NISSAN SENTRA Recalls

Jun 21, 2006 – CERTAIN PASSENGER VEHICLES EQUIPPED WITH 2.5L ENGINES MAY EXPERIENCE EXCESSIVE ENGINE OIL CONSUMPTION AS A RESULT OF IMPROPER PERFORMANCE OF THE PISTON RINGS.

May 24, 2006 – CERTAIN CK MOTORSPORTS COMBINATION HEADLIGHTS, CLEAR CORNER, BUMPER, AND SIDE MARKER LIGHTS SOLD AS REPLACEMENT LAMPS FOR USE ON THE PASSENGER VEHICLES LISTED ABOVE. SOME COMBINATION LAMPS THAT ARE NOT EQUIPPED WITH AMBER SIDE REFLECTORS FAIL TO CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT.

Mar 23, 2006 – CERTAIN PRO-A MOTORS CORNER LAMPS, TURN SIGNALS, AND HEADLIGHTS SOLD AS REPLACEMENT LAMPS FOR USE ON CERTAIN PASSENGER VEHICLES LISTED ABOVE. SOME COMBINATION LAMPS THAT ARE NOT EQUIPPED WITH AMBER SIDE REFLECTORS FAIL TO CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT.

Mar 13, 2006 – CERTAIN ANZO COMBINATION HEADLAMP ASSEMBLIES SOLD AS REPLACEMENT LAMPS FOR USE ON CERTAIN PASSENGER VEHICLES. SOME COMBINATION LAMPS ARE NOT EQUIPPED WITH AMBER SIDE REFLECTORS WHICH FAIL TO CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT."

Jun 07, 2005 – ON CERTAIN PASSENGER VEHICLES, A VAPOR HOSE LOCATED IN THE FUEL TANK MAY NOT HAVE BEEN FORMED CORRECTLY DURING THE MANUFACTURING PROCESS. WHEN THE VEHICLE IS PARKED WITH A FULL FUEL TANK, FUEL MAY FLOW INTO THE VAPOR HOSE, WHICH IS CONNECTED TO A VAPOR CANISTER.

Dec 10, 2003 – ON CERTAIN ELECTRIC VEHICLES, THE FRONT SUSPENSION TRANSVERSE LINK'S BALL JOINT BRACKET MAY BREAK FROM STRESS CONCENTRATION AT A NOTCH CREATED BY SURFACE ROUGHNESS AND THE SHAPE OF THE MATERIAL CUT-LINE.

Nov 17, 2003 – ON CERTAIN PASSENGER VEHICLES, THE CIRCUIT BOARD FOR THE CRANK POSITION SENSOR OR CAM POSITION SENSOR MAY HAVE AN IMPROPER SOLDER JOINT DUE TO SOLDER DEFORMATION CAUSED BY HEAT STRESS ACCELERATED BY THE EXISTENCE OF FLUX RESIDUE DURING THE SOLDERING PROCESS.

Nov 14, 2003 – ON CERTAIN PASSENGER VEHICLES EQUIPPED WITH THE QG18DE ENGINE OR QR25DE ENGINES, THE FOAM MATERIAL USED FOR THE INTERIOR LINING OF THE ELECTRONIC CONTROL MODULE (ECM) BOX EMITS SULFUR AS IT CURES.

Mar 11, 2003 – ON CERTAIN VEHICLES EQUIPPED WITH THE 2.5 LITER ENGINE, THE EXHAUST PIPE HANGER PIN MAY CATCH DEBRIS FROM THE ROAD THAT COULD BE IGNITED BY CONTACT WITH THE MAIN CATALYST. ALSO ON 2002 ALTIMA AND SENTRA VEHICLES, CERTAIN ENGINE OPERATING CONDITIONS MAY CAUSE THE PRE-CATALYST TO OVERHEAT AND DAMAGE THE CATALYST SUBSTRATE.

Feb 15, 2002 – ON SOME PASSENGER VEHICLES EQUIPPED WITH A NISSAN-APPROVED ACCESSORY FLOOR MAT THAT WAS INSTALLED EITHER AT THE ASSEMBLY PLANT OR BY THE DEALER, DUE TO THE LENGTH OF THE DRIVER SIDE FLOOR MAT, A SMALL AMOUNT OF MAT MOVEMENT COULD CAUSE THE MAT TO INTERFERE WITH THE ACCELERATOR PEDAL AND NOT ALLOW THE PEDAL TO RELEASE AFTER IT IS DEPRESSED.