MERCURY MARQUIS Recalls

Aug 27, 2007 – CERTAIN FEDERAL-MOGUL AFTERMARKET FUEL PUMPS SOLD UNDER THE BRAND NAMES OF CARTER, ACCUFLOW, NAPA, TRUFLOW, PARTS DEPO, AND PARTS MASTER, SHIPPED BETWEEN AUGUST 2006 AND JULY 2007 FOR USE ON THE VEHICLES LISTED ABOVE. THE FUEL PUMP DIAPHRAGM IN CERTAIN PRODUCTION RUNS MAY HAVE BEEN IMPROPERLY INSTALLED OR INADEQUATELY TESTED WHICH MAY CAUSE THE FUEL PUMP TO LEAK.

Mar 14, 2005 – ON CERTAIN PASSENGER VEHICLES BUILT WITH ELECTRONIC TRACTION CONTROL, THE REAR BRAKE LINE MAY CHAFE DUE TO CONTACT BETWEEN IT AND A FLOOR PAN STIFFENING RIB, AND A BRAKE FLUID LEAK MAY OCCUR.

May 21, 1985 – BRAKE BOOSTER REAR SHELLS MAY HAVE REDUCED WALL THICKNESSES WHICH COULD CAUSE THE SHELL TO BREAK. CONSEQUENCE OF DEFECT: REPEATED BRAKE USE COULD CAUSE THE SHELL TO CRACK AND THE BOOSTER ASSEMBLY TO COME APART. SERVICE BRAKES CAPABILITY WOULD BE TOTALLY LOST WITHOUT WARNING AND COULD RESULT IN AN ACCIDENT.

Dec 20, 1983 – THE BOLTS THAT ATTACH THE D-SHAPED RING FOR THE SHOULDER BELT ARE INADEQUATELY SUPPORTED BY THE MATERIAL IN WHICH THEY ARE MOUNTED. THE ATTACHMENT DOES NOT COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 210, "SEAT BELT ASSEMBLY ANCHORAGES".

Mar 07, 1983 – THE PARKING GEAR MAY NOT ENGAGE, EVEN THOUGH THE GEAR SHIFT LEVER IS PLACED IN THE "PARK" POSITION. THIS OCCURS IF THE LINKAGE INSIDE THE TRANSMISSION THAT ACTUATES THE PARK GEAR WAS IMPROPERLY MANUFACTURED. A PIN THAT RETAINS COMPONENTS ON A LINKAGE (ACTUATING) ROD COULD BREAK AND THE LINKAGE MAY NOT ENGAGE THE PARKING GEAR.

Feb 24, 1983 – THE SHIFT INDICATOR MAY NOT ACCURATELY REFLECT THE SHIFT SELECTOR POSITION. SOME VEHICLES WERE PRODUCED WITH TRANSMISSION CONTROL SELECTOR TUBE RETAINING CLIPS THAT MAY NOT BE HARD ENOUGH. THE CLIP MAY LOOSEN OR FALL OFF, AND THE SELECTOR TUBE MAY BECOME DISPLACED.

Dec 28, 1982 – THE LOWER CONTROL ARMS MAY HAVE BEEN MANUFACTURED FROM STEEL WITH MATERIAL THICKNESS BELOW THE MINIMUM SPECIFICATIONS FOR POLICE DUTY. THIS COULD LEAD TO CRACKS DEVELOPING IN THE CONTROL ARMS, AND EVENTUALLY, THE POSSIBILITY OF FRACTURE OF AN ARM.

Nov 13, 1980 – SOME OF THE INVOLVED VEHICLES HAVE ELECTRICAL RELAY SYSTEMS WHICH MAY BE SUSCEPTIBLE TO WATER LEAKAGE INTO THE RELAY CASE. WATER ENTRY MAY CAUSE A SHORT CIRCUIT WITHIN THE RELAY.

Sep 23, 1980 – THE INVOLVED VEHICLES MAY START IN REVERSE GEAR. THIS DOES NOT COMPLY WITH FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 102, "TRANSMISSION SHIFT LEVER SEQUENCE, STARTER INTERLOCK, AND TRANSMISSION BRAKING AFFECT". SOME OF THESE VEHICLES MAY BE EQUIPPED WITH A DEFECTIVE NEUTRAL START SWITCH THAT OCCASIONALLY PERMITS ENGINE STARTING WITH THE TRANSMISSION SHIFT LEVER IN THE REVERSE ("R") POSITION.

May 15, 1979 – THE INVOLVED VEHICLES WERE PRODUCED WITH BRAKE PUSH-ROD TO BRAKE PEDAL RETAINING PINS WHICH WERE NOT HEAT-TREATED AS SPECIFIED. THIS COULD ALLOW THE BRAKE PEDAL TO BECOME DISENGAGED FROM THE PUSH-ROD.