSIBILITY THAT A SEPARATED MOTOR MOUNT MAY ALLOW THE ENGINE TO LIFT, WHICH MAY AFFECT THE THROTTLE LINKAGE, MOMENTARILY INCREASING THROTTLE, POSSIBLY TO FULL THROTTLE.