NAVISTAR Recalls

May 12, 2016 – Kovatch Mobile Equipment Corp. (KME) is recalling certain model year 2016 KME Predator and KME 2016-2107 Predator Severe Service and Panther emergency vehicles, equipped with pumps to provide pressurized water to aid in fighting fires. These pumps have 6" intake strainers that may have been improperly soldered during production and, as a result, the strainers may come apart during use, allowing parts of the strainer and debris to enter the pump, possibly damaging the pump.

Aug 26, 2014 – Navistar, Inc. (Navistar) is recalling certain FLTTRIKIT3 warning triangle kits manufactured August 15, 2012, to July 25, 2014. The affected warning triangles may reflect an inadequate amount of light. As such, these warning triangles fail to comply with Federal Motor Vehicle Safety Standard No. 125, "Warning devices."

Jan 24, 2000 – VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS. THE ANTILOCK TRACTION RELAY VALVES WERE INCORRECTLY ASSEMBLED BY THE SUPPLIER. AN EXTRA CHECK VALVE WAS INSTALLED WHICH WILL NOT ALLOW THE TRACTION CONTROL SYSTEM TO FUNCTION PROPERLY.

Dec 14, 1999 – VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS. THE CHECK VALVES IN THE AIR BRAKE SYSTEM ON THESE VEHICLES DO NOT MEET THE REQUIREMENTS OF FMVSS NO. 121, "AIR BRAKE SYSTEMS."

Dec 14, 1999 – VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS. THERE IS INTERFERENCE BETWEEN THE AIR BRAKE S-CAM AND THE END OF ONE OF THE KNUCKLE STUDS. AS THE BRAKE SHOE LINING WEARS, THE S-CAM ROTATION MAY BE LIMITED BY THE INTERFERING KNUCKLE STUD. IF THE S-CAM CAN NOT ROTATE THROUGH ITS FULL RANGE OF MOTION, THE BRAKING FORCE CAN NOT BE FULLY TRANSMITTED FROM THE BRAKE SHOE LININGS TO THE BRAKE DRUMS.

Nov 23, 1999 – VEHICLE DESCRIPTION: SCHOOL BUS. AN AIR BRAKE LINE CONTROLLING THE REAR BRAKES MAY BE TOO CLOSE TO THE EXHAUST PIPE AND COULD RUPTURE AT ANY TIME WITHOUT WARNING.

Sep 21, 1999 – VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS EQUIPED WITH BOSCH 9" X 3" PARKING BRAKE, SPRING ACTUATED, FOR HYDRAULIC LESS AIR SOURCE AND ACTUATED BY PARKING BRAKE KNOB IN INSTRUMENT PANEL. THE PARKING BRAKE HOSE CHAFES AT VARIOUS POINTS THROUGH THE ROUTING OF THE HOSES TO AND FROM THE HAND CONTROL VALVE.

Sep 21, 1999 – VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS BUILT WITH REAR LEAF SPRING SUSPENSIONS (MODELS 4700 BUILT WITH REAR LEAF SUSPENSIONS AND MANUFACTURED FROM DECEMBER 9, THROUGH DECEMBER 16, 1998; MODELS 3400 AND 3800 BUILT WITH 14SBK REAR LEAF SPRING SUSPENSIONS AND BUILT APRIL 14 THROUGH MAY 10, 1999; AND MODELS 3400 AND 3800 BUILT WITH REAR LEAF SPRING SUSPENSIONS AND MANUFACTURED FROM MAY 10 THROUGH MAY 18, 1999). ON VEHICLES WHERE THE FRAME TO AXLE HOSE LENGTH WAS TOO LONG, A CHAFING CONDITION EXISTS ON SUSPENSION COMPONENTS, WHICH COULD RESULT IN HOSE RUPTURE. ON VEHICLES WHERE THE HOSES ARE TOO SHORT, A HOSE SEPARATION COULD OCCUR WITH SEVERE SUSPENSION ARTICULATION.

Sep 21, 1999 – VEHICLE DESCRIPTION: TRANSIT AND SCHOOL BUSES BUILT WITH ABS AIR BRAKE ECU AND A 100 GALLON FUEL TANK MOUNTED BETWEEN THE RAILS AND BEHIND THE REAR AXLE ON MODELS WITH A 276" WHEEL BASE. THE ABS ECU INTERFERED WITH THE CROSS MEMBER MOUNTED BEHIND THE REAR AXLE AND IN FRONT OF THE BETWEEN THE RAILS FUEL TANK. THIS CREATED A NO-BUILD SITUATION AT THE PLANT - THE PLANT WOULD EITHER ELIMINATE OR RELOCATE THE CROSS MEMBER OR MOVE THE ECU AS NEEDED.

Sep 20, 1999 – VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS BUILT WITH CODE 16XWD (SUNSHADE OPTION CODE). SOME WIRES IN THE SUNSHADE WIRE HARNESS HAD INSULATION THAT DID NOT MEET TEMPERATURE SPECIFICATIONS. SOME HARNESSES HAVE BEEN FOUND TO HAVE ENOUGH MELTED INSULATION TO CREATE AN ELECTRICAL SHORT.