SUZUKI Recalls

Dec 19, 2011 – SUZUKI IS RECALLING CERTAIN MODEL YEAR 2011-2012 EQUATOR PICKUP TRUCKS MANUFACTURED FROM JUNE 16, 2011, THROUGH AUGUST 31, 2011. SOME OF THE BOLTS THAT CONNECT THE ENGINE OIL COOLER AND THE ENGINE OIL FILTER TO THE ENGINE IN THESE VEHICLES MAY HAVE BEEN MANUFACTURED TO BELOW SPECIFICATION STRENGTH. AS A RESULT, THE BOLT MAY BREAK AT THE OIL FILTER ATTACHMENT POINT AND CAN CAUSE AN ENGINE OIL LEAK.

Feb 23, 2011 – SUZUKI IS RECALLING CERTAIN MODEL YEAR 2008 THROUGH 2010 MOTORCYCLES MANUFACTURED FROM JULY 2007 THROUGH SEPTEMBER 2009, EQUIPPED WITH REGULATOR/RECTIFIER ASSEMBLIES, SUZUKI PART NUMBERS 32800-41F11, 32800-15H10, 32800-05H11, 32800-41G10, 32800-15H00, 32800-18H00, 32800-05G10, 32800-10G10, 32800-05H20, OR 32800-06G01. SOME REGULATOR/RECTIFIER ASSEMBLIES WERE PRODUCED WITH INSUFFICIENT ADHESION BETWEEN THE POWER MODULE (CIRCUIT BOARD) AND THE RECTIFIER CASE THAT CONTAINS A HEAT SINK TO DISSIPATE HEAT. DUE TO INSUFFICIENT ADHESION, HEAT GENERATED ON THE POWER MODULE CIRCUIT BOARD CAN CAUSE THE CIRCUIT BOARD TO DEFORM, AND LIFT OF THE CASE.

Jan 27, 2011 – SUZUKI IS RECALLING CERTAIN MODEL YEAR 2009-2010 SUZUKI GRAND VITARA MULTIPURPOSE PASSENGER VEHICLES EQUIPPED WITH 4-CYLINDER ENGINES; MODEL YEAR 2011 SUZUKI GRAND VITARA MULTIPURPOSE PASSENGER VEHICLES PRODUCED PRIOR TO OCTOBER 17, 2010; MODEL YEAR 2010 SUZUKI SX4 PASSENGER VEHICLES; AND 2011 SUZUKI SX4 PASSENGER VEHICLES PRODUCED PRIOR TO OCTOBER 14, 2010. THE TENSION ADJUSTER PULLEY FOR THE DRIVE BELT THAT OPERATES THE ALTERNATOR, WATER PUMP, AIR CONDITIONER COMPRESSOR AND POWER STEERING PUMP, HAS AN IMPROPERLY MANUFACTURED INTERNAL SPRING THAT CAN BREAK DUE TO REPEATED STRESS. IF THE SPRING BREAKS, THE DRIVE BELT WILL NOT BE ADJUSTED PROPERLY AND CAN SLIP, CAUSING A SQUEAKING NOISE. OR THE DRIVE BELT COULD COME OFF CAUSING THE DRIVER TO INCREASE TO STEER THE VEHICLE. THIS CAN ALSO CAUSE THE COOLANT TEMPERATURE INDICATION TO RISE, WHICH CAN LEAD TO THE ENGINE OVERHEATING, OR CAN CAUSE THE CHARGING LIGHT TO COME ON, WHICH CAN LEAD TO BATTERY DISCHARGE AND ENGINE STALL.

Oct 19, 2010 – SUZUKI IS RECALLING CERTAIN MODEL YEAR 2007 SX4 HATCHBACK AND MODEL YEAR 2008-2010 SX4 HATCHBACK AND SEDAN PASSENGER VEHICLES. THE THREE SCREWS THAT SECURE EACH OF THE OUTSIDE REAR VIEW MIRRORS TO THE MIRROR BASE CAN COME LOOSE DUE TO VIBRATION.

Sep 01, 2010 – SUZUKI IS RECALLING CERTAIN MODEL YEAR 2008 THROUGH 2010 SX4, 2010 GRAND VITARA, AND 2009 THROUGH 2010 EQUATOR VEHICLES THAT WERE EQUIPPED WITH A GARMIN NUVI MODEL 750, 760, AND 765 NAVIGATION SYSTEM. THE BATTERIES CONTAINED IN THE AFFECTED GPS UNITS CAN OVERHEAT.

Jun 28, 2010 – SUZUKI IS RECALLING CERTAIN MODEL YEAR 2010 KIZASHI PASSENGER VEHICLES MANUFACTURED FROM OCTOBER 13, 2009 THROUGH MAY 31, 2010. THE HINGED DOOR OF THE CENTER LOWER BOX LOCATED IN THE FRONT DASHBOARD AREA FAILS TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 201, "OCCUPANT PROTECTION IN INTERIOR IMPACT."

Jun 09, 2010 – SUZUKI IS RECALLING CERTAIN MODEL YEAR MODEL YEAR 2006 GRAND VITARA AND MODEL YEAR 2005-2006 XL-7 VEHICLES. THE TENSION ADJUSTER PULLEY FOR THE DRIVE BELT THAT OPERATES THE POWER STEERING PUMP AND AIR CONDITIONER COMPRESSOR (IF EQUIPPED) HAS AN OUTER PORTION THAT IS MADE OF PLASTIC. REPEATED HEAT STRESS CAN CAUSE THE PLASTIC MATERIAL TO DETERIORATE AND PIECES OF THE PULLEY CAN BREAK OFF.

May 19, 2010 – SUZUKI IS RECALLING CERTAIN MODEL YEAR 2010 EQUATOR PICKUP TRUCKS MANUFACTURED FROM NOVEMBER 20, 2009 THROUGH MARCH 3, 2010. THE LOWER CONTROL LINK BUSHING COLLARS, LOCATED IN THE FRONT SUSPENSION, MAY CONTAIN WELDS THAT DO NOT MEET STRENGTH SPECIFICATIONS. IF A COLLAR WELD SEPARATES, IT MAY CHANGE THE WHEEL ALIGNMENT, POTENTIALLY ALLOWING THE VEHICLE HANDLING CHARACTERISTICS TO DETERIORATE.

Mar 25, 2010 – SUZUKI HAS NOTIFIED NHTSA OF A DEFECT IN CERTAIN MODEL YEAR 2010 EQUATOR TRUCKS MANUFACTURED FROM FEBRUARY 22, 2010 TO MARCH 13, 2010. THE FASTENERS SECURING THE PASSENGER FRONT AIR BAG MODULE, AND ALSO THE FASTENERS SECURING THE STEERING SHAFT POSITIONING BRACKET MAY NOT HAVE BEEN TIGHTENED TO THE PROPER TORQUE SPECIFICATION.

Apr 07, 2009 – SABERSPORT IS RECALLING 16,270 COMBINATION CORNER AND BUMPER LAMP ASSEMBLIES OF VARIOUS PART NUMBERS SOLD FOR USE AS AFTERMARKET EQUIPMENT FOR VARIOUS PASSENGER VEHICLES. THESE HEADLAMPS FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT." THESE LAMPS DO NOT CONTAIN THE REQUIRED AMBER SIDE REFLECTORS.