ISUZU AMIGO Recalls

Jun 29, 2012 – ISUZU IS RECALLING CERTAIN MODEL YEAR 1998-2000 AMIGO AND MODEL YEAR 2001-2002 RODEO SPORT VEHICLES, THAT WERE ORIGINALLY SOLD, OR ARE CURRENTLY REGISTERED, IN THE STATES OF MAINE, NEW HAMPSHIRE, VERMONT, MASSACHUSETTS, RHODE ISLAND, CONNECTICUT, NEW YORK, NEW JERSEY, PENNSYLVANIA, DELAWARE, MARYLAND, THE DISTRICT OF COLUMBIA, WEST VIRGINIA, OHIO, INDIANA, MICHIGAN, ILLINOIS, WISCONSIN, MINNESOTA, IOWA, MISSOURI, AND KENTUCKY. THESE VEHICLES MAY EXPERIENCE EXCESSIVE CORROSION IN THE VICINITY OF THE FORWARD MOUNTING POINT BRACKET FOR THE LEFT OR RIGHT REAR SUSPENSION LOWER LINK.

Oct 15, 2002 – ON CERTAIN SPORT UTILITY VEHICLES AND PICKUP TRUCKS, THE LATCH PLATE USED IN THE SEAT BELT BUCKLE WAS NOT MANUFACTURED ACCORDING TO DESIGN DIMENSIONS. IF THE SEAT BELT TONGUE IS INSERTED SLOWLY AT AN ANGLE INTO THE BUCKLE, THERE IS A POSSIBILITY OF PARTIAL ENGAGEMENT.

Jun 03, 2002 – ON CERTAIN SPORT UTILITY VEHICLES THAT ARE EQUIPPED WITH AN ANTI-LOCK BRAKING SYSTEM (ABS), THE VEHICLES CAN EXPERIENCE EXTENDED STOPPING DISTANCES IN CERTAIN TYPES OF BRAKING EVENTS.

May 29, 2001 – THIS IS NOT A SAFETY RECALL IN ACCORDANCE WITH THE SAFETY ACT. HOWEVER, IT IS DEEMED A SAFETY IMPROVEMENT CAMPAIGN BY THE AGENCY. VEHICLE DESCRIPTION: 1998-2000 RODEO (UE) AND AMIGO (UA) MODELS EQUIPPED WITH 2.2L 4-CYLINDER ENGINES. THE TIMING BELT COULD BREAK BEFORE THE RECOMMENDED SCHEDULED MAINTENANCE.

Mar 02, 2000 – VEHICLE DESCRIPTION: SPORT UTILITY VEHICLES. PAINT WAS APPLIED UNEVENLY ON THE REAR AXLES, RESULTING IN INSUFFICIENT PAINT HARDNESS. SHOULD THIS OCCUR ON THE SURFACE THAT CONTACTS THE REAR AXLE LOWER LINK BRACKET BOLT HEAD AND/OR NUT, THE NUT MAY LOOSEN.

Oct 20, 1998 – VEHICLE DESCRIPTION: PASSENGER VEHICLES EQUIPPED WITH A SUNROOF SUNSHADE. THE PRIMER APPLIED TO PREPARE THE SURFACE PRIOR TO BONDING THE SUNSHADE HOLDERS TO THE SUNROOF WEAKENED THE BONDING STRENGTH OF THE ADHESIVE, RESULTING IN AN UNSATISFACTORY BOND OF THE HOLDER TO THE SUNROOF.

Jul 24, 1998 – VEHICLE DESCRIPTION: SPORT UTILITY VEHICLES. A GROUND CONNECTION TERMINAL WAS NOT PROPERLY CRIMPED IN THE SUPPLIER'S ENGINE WIRING HARNESS MANUFACTURING LINE. THIS IMPROPER CRIMPING PROCESS CAN LEAVE AN IMPRESSION ON THE TERMINAL THAT WILL EVENTUALLY CAUSE A STRESS FRACTURE. S

May 26, 1998 – VEHICLE DESCRIPTION: SPORT UTILITY VEHICLES. THE STRENGTH OF THE REAR SEAT BELT SHOULDER ANCHORAGE IS NOT TO DESIGN SPECIFICATIONS AND DOES NOT FULLY COMPLY WITH REQUIREMENTS OF FMVSS NO. 210, "SEAT BELT ASSEMBLY ANCHORAGES."

Sep 17, 1996 – THE LATCH PLATE USED IN THE SEAT BELT BUCKLE WAS NOT MANUFACTURED ACCORDING TO DESIGN DIMENSIONS. IF THE SEAT BELT TONGUE IS INSERTED SLOWLY AT AN ANGLE INTO THE BUCKLE, THERE IS A POSSIBILITY OF PARTIAL ENGAGEMENT.

Jul 22, 1993 – THE WELD ON THE RECEIVER UNIT OF THE TRAILER HITCH CAN BREAK.