CHEVROLET VENTURE Recalls

Aug 09, 2002 – CERTAIN PASSENGER, MINI VANS, AND SPORT UTILITY VEHICLES HAVE AN AIR BAG INFLATOR ON THE DRIVER'S SIDE THAT COULD FRACTURE AT A WELD DURING A DEPLOYMENT.

Dec 13, 2001 – VEHICLE DESCRIPTION: CERTAIN MINI VANS BUILT WITH SECOND ROW 50/50 SPLIT BENCH SEATS OR CAPTAIN'S CHAIRS, FAIL TO COMPLY WITH THE REQUIREMENTS OF FMVSS NO. 225, "CHILD RESTRAINT ANCHORAGE SYSTEMS." THE SEAT LATCH ANCHOR WIRE DIAMETER IS GREATER THAN 6.1 MM.

Aug 21, 2001 – VEHICLE DESCRIPTION: 1997-2001 CHEVROLET VENTURE, PONTIAC MONTANA/TRANSPORT, AND OLDSMOBILE SILHOUETTE MINI VANS EQUIPPED WITH PASSENGER SIDE POWER SLIDING DOORS THAT WERE SERVICED IN CAMPAIGN 01013 (01V-067) FROM APRIL TO AUGUST 2001. ALSO 2001 CHEVROLET VENTURE, PONTIAC MONTANA, AND OLDSMOBILE SILHOUETTE MINI VANS EQUIPPED WITH PASSENGER SIDE POWER SLIDING DOORS ASSEMBLED IN JANUARY THROUGH APRIL 2001. THESE VEHICLES HAVE INADEQUATE FRONT WELDS. IF A FRONT WELD FAILS, THE ACTUATOR CAN JAM IN THE UNLATCHED POSITION AND, WHEN THE SLIDING DOOR CLOSES, IT WILL NOT BE LATCHED.

Mar 08, 2001 – VEHICLE DESCRIPTION: MINIVANS EQUIPPED WITH PASSENGER SIDE POWER SLIDING DOORS. THE DOOR CLOSES BUT MAY NOT BE LATCHED. IF THIS HAPPENS, THE POWER SLIDING DOOR CAN OPEN WHILE THE VEHICLE IS IN MOTION, PARTICULARLY WHEN THE VEHICLE ASCENDS A HILL, MAKES A TURN, OR TRAVELS OVER A ROUGH ROAD SURFACE.

Feb 01, 2001 – VEHICLE DESCRIPTION: PASSENGER, SPORT UTILITY VEHICLES AND MINIVANS. THE PASSENGER AIR BAG INFLATOR MODULES WERE BUILT WITHOUT THE CORRECT AMOUNT OF GENERANT, WHICH PRODUCES THE GAS THAT FILLS THE AIR BAG. SOME WERE BUILT WITH A DOUBLE LOAD OF GENERANT AND SOME WERE BUILT WITHOUT GENERANT.

Aug 07, 2000 – VEHICLE DESCRIPTION: PASSENGER VEHICLES, LIGHT DUTY TRUCKS, SPORT UTILITY VEHICLES, AND MINI VANS EQUIPPED WITH TRW SEAT BELT BUCKLE ASSEMBLIES. THE BUCKLE BASE OF THESE SEAT BELT ASSEMBLIES WERE NOT PROPERLY HEAT TREATED AND THEREFORE DO NOT PASS THE LOAD BEARING REQUIREMENT OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 209, "SEAT BELT ASSEMBLIES."

Sep 29, 1999 – VEHICLE DESCRIPTION: MINI VANS WITH EXTENDED WHEELBASE. SOME OF THESE VEHICLES HAVE INOPERATIVE FUEL TANK ROLLOVER VALVES AND FUEL LEAKAGE WOULD EXCEED THE PERMISSIBLE AMOUNT IN A ROLLOVER TEST. THIS DOES NOT COMPLY WITH THE REQUIREMENTS OF FMVSS NO. 301, "FUEL SYSTEM INTEGRITY."

Apr 12, 1999 – VEHICLE DESCRIPTION: PASSENGER MINI VANS. THE LEFT AND/OR RIGHT FRONT LOWER INSULATOR TO CRADLE CENTER METAL SLEEVE IS COLLAPSED, WHICH CAN RESULT IN LOSS OF CLAMP LOAD IN THE JOINT. IF THE CLAMP LOAD IS REDUCED OR LOST, THE BOLT CAN BE LOST OR BROKEN AND THE JOINT CAN SEPARATE.

Jun 26, 1998 – VEHICLE DESCRIPTION: PASSENGER MINI VANS EQUIPPED WITH BUCKET SEATS OR A SPLIT BENCH SEAT IN THE SECOND (MIDDLE) OR THIRD (BACK) ROW. THE SEAT LATCH MECHANISMS ON BUCKET SEATS AND ON THE 40% PORTION OF THE SPLIT BENCH SEAT IN THE SECOND AND THIRD ROWS DO NOT HAVE PROTECTIVE COVERS.

Jun 11, 1998 – VEHICLE DESCRIPTION: MINI VANS. THESE VEHICLES MAY HAVE (1) A BROKEN SHIFT CABLE FITTING OR (2) LOOSE SHIFT LINKAGE. CONSEQUENTLY, MOVING THE SHIFT LEVER TO A 'PARK' POSITION MAY NOT SHIFT THE TRANSMISSION TO 'PARK'.