NAVISTAR Recalls

Aug 03, 1999 – VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS EQUIPPED WITH STEERING COLUMNS SUPPLIED BY DOUGLAS AUTOTEC. THE STEERING COLUMNS ON THESE VEHICLES MAY HAVE A DEFECTIVE OR DISLOCATED WELD.

Jul 15, 1999 – VEHICLE DESCRIPTION: TRUCKS ASSEMBLED WITH SKF LEVEL 2 TRUCK HUB UNITS (THU) RECEIVED FROM MERITOR. THESE HUBS CAN FATIGUE CRACK.

May 04, 1999 – VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS EQUIPPED WITH DANA/SPRAGUE WINDSHIELD WIPER ASSEMBLIES. THE KNURLED PIVOT SHAFT (WHICH OPERATES THE WINDSHIELD WIPER ARM) IS WELDED TO A LEVER, WHICH CONNECTS TO LINKAGE FROM THE WIPER MOTOR. THE WELD AT THE PIVOT SHAFT TO LEVER CAN FAIL.

Mar 16, 1999 – VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS, TRANSIT AND SCHOOL BUSES, EQUIPPED WITH MERITOR AIR BRAKE AUTOMATIC SLACK ADJUSTERS. SOME OF THE AUTOMATIC SLACK ADJUSTERS HAD INSUFFICIENT TORQUE APPLIED TO THE GUIDE PAWL CAP SCREW.

Mar 15, 1999 – VEHICLE DESCRIPTION: CLASS 8 HEAVY DUTY TRUCK CHASSIS EQUIPPED WITH 16,000 LB., 18,000 LB., OR 20,000 LB. HEAVY DUTY STEERING AXLES. THE INNER WHEEL BEARING CONE FOR THE STEERING AXLE WHEEL HUB ASSEMBLY DOES NOT PROPERLY FIT ONTO THE NAVISTAR STEERING AXLE SPINDLE ASSEMBLY. IMPROPER FIT OF THE BEARING TO THE SPINDLE INCREASES THE STRESS LEVELS TO THE STEERING AXLE SPINDLE WHICH COULD CAUSE SPINDLE FAILURE.

Feb 16, 1999 – SCHOOL, TRANSIT, OR HEAVY DUTY VEHICLES EQUIPPED WITH SPICER 6,000 OR 8,000 LB. FRONT STEER AXLES. THE TIE ROD END CAN PULL OUTBOARD AND SEPARATE FROM THE TIE ROD TUBE DUE TO IMPROPER THREAD ENGAGEMENT BETWEEN THE MALE TIE ROD END AND THE FEMALE TUBE.

Nov 09, 1998 – VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS EQUIPPED WITH A T444E DIESEL ENGINE. THE HIGH PRESSURE OILLINE FOR THE FUEL INJECTION SYSTEM THAT GOES FROM THE HIGH PRESSURE OIL PUMP TO THE RIGHT CYLINDER HEAD CAN CHAFE AGAINST THE CHARGE AIR COOLER CROSSOVER PIPE.

Nov 09, 1998 – VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS EQUIPPED WITH SPICER SPL170 55MM CENTER BERING PACKAGE. THE END YOKE RETAINING NUT CAN LOOSEN.

Nov 09, 1998 – VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS EQUIPPED WITH T444E DIESEL ENGINES. A FUEL LEAK CAN OCCUR BECAUSE OF OVERCRIMPING OF THE HOSE END FITTINGS ON THE HOSE FROM THE REGULATOR TO THE LEFT HEAD AND THE HOSE FROM THE FUEL TRANSFER PUMP TO THE REGULATOR.

Sep 17, 1998 – VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS EQUIPPED WITH A 1710 DRIVE LINE AND A 12 X 4 HYDRAULIC PARKING BRAKE. IF THE BRAKE DRUM OR TRANSMISSION YOKE ARE NOT FULLY SEATED WHEN THE EIGHT BOLTS ARE INSTALLED CONNECTING THE 3-PIECE JOINT, THE BOLTS CAN LOOSEN.