NISSAN SENTRA Recalls

Dec 15, 2011 – NISSAN IS RECALLING CERTAIN MODEL YEAR 2010-2011 SENTRA VEHICLES EQUIPPED WITH MR20 ENGINES, MANUFACTURED FROM MAY 11, 2010, TO MAY 22, 2010, AND JULY 8, 2010, TO OCTOBER 25, 2010. THE ZINC COATING APPLIED TO THE TERMINAL STUD BOLT WAS THICKER THAN SPECIFICATION. THIS CAN RESULT IN A VOLTAGE DROP THAT MAY CAUSE DIFFICULTY STARTING THE VEHICLE AND COULD CAUSE DAMAGE TO THE ENGINE CONTROL MODULE (ECM).

Nov 12, 2010 – NISSAN IS RECALLING CERTAIN MODEL YEAR 2010-2011 SENTRA VEHICLES, MANUFACTURED FROM MAY 22, 2010, THROUGH JULY 8, 2010. DUE TO A MACHINING IRREGULARITY, THE BOLT/WASHER SURFACE ON THE POSITIVE BATTERY TERMINAL CABLE END MAY ALLOW FOR A GAP TO OCCUR IN THE CONTACT AREA OF THE TERMINAL. THIS CAN RESULT IN A VOLTAGE DROP THAT MAY CAUSE DIFFICULTY STARTING THE VEHICLE AND COULD CAUSE DAMAGE TO THE ENGINE CONTROL MODULE.

Sep 10, 2010 – NISSAN IS RECALLING CERTAIN VEHICLES THAT WERE EQUIPPED WITH A GARMIN NUVI MODEL 750 NAVIGATION SYSTEM. THE BATTERIES CONTAINED IN THE AFFECTED GPS UNITS CAN OVERHEAT.

Nov 03, 2009 – NISSAN IS RECALLING CERTAIN MODEL YEAR 2008 SENTRA PASSENGER VEHICLES EQUIPPED WITH BOSCH MASTER CYLINDERS. BRAKE FLUID MAY LEAK FROM THE MASTER CYLINDER. IF THE AMOUNT OF BRAKE FLUID IN THE MASTER CYLINDER RESERVOIR DECREASES TO BELOW THE MINIMUM LEVEL, THE BRAKE SYSTEM WARNING INDICATOR WILL ILLUMINATE AS DESIGNED AND THE BRAKES WILL NOT FUNCTION PROPERLY.

May 11, 2009 – DOPE, INC. IS RECALLING 42,540 COMBINATION CORNER AND BUMPER LAMP ASSEMBLIES OF VARIOUS PART NUMBERS SOLD FOR USE AS AFTERMARKET EQUIPMENT FOR VARIOUS PASSENGER VEHICLES. THESE HEADLAMPS FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT." THESE LAMPS DO NOT CONTAIN THE REQUIRED AMBER SIDE REFLECTORS.

Apr 07, 2009 – SABERSPORT IS RECALLING 16,270 COMBINATION CORNER AND BUMPER LAMP ASSEMBLIES OF VARIOUS PART NUMBERS SOLD FOR USE AS AFTERMARKET EQUIPMENT FOR VARIOUS PASSENGER VEHICLES. THESE HEADLAMPS FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT." THESE LAMPS DO NOT CONTAIN THE REQUIRED AMBER SIDE REFLECTORS.

Jul 11, 2008 – NISSAN IS RECALLING 169,202 MY 2007-2008 SENTRA PASSENGER VEHICLES EQUIPPED ROBERT BOSCH MASTER CYLINDER. DUE TO THE MACHINING IRREGULARITY BY THE SUPPLIER, THE INTERNAL SEAL GROOVE IN THE BODY OF SOME BRAKE MASTER CYLINDERS MAY ALLOW FOR A GAP IN THE GROOVE CONTACT AREA OF THE SEAL. THIS MAY RESULT IN BRAKE FLUID SLOWLY LEAKING FROM THE MASTER CYLINDER INTO THE BRAKE BOOSTER ASSEMBLY, CAUSING THE BRAKE WARNING LIGHT TO ILLUMINATE.

Nov 14, 2007 – ON CERTAIN PASSENGER VEHICLES EQUIPPED WITH A 2.5L ENGINE, THE CRANKSHAFT POSITION SENSOR CAN OVERHEAT CAUSING A BRIEF INTERRUPTION IN THE SIGNAL OUTPUT FROM THE SENSOR.

Jul 17, 2006 – CERTAIN TRADESONIC COMBINATION LAMPS SOLD AS REPLACEMENT LAMPS FOR USE ON THE ABOVE LISTED PASSENGER VEHICLES. COMBINATION LAMPS NOT EQUIPPED WITH AMBER SIDE REFLECTORS FAIL TO CONFORM WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT.

Jul 07, 2006 – ON CERTAIN PASSENGER VEHICLES EQUIPPED WITH A 2.5L ENGINE, THE CRANK ANGLE SENSOR IS AFFECTED BY TEMPERATURE VARIATIONS. UNDER CERTAIN DRIVING CONDITIONS, THESE VARIATIONS IN TEMPERATURE CAN BE LARGE ENOUGH TO CAUSE A BRIEF INTERRUPTION IN THE SIGNAL OUTPUT FROM THE SENSOR.