Ford Motor Company is recalling certain 2025 Ranger, Lincoln Nautilus

Mar 03, 2026 — Recall Campaign #26V122000

Ford Motor Company (Ford) is recalling certain 2025 Ranger, Lincoln Nautilus, Mustang, Maverick, Explorer, Escape, Lincoln Corsair, Bronco Sport, and Bronco vehicles. The exhaust gas recirculation (EGR) valve may fail, resulting in an unexpected loss of drive power.

The recall was influenced by the manufacturer with about 47,804 units affected.

See recall notice

NHTSA Safety Recall Notice

26V122000

Manufacturer:	Ford Motor Company
Recall date:	March 03, 2026
NHTSA Campaign #:	26V122000
Units affected:	47,804

Description:: Ford Motor Company (Ford) is recalling certain 2025 Ranger, Lincoln Nautilus, Mustang, Maverick, Explorer, Escape, Lincoln Corsair, Bronco Sport, and Bronco vehicles. The exhaust gas recirculation (EGR) valve may fail, resulting in an unexpected loss of drive power.
Consequeces:: An unexpected loss of drive power increases the risk of a crash.
Corrective action:: Dealers will replace the EGR valves, free of charge. Owner notification letters were mailed July 31, 2026. Owners may contact Ford customer service at 1-866-436-7332. Ford's number for this recall is 26S10. Vehicle Identification Numbers (VINs) involved in this recall became searchable on NHTSA.gov on March 4, 2026.

Affects the following:

2025 FORD BRONCO SPORT Complaints
Both front lower control arm ball joints on my 2025 Bronco Sport failed prematurely at approximately 13,000 miles. Upon removal, both ball studs showed heavy corrosion and clear evidence of water intrusion past the factory boot seals. One boot's upper metal retainer was visibly deformed, allowing water into the joint. This level of corrosion should not exist on a vehicle this new and indicates a defective component or seal, not normal wear. I have retained both failed parts and have photographs documenting the condition. This is the same component covered under Ford's active do-not-drive safety recall 26S36 (NHTSA campaign 26V-340) for front lower control arm ball joint defects on 2021–2026 Bronco Sport vehicles. My VIN is not included in that campaign, but I experienced failure of the identical safety-critical component. I am reporting this so NHTSA is aware the defect may extend beyond the current recall population. When I brought the vehicle to my local Ford dealer and requested inspection under the new vehicle warranty, the service department refused to inspect the vehicle at all, citing a 1.5-inch aftermarket leveling kit. No inspection was performed and no determination was made that the modification caused or contributed to the failure. A leveling kit does not cause water intrusion past a factory boot seal. Because the dealer refused service on a safety-critical component, I replaced both ball joints at my own expense to keep the vehicle safe to drive. I have opened a case with Ford Customer Relationship Center (case CXH-09202228-R9R8V5). No crash or injury occurred, but ball joint separation causes loss of steering control, and I believe this failure mode warrants investigation of vehicles outside the current recall scope.;
2025 FORD BRONCO SPORT Complaints
Both front lower control arm ball joints on my 2025 Bronco Sport failed prematurely at approximately 13,000 miles. Upon removal, both ball studs showed heavy corrosion and clear evidence of water intrusion past the factory boot seals. One boot's upper metal retainer was visibly deformed, allowing water into the joint. This level of corrosion should not exist on a vehicle this new and indicates a defective component or seal, not normal wear. I have retained both failed parts and have photographs documenting the condition. This is the same component covered under Ford's active do-not-drive safety recall 26S36 (NHTSA campaign 26V-340) for front lower control arm ball joint defects on 2021–2026 Bronco Sport vehicles. My VIN is not included in that campaign, but I experienced failure of the identical safety-critical component. I am reporting this so NHTSA is aware the defect may extend beyond the current recall population. When I brought the vehicle to my local Ford dealer and requested inspection under the new vehicle warranty, the service department refused to inspect the vehicle at all, citing a 1.5-inch aftermarket leveling kit. No inspection was performed and no determination was made that the modification caused or contributed to the failure. A leveling kit does not cause water intrusion past a factory boot seal. Because the dealer refused service on a safety-critical component, I replaced both ball joints at my own expense to keep the vehicle safe to drive. I have opened a case with Ford Customer Relationship Center (case CXH-09202228-R9R8V5). No crash or injury occurred, but ball joint separation causes loss of steering control, and I believe this failure mode warrants investigation of vehicles outside the current recall scope.;
2025 FORD ESCAPE Complaints
Multiple computer related problems, including sensing objects that do not exist while using automated cruise control. Automatic braking engagement when car senses objects that do not exist both in the front and rear while driving. Rear sensor occupancy alert randomly triggered when it has been turned off, And when there is nobody in the back seat. GPS unable to locate signal even in wide open spaces, randomly drops service. Various climate control components read improperly, or do not display appropriately. Numerous morning messages both before and after incidents. The vehicle has been to Ford dealer, they have been unable to reproduce or determine what caused these faults.;
2025 FORD EXPLORER Complaints
The contact owns a 2025 Ford Explorer. The contact received notification of NHTSA Campaign Number: 26V122000 (Engine and Engine Cooling). The contact scheduled an appointment at the local dealer after being notified of the recall. The dealer initially stated that the part would be available within a week, but the contact was subsequently informed that the part was on backorder and there was no estimated date when the part would be available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The contact had not experienced a failure.;
2025 FORD MAVERICK Complaints
Loud Knocking from engine, CEL illuminated flashing, loss in power and had an active misfire in cyl #2. Upon inspection cyl #2 Spark plug electrode broke off/melted into the cylinder causing a gauge in the cylinder. Vehicle is being dropped off to the dealer for most likely an engine replacement.;