ALTEC Recalls

May 10, 2013 – Altec is recalling certain model year 2010-2011 AC35/38 cranes equipped with 31-55 foot telescopic jibs built between 2010 and 2011. The jib attachment bracket is not sufficient for loads that can occur when the fully extended jib is lifted off the ground.

Apr 11, 2013 – Altec Industries, Inc (Altec) is recalling certain model year 2007-2012 DC, and DL/DM Digger Derrick utility trucks, equipped with boom tip winches using Tulsa Winch Group (formerly Gear Products) winch drums. In the affected vehicles, the winch drum could deform or fracture.

Apr 04, 2013 – Altec is recalling certain model year 2010-2012 AC18, AC23, and AC38 cranes with front bumper outriggers mounted on Kenworth chassis between November 2010 and October 2012. The brackets that attach the outrigger to the front bumper of the chassis may be inadequate to support the full capacity of the crane in certain positions.

Oct 24, 2012 – Altec is recalling certain model year 2011-2012 CFD 1217 wood chippers, manufactured between May 2011 through September 2012. The wood chipper blades were not made to hardness specifications.

Oct 03, 2012 – Altec Industries, Inc. is recalling certain model year 2011-2012 vehicles mounted on a Freightliner chassis. Due to improper installation, the air supply line of the front brakes is susceptible to kinking.

Sep 18, 2012 – Altec Industries, Inc. is recalling certain model year 2002-2009 AH75/85/100 and HL125 aerial device vehicles equipped with 16-foot radial outriggers. An improper torque was applied to the outrigger cylinder piston retention system during assembly. As a result, the cylinder could loosen from the rod allowing the outrigger leg to protrude beyond the confines of the chassis when it is in a stowed position.

Aug 30, 2012 – Altec Industries, Inc. is recalling certain model year 2011-2012 Digger Derrick vehicles equipped with a PENGO digger extension shaft. A defect in the base material at the weld joint may result in a stress fracture through the applied weld of the drive hub to the hex bar material.

Aug 21, 2012 – Altec Industries, Inc. is recalling certain model year 2008-2009 Aerial Device vehicles due to improper welding processes used to manufacture the boom pivot pins. Failure of the pin could cause separation of the boom from the turntable.

Aug 08, 2012 – Altec Industries, Inc. is recalling certain model year 2012 Aerial Device vehicles built on a Navistar Terrastar chassis because the Altec-installed torsion bar increases the ride height of the front suspension, which when the vehicle hits bumps, may cause the vehicle to alter its steering direction.

Aug 03, 2012 – Altec Environmental Products (AEP) is recalling certain model year 2008-2009 DC1217 and DC1317 and model year 2008-2011 DC1317HP wood chippers. Cracks could develop in the wood chipper frame.