GMC Recalls

Aug 16, 2006 – CERTAIN TRUCKS FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 121, "AIR BRAKE SYSTEMS." AN INTERNAL CONTROL AND CHECK VALVE WITHIN THE AIR BRAKE APPLICATION VALVE ASSEMBLY WAS CONFIGURED IMPROPERLY, PREVENTING AIR FROM FLOWING THROUGH THE BRAKE SYSTEM AS DESIGNED. IN THE EVENT OF AN EMERGENCY STOP, THE VEHICLE'S STOPPING DISTANCE WOULD BE INCREASED.

Aug 11, 2006 – CERTAIN SPORT UTILITY VEHICLES AND TRUCKS FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 110, "TIRE SELECTION AND RIMS." THESE VEHICLES HAVE AN INCOMPLETE TIRE RIM DESIGNATION ON THE CERTIFICATION/TIRE LABEL LOCATED ON THE DRIVER'S DOOR EDGE. IN ADDITION, THE LABEL MAY ALSO BE MISSING THE TIRE LOAD RATING ON THE LABEL. ALTHOUGH THIS INFORMATION IS NOT REQUIRED BY THE STANDARD, IF A TIRE OF A LESSER LOAD RATING IS INSTALLED, THE TIRE MAY NOT BE ABLE TO SUSTAIN THE LOADS ENCOUNTERED DURING USE.

Aug 03, 2006 – ON CERTAIN TRUCKS EQUIPPED WITH AN 8.1L V8 (RPO L8-VIN G) ENGINE HAVE A CONDITION IN WHICH THE ENGINE FUEL RAIL PULSE DAMPER RETAINER CLIP MAY FRACTURE RESULTING IN INADEQUATE RETENTION OF THE DAMPER.

Jul 13, 2006 – CERTAIN MEDIUM DUTY TRUCKS EQUIPPED SR-7 BENDIX BRAKE VALVES, THE CHECK VALVE INSIDE THE VALVE CAVITY MAY NOT PROPERLY SET, CAUSING INTERNAL AIR LEAKAGE. IF THE CHECK VALVE DOES NOT PROPERLY SEAT, THE RESULTING LEAKAGE CAN CAUSE A DELAY IN THE APPLICATION OF THE SPRING BRAKES TO PARK THE VEHICLE AFTER OPERATOR PULLS THE DASH VALVE BUTTON.

Jun 06, 2006 – CERTAIN FEDERAL-MOGUL NATIONAL AND CARQUEST AFTERMARKET HUB ASSEMBLIES, P/N 515058, SOLD FOR USE ON 2001-2006 GENERAL MOTORS 1500 AND 2500 4WD TRUCKS. ON THE SUBJECT HUB ASSEMBLIES, THE ABS SENSOR CORD DEPARTS FROM THE HUB ASSEMBLY AT A 90 DEGREE ANGLE. AS A RESULT, THERE IS A FIT ISSUE WITH THE BRAKE ROTOR DUST SHIELD INTERFERING WITH THE ABS SENSOR CORD. IF THE HUB ASSEMBLY IS INSTALLED DESPITE THIS INTERFERENCE, THE GAP BETWEEN THE ABS SENSOR AND THE TONE WHEEL MAY BE ALTERED. THIS MAY WEAKEN THE OUTPUT OF THE ABS SENSOR. DIMINISHED OUTPUT COULD RESULT IN AN UNWANTED ABS ACTIVATION AT LOW SPEEDS AND STOPPING DISTANCE COULD BE AFFECTED.

May 24, 2006 – CERTAIN CK MOTORSPORTS COMBINATION HEADLIGHTS, CLEAR CORNER, BUMPER, AND SIDE MARKER LIGHTS SOLD AS REPLACEMENT LAMPS FOR USE ON THE PASSENGER VEHICLES LISTED ABOVE. SOME COMBINATION LAMPS THAT ARE NOT EQUIPPED WITH AMBER SIDE REFLECTORS FAIL TO CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT.

May 19, 2006 – CERTAIN REPLACEMENT FUEL FILTERS, FRAM BRAND NAME P/N G3727, WITH DATE CODES X52911 THROUGH X60801 SEQUENTIALLY OR X600141 AND A MEXICO COUNTRY OR ORIGIN MARKING ON THE FUEL FILTER HOUSING MANUFACTURED FROM OCTOBER 18, 2005, THROUGH MARCH 21, 2006, SOLD FOR USE ON THE VEHICLES LISTED ABOVE AND ON CERTAIN SCHOOL BUSES. (TO SEE THE SCHOOL BUS ENGINE SIZES, CLICK ON "DOCUMENT SEARCH" AND THEN "BUS APPLICATIONS"). THE CONNECTOR ON THE FUEL FILTER WAS NOT MANUFACTURED TO HONEYWELL'S SPECIFICATION. AS A RESULT, THE O-RING MAY NOT SEAT CORRECTLY ON THE FUEL LINE.

May 18, 2006 – CERTAIN R&B, INC. CENTRAL MULTIPORT FUEL INJECTION (CMFI) FUEL RETURN LINES, MODELS HELP 55163, NAPA BALKAMP 700-3270, AND THE CONNECTION 2560001, SOLD FOR USE AS REPLACEMENT EQUIPMENT FOR THE VEHICLES LISTED ABOVE. THE FUEL RETURN LINE HAS A MECHANICAL BLEED VALVE WHICH WAS NOT INSTALLED AT THE PROPER TORQUE.

May 15, 2006 – CERTAIN E SPEED RACING COMBINATION LAMPS SOLD AS REPLACEMENT EQUIPMENT FOR USE ON CERTAIN PASSENGER VEHICLES LISTED ABOVE. SOME COMBINATION LAMPS THAT ARE NOT EQUIPPED WITH AMBER SIDE REFLECTORS FAIL TO CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT.

Apr 27, 2006 – CERTAIN PICKUP TRUCKS MAY EXPERIENCE THE PERMANENT LOSS OF BRAKE LAMP FUNCTION OR BRAKE LAMPS THAT ARE ILLUMINATED AT ALL TIMES. THE CENTER HIGH-MOUNTED STOP LAMP (CHMSL) IS AFFECTED IN BOTH INSTANCES. ALSO, IF EQUIPPED, THE CRUISE CONTROL WILL BECOME INOPERATIVE. ANY TRAILER BRAKE LAMPS WHICH ARE CONNECTED TO THE VEHICLE'S BRAKE LAMP WIRING WILL MIMIC THE VEHICLE'S BRAKE LAMPS WHEN EITHER CONDITION OCCURS.