SUZUKI Recalls

Jan 16, 2009 – AMERICAN SUZUKI (SUZUKI) IS CONDUCTING A SAFETY IMPROVEMENT CAMPAIGN INVOLVING 26,082 MY 2005-2006 GSX-R1000 MOTORCYCLES. CRACKING OR BREAKAGE OF THE MOTORCYCLE FRAME CAN OCCUR IN CERTAIN EXTREME SITUATIONS WHERE UNUSUALLY HIGH STRESS IS PLACED ON THE FRAME. REPEATED HARD LANDINGS FROM HAZARDOUS MANEUVERS SUCH AS EXTREME OR EXTENDED WHEELIES OR OTHER STUNTS MAY GENERATE SUFFICIENT STRESS TO CAUSE THIS PROBLEM.

Aug 15, 2008 – MOTION PRO IS RECALLING 10,000 AFTERMARKET BRAKE LEVERS, MODEL NO. 14-0415, SOLD FOR USE ON CERTAIN MY 1999 THROUGH 2008 SUZUKI AND MY 1998 THROUGH 2003 YAMAHA MOTORCYCLES. THE LOBE HEIGHT ON SOME OF THESE LEVERS ARE SMALLER AND DO NOT PROPERLY ENGAGE THE STOMP LAMP SWITCH WHICH WILL NOT DEACTIVATE WHEN THE DRIVER RELEASES THE BRAKE LEVER. THE LEVER CAN BE IDENTIFIED BY THE MARKING "JY 378" AT THE BASE OF THE LEVER NEAR THE PIVOT BUSHING.

Jun 03, 2008 – AMERICAN SUZUKI IS RECALLING 9,109 MY 2008 GSX1300R MOTORCYCLES. IMPROPER ROUTING OF THE IGNITION SWITCH WIRING HARNESS CAN CAUSE A BENT PORTION OF THE WIRING HARNESS TO FLEX RATHER THAN SLIDE WHEN THE HANDLEBAR IS MOVED FROM RIGHT TO LEFT OR LEFT TO RIGHT. REPEATED SIDE-TO-SIDE MOVEMENT OF THE HANDLEBAR, AND FLEXING OF THE BENT PORTION WIRING HARNESS, CAN EVENTUALLY CAUSE THE IGNITION SWITCH LEAD WIRES TO BECOME CUT OR BROKEN.

Dec 07, 2007 – CERTAIN VEHICLES EQUIPPED WITH AUTOMATIC TRANSMISSIONS FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 114, 'THEFT PROTECTION. ' THE AUTOMATIC TRANSMISSION SELECTOR LEVER "PARK" LOCK FUNCTION MAY BE INOPERATIVE DUE TO A STICKING SHIFT LOCK ARM. THE SHIFT LEVER MAY BE ABLE TO BE SHIFTED OUT OF "PARK" WITH THE KEY REMOVED AND WITHOUT DEPRESSING THE BRAKE PEDAL.

Nov 05, 2007 – THE REAR REFLEX REFLECTOR ON AFFECTED GS500 MOTORCYCLES AND THE REAR AND SIDE REFLEX REFLECTORS ON AFFECTED GZ250 MOTORCYCLES FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, 'LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT.' THE REFLEX REFLECTORS HAVE A REFLECTED LIGHT OUTPUT AT SOME MEASUREMENT ANGLES THAT IS LESS THAN THE MINIMUM OUTPUT REQUIRED BY THE STANDARD.

Sep 25, 2007 – ON CERTAIN PASSENGER VEHICLES, HEADLAMP LOW BEAM OR DAYTIME RUNNING LIGHT (DRL) FUNCTION MAY BE INOPERATIVE DUE TO A MELTED SPLICE PACK ON THE WIRING HARNESS.

Aug 15, 2007 – ON CERTAIN MOTORCYCLES, EACH TIME THE IGNITION SWITCH IS TURNED OFF, THE ENGINE CONTROL MODULE (ECM) PRE-SETS THE POSITION OF THE IDLE SPEED CONTROL (ISC) VALVE FOR SUBSEQUENT ENGINE STARTING BY OPENING THE VALVE COMPLETELY AND THEN CLOSING IT TO A START-UP POSITION.

Jul 24, 2007 – ON CERTAIN PASSENGER VEHICLES, THE FRONT SEAT BELT TONGUE WILL NOT LATCH INTO THE BUCKLE AND, IN RARE CASES, EVEN THE LOCKED TONGUE WILL POP OUT BY LOW STRETCHING FORCE. IF THE BUCKLE DOES NOT LATCH COMPLETELY, THE BUCKLE COULD RELEASE WITHOUT PRESSING THE RELEASE BUTTON.

Jul 15, 2007 – ON CERTAIN VEHICLES EQUIPPED WITH 5-SPEED MANUAL TRANSMISSIONS, DUE TO IMPROPER SHAPE OF THE CLIP, THE RETAINING CLIP THAT KEEPS THE GEAR SHIFT CABLE ATTACHED TO THE GEAR SHIFT LEVER CAN CONTACT THE GEAR SHIFT LEVER HOUSING IF EXCESSIVE LATERAL FORCE IS APPLIED WHEN SHIFTING TO FIRST GEAR.

Jun 14, 2007 – CERTAIN VEHICLES FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 212, "WINDSHIELD MOUNTING." AN INCORRECT PRIMER MAY HAVE BEEN USED WHEN INSTALLING THE WINDSHIELD.