Ford Motor Company is recalling certain 2024-2025 F-150

Mar 14, 2025 — Recall Campaign #25V164000

Ford Motor Company (Ford) is recalling certain 2024-2025 F-150, Bronco, 2024 Ranger, 2025 Mustang, Explorer, and Aviator vehicles. The transmission valve body may have been machined incorrectly, which can cause reverse gear failure, or unexpected forward movement in reverse or neutral gear.

The recall was influenced by the manufacturer with about 269 units affected.

See recall notice

NHTSA Safety Recall Notice

25V164000

Manufacturer:	Ford Motor Company
Recall date:	March 14, 2025
NHTSA Campaign #:	25V164000
Units affected:	269

Description:: Ford Motor Company (Ford) is recalling certain 2024-2025 F-150, Bronco, 2024 Ranger, 2025 Mustang, Explorer, and Aviator vehicles. The transmission valve body may have been machined incorrectly, which can cause reverse gear failure, or unexpected forward movement in reverse or neutral gear.
Consequeces:: Unexpected vehicle movement increases the risk of a crash.
Corrective action:: Dealers will replace the transmission main control valve body, free of charge. Owner notification letters were mailed April 11, 2025. Owners may contact Ford customer service at 1-866-436-7332. Ford's number for this recall is 25S19.
Notes:: Owners may also contact the National Highway Traffic Safety Administration Vehicle Safety Hotline at 888-327-4236 (TTY 888-275-9171) or go to nhtsa.gov.

Affects the following:

2024 FORD RANGER Complaints
vehicle has a reoccurring no throttle response issue on turns only, not in a traction/stability loss scenario. not during any abnormal body roll scenario's . has happened many times with no related codes present. the vehicle now has 13k miles but first started around 2k miles. the issues typically happens when driving at normal speeds, if the throttle is let off then throttle is depressed again there is no throttle response and the vehicle will not accelerate ranging from 2 seconds up to 10 seconds on one instance, before it figures out what gear it should be in and then acceleration is back to normal. sometimes when power is returned, the transmission will slam into gear. during these occurrence's , the engine does not shut off and there are no loss to other functions besides a dead pedal. I am considering this a major safety issue being that once of these occurrences was making a left turn on a green arrow, when i was slowing down for the light, light turned to a green arrow and had a lot of time to safely make the turn before the on coming car in heading the opposite direction, except the throttle did not respond at all and was left coasting through the turn with the oncoming car getting dangerously close. a large risk for a accident is present in a lot of scenarios. the vehicle has been inspected with no issues found and cannot duplicate at the time being that the issue is very inconsistent and may happen twice in 2 weeks, or once in 5 months, each time no codes present in vehicle modules.;
2025 FORD BRONCO SPORT Complaints
Both front lower control arm ball joints on my 2025 Bronco Sport failed prematurely at approximately 13,000 miles. Upon removal, both ball studs showed heavy corrosion and clear evidence of water intrusion past the factory boot seals. One boot's upper metal retainer was visibly deformed, allowing water into the joint. This level of corrosion should not exist on a vehicle this new and indicates a defective component or seal, not normal wear. I have retained both failed parts and have photographs documenting the condition. This is the same component covered under Ford's active do-not-drive safety recall 26S36 (NHTSA campaign 26V-340) for front lower control arm ball joint defects on 2021–2026 Bronco Sport vehicles. My VIN is not included in that campaign, but I experienced failure of the identical safety-critical component. I am reporting this so NHTSA is aware the defect may extend beyond the current recall population. When I brought the vehicle to my local Ford dealer and requested inspection under the new vehicle warranty, the service department refused to inspect the vehicle at all, citing a 1.5-inch aftermarket leveling kit. No inspection was performed and no determination was made that the modification caused or contributed to the failure. A leveling kit does not cause water intrusion past a factory boot seal. Because the dealer refused service on a safety-critical component, I replaced both ball joints at my own expense to keep the vehicle safe to drive. I have opened a case with Ford Customer Relationship Center (case CXH-09202228-R9R8V5). No crash or injury occurred, but ball joint separation causes loss of steering control, and I believe this failure mode warrants investigation of vehicles outside the current recall scope.;
2025 FORD EXPLORER Complaints
The contact owns a 2025 Ford Explorer. The contact received notification of NHTSA Campaign Number: 26V122000 (Engine and Engine Cooling). The contact scheduled an appointment at the local dealer after being notified of the recall. The dealer initially stated that the part would be available within a week, but the contact was subsequently informed that the part was on backorder and there was no estimated date when the part would be available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The contact had not experienced a failure.;
2025 FORD F-150 HYBRID Complaints
Vehicle: 2025 Ford F-150 (VIN and mileage available upon request) Component: Rearview/backup camera display, Accessory Protocol Interface Module (APIM) / SYNC infotainment system (Sync 4 version 25211 revision 1966-same CCPU ver./VMCU version:6.1.42.2) Summary of Problem: The rearview camera display intermittently shows a distorted, glitched, or corrupted image when the vehicle is shifted into Reverse. The fault is not consistent or reproducible on demand, it occurs unpredictably across different drive cycles, which makes it difficult to document with video or photo evidence at the time it occurs. When the fault is present, the driver does not have a reliable rear-view image, reducing visibility and situational awareness while backing up. I checked my VIN against Ford's and NHTSA's recall databases and found no open recall covering this specific vehicle for this issue. However, Ford has issued multiple prior recalls (including NHTSA 25V315 / Ford 25S49) for related APIM software defects causing rear camera freezing, blanking, or display corruption on other model years and vehicle lines. This suggests the underlying APIM/software issue may not be fully resolved across all affected builds, including 2025 model year trucks not currently covered. Safety Concern: Because the failure is intermittent and unpredictable, the driver cannot anticipate when the rear camera will be unreliable, which itself is a safety hazard distinct from a consistent failure that could at least be planned around. This creates a risk of collision with pedestrians, vehicles, or objects behind the truck during reversing, particularly since the rear camera is often relied on as a primary means of rear visibility. Additional Notes: I am in the process of documenting occurrences and requesting APIM diagnostic logs from Ford/dealer service to establish a pattern, given the intermittent nature of the fault.;
2025 FORD MUSTANG Complaints
The contact owns a 2025 Ford Mustang. The contact received notifications of NHTSA Campaign Numbers: 25V546000 (Exterior Lighting) and 26V418000 (Visibility); however, the parts to do the recall repairs were unavailable. The contact stated the manufacturer had exceeded a reasonable amount of time for the recall repair. The contact stated that several exterior lights randomly illuminated while the vehicle was turned on or off, causing the battery to drain. The parking lights, headlights, and the turn signals were unintendedly illuminated. The vehicle was taken to the dealer, who confirmed that parts for NHTSA Campaign Numbers: 26V418000 (Visibility) were not yet available. The dealer confirmed that there was water intrusion into the module at the front of the vehicle that had caused an electrical short. The dealer stated that the wiring harness needed to be replaced before the vehicle was repaired under NHTSA Campaign Number: 25V546000 (Exterior Lighting). The vehicle was not repaired. The manufacturer was not made aware of the issue. The failure mileage was approximately 2,800.;