NISSAN SENTRA Recalls

Dec 12, 2001 – VEHICLE DESCRIPTION: CERTAIN PASSENGER VEHICLES FAIL TO COMPLY WITH REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT." THESE VEHICLES WERE MISSING TAMPERPROOF CAPS THAT PREVENT HORIZONTAL HEADLAMP ADJUSTMENT.

Nov 16, 2001 – VEHICLE DESCRIPTION: PASSENGER VEHICLES EQUIPPED WITH A 1.8 LITER ENGINE. THE ENGINE COULD STOP RUNNING WHILE BEING DRIVEN DUE TO A DEFECTIVE CRANK POSITION SENSOR. THIS COULD ALSO RESULT IN THE "SERVICE ENGINE SOON" WARNING LIGHT COMING ON OR REDUCED ENGINE POWER.

Aug 29, 2001 – VEHICLE DESCRIPTION: PASSENGER VEHICLES. THE COOLING HOLES IN THE STEEL WHEEL MAY HAVE BURRS ON THEIR EDGES AS A RESULT OF IMPROPER MANUFACTURING. THESE BURRS CAN CAUSE CRACKS AS THE VEHICLE IS BEING DRIVEN. CRACKS CAN PROPAGATE BETWEEN ADJACENT COOLING HOLES. IF ENOUGH CRACKS DEVELOP BETWEEN THE COOLING HOLES, THE WHEEL COULD FAIL AND SEPARATE FROM THE MOUNTING HUB WITHOUT PRIOR WARNING.

May 23, 2001 – VEHICLE DESCRIPTION: PASSENGER VEHICLES. ONE OR MORE OF THE THREE BOLTS USED TO ATTACH EACH FRONT SUSPENSION LOWER CONTROL ARM TO THE BODY ON THE LEFT AND RIGHT SIDES MAY NOT HAVE BEEN PROPERLY MANUFACTURED.

Mar 02, 2000 – VEHICLE DESCRIPTION: PASSENGER VEHICLES. THE FRONT COIL SPRINGS MAY NOT HAVE SUFFICIENT CORROSION RESISTANCE IN AREAS OF THE COUNTRY WHERE SIGNIFICANT AMOUNTS OF DE-ICING SALTS ARE APPLIED TO ROADS IN THE WINTER.

May 05, 1998 – VEHICLE DESCRIPTION: PASSENGER VEHICLES. WATER CAN ENTER AND DISPLACE THE GREASE IN THE WIPER ARM LINKAGE BALL JOINT WHERE THE WIPER LINKAGE ATTACHES TO THE WIPER MOTOR LINKAGE.

Jan 21, 1998 – THESE VEHICLES DO NOT MEET THE ILLUMINATION REQUIREMENTS OF FMVSS NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT."

Jul 22, 1997 – VEHICLE DESCRIPTION: PASSENGER VEHICLES. ONE OF THREE STYROFOAM PADS LOCATED IN EACH REAR DOOR AS PART OF THE DESIGN FOR ENSURING COMPLIANCE WITH FMVSS NO. 214, "SIDE DOOR STRENGTH," WAS NOT INSTALLED.

May 24, 1995 – THE FRONT SAFETY BELT BUCKLE RELEASE BUTTONS CAN BREAK. THESE RED PLASTIC RELEASE BUTTONS ARE MARKED "PRESS." IF A BUTTON BREAKS, PIECES CAN FALL INTO THE BUCKLE ASSEMBLY CAUSING THE BUCKLE TO OPERATE IMPROPERLY.

Mar 01, 1995 – THE ANTI-LOCK BRAKING SYSTEM (ABS) HYDRAULIC ACTUATOR WAS NOT PROPERLY PURGED OF ALL AIR DURING THE FILL AND EVACUATION PROCESS CAUSING AIR BUBBLES TO GET INTO THE BRAKE SYSTEM.