MITSUBISHI IS RECALLING 39,711 MY 2008-2009 OUTLANDER AND LACER VEHICLES

Mar 10, 2009 — Recall Campaign #09V077000

MITSUBISHI IS RECALLING 39,711 MY 2008-2009 OUTLANDER AND LACER VEHICLES. INCORRECT MATERIAL COMPOSITION OF THE BRAKE BOOSTER CHECK VALVE MAY CAUSE THE CHECK VALVE TO STICK CLOSED WHEN THE ENGINE IS SHUT OFF. WHEN THE VEHICLE IS RE-STARTED AND PUT INTO MOTION, UNDER CERTAIN DRIVING CONDITIONS (VERY SLOW VEHICLE MANEUVERS), THERE MAY BE INSUFFICIENT INITIAL BRAKING ASSIST.

The recall was influenced by the manufacturer with about 39,711 units affected.

See recall notice

NHTSA Safety Recall Notice

09V077000

Manufacturer:	Mitsubishi Motors North America, Inc.
Recall date:	March 10, 2009
NHTSA Campaign #:	09V077000
Units affected:	39,711

Description:: MITSUBISHI IS RECALLING 39,711 MY 2008-2009 OUTLANDER AND LACER VEHICLES. INCORRECT MATERIAL COMPOSITION OF THE BRAKE BOOSTER CHECK VALVE MAY CAUSE THE CHECK VALVE TO STICK CLOSED WHEN THE ENGINE IS SHUT OFF. WHEN THE VEHICLE IS RE-STARTED AND PUT INTO MOTION, UNDER CERTAIN DRIVING CONDITIONS (VERY SLOW VEHICLE MANEUVERS), THERE MAY BE INSUFFICIENT INITIAL BRAKING ASSIST.
Consequeces:: THIS MAY TEMPORARILY INCREASE THE STOPPING DISTANCE OF THE VEHICLE AND THEREFORE INCREASE THE RISK OF A CRASH.
Corrective action:: DEALERS WILL REPLACE THE BRAKE BOOSTER CHECK VALVE FREE OF CHARGE. THE RECALL IS EXPECTED TO BEGIN DURING APRIL 2009. OWNERS MAY CONTACT MITSUBISHI AT 1-800-222-0037.
Notes:: MITSUBISHI RECALL NO. SR-09-002.OWNERS MAY ALSO CONTACT THE NATIONAL HIGHWAY TRAFFIC SAFETY ADMINISTRATION'S VEHICLE SAFETY HOTLINE AT 1-888-327-4236 (TTY 1-800-424-9153), OR GO TO HTTP://WWW.SAFERCAR.GOV .

Affects the following:

2009 MITSUBISHI LANCER Complaints
I was driving down the road and spun out of control because my rack and pinion steering inner and outer tie rod snapped in half, because of rust from salt water and corrosion on the metal, resulting in my loss of control and front passenger wheel turned 90 degrees inward and nearly ripped the front tire off and under the car, brought the car home and inspected it tthoroughly, and saw the immediate problem;
2009 MITSUBISHI OUTLANDER Complaints
I was driving home from work and I came upon a red light as I was slowing down the car started jilting as I went to take off I started jilting again but then smoothed out. The check engine light, ABS brake light and speed traction off light came on.They just all popped on. At the next light it did the same thing , it started to shutter and loss of power on taking off. It was sputtery at the same time which could have caused an accident! I finally make it home in about an hour later I had to run out to the store to get a couple things. I put it in reverse and it started to jitter again so I put it in park I checked all the fluids everything was fine Don't know why the lights were on. Again I put it in reverse Go to pull out of my driveway it starts to jitter. I put it in drive very slow getting up to movement. I slowed to stop at a light and it stalls out right in the middle of the intersection I try to start it back up , it does but now it just will not go anywhere!! there was no warning no loud bangs, pops, or squeals, no loud anything it just stopped. It will engage in each gear but refuses to go anywhere. it feels like it wants to go but it's just not going. This is very dangerous I could have gotten in a serious accident being in the middle of the intersection like that. this problem needs to be fixed upon looking on many forums and internet sites this seems to be a very common issue with the CVT or the 2009 or any outlander for that matter. My car was made in Japan I guess because the VIN starts with J I'm not sure of how to get any recalls from there or if that matters. I'm not sure the history on my vehicle neither or where it was registered last. I wish I knew when and where the repairs have been done for the recalls that my vehicle may have had. My car is doing exactly what the recalls were for; MMNS's number SR-15-002 in June 15th 2015 and also mmna's number SR-18-001 I did change both CVT filters and fluid also the oil and oil filter. Still nothing.;