AMTRAN FE Recalls

Feb 20, 2003 – ON CERTAIN SCHOOL BUS WARNING LAMPS, A STATIC ELECTRICITY DISCHARGE CAN OCCUR DURING NORMAL SERVICES OR HANDLING. THIS DISCHARGE CAN POTENTIALLY INITIATE A CHEMICAL REACTION OF MATERIALS WITHIN THE LAMP WHICH COULD CAUSE THE LENS TO FRACTURE.

Dec 30, 2002 – ON CERTAIN BUSES EQUIPPED WITH HYDRAULIC BRAKES, THE MASTER CYLINDER WAS DAMAGED DURING THE FILL AND BLEED PROCEDURE.

Nov 20, 2001 – VEHICLE DESCRIPTION: CERTAIN BUSES WERE BUILT WITH A WIRING DIAGRAM DECAL THAT SHOWS THE CIRCUIT PROTECTION SIZE OF 30 AMPERES INSTEAD OF 20 AMPERES FOR THE HEATER SUPPLY CIRCUITS.

Nov 20, 2001 – VEHICLE DESCRIPTION: CERTAIN SCHOOL AND TRANSIT BUSES WERE BUILT WITH A POOR QUALITY HEATER/DEFROSTER BLOWER SWITCH. IN SOME CASES THIS HAS CAUSED THE MELTING OF THE HEATER HARNESS CONNECTOR AT THE SWITCH TERMINALS OR THE HIGH-SPEED WIRE INSULATION AT THE CONNECTOR. ALSO, SOME OF THE UNITS HAD IMPROPER CIRCUIT PROTECTION SIZE INSTALLED IN THE HEATER DEFROSTER CIRCUIT.

Nov 15, 2001 – VEHICLE DESCRIPTION: CERTAIN BUSES WERE BUILT WITH AN IMPROPER CONNECTION OF THE HEATER HARNESS FROM THE HEATER SWITCH TO THE CONNECTOR JUST OUTSIDE THE HEATER UNIT. THE ASSEMBLY LEFT A LOOSE HOT WIRE IN THE HEATER HARNESS WITH AN UNPROTECTED TERMINAL THAT COULD CAUSE A DIRECT SHORT. THIS WIRE IS PROTECTED WITH A 20-AMPERE CIRCUIT PROTECTION, BUT IN A RARE CASE COULD CAUSE A FIRE.

Aug 26, 2001 – VEHICLE DESCRIPTION: SCHOOL AND TRANSIT BUSES EQUIPPED WITH 39-INCH FLIP SEATS. THE FLIP SEATS COULD BIND IN THE OCCUPIED POSITION AND NOT RETURN TO THE STORED POSITION WHEN NOT OCCUPIED. THE CUSHION FRAME SUPPORT BAR SLIDES OFF THE SEAT SUPPORT PAD, WHICH COULD RETAIN THE SEAT IN THE OCCUPIED POSITION.

Apr 26, 2001 – VEHICLE DESCRIPTION: SCHOOL BUSES EQUIPPED WITH ROSCO CROSS OVER MIRRORS. THE POSITION OF THE DRIVER'S REAR VIEW MIRROR DOES NOT ALLOW COMPLETE VISIBILITY OF PEDESTRIANS AS REQUIRED UNDER FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 111, "REARVIEW MIRRORS."

Feb 23, 2001 – VEHICLE DESCRIPTION: SCHOOL AND TRANSIT BUSES. SOME CERTIFICATION LABELS DISPLAYED THE INCORRECT TIRE PRESSURE FOR THE TIRE SPECIFIED TO MEET THE GROSS AXLE WEIGHT RATING FOR THE FRONT AND/OR REAR AXLES. THIS DOES NOT MEET THE CERTAIN REQUIREMENTS OF FMVSS NO. 120, "TIRE SELECTION AND RIMS FOR MOTOR VEHICLES OTHER THAN PASSENGER CARS," AND 49 CFR PART 567, "CERTIFICATION."

Aug 21, 2000 – VEHICLE DESCRIPTION: SCHOOL BUSES BUILT WITH BENDIX AIR ABS WITH AN EC-17 1030R ELECTRONIC CONTROL UNIT (ECU). THERE HAVE BEEN REPORTS OF UNWANTED ABS ACTIVATION AT LOW SPEEDS CAUSED BY 1) CHAFED ABS WHEEL SPEED SENSOR WIRES ON ROTATING PARTS OR 2) A DAMAGED COMPONENT AT THE WHEEL END THAT GENERATES A CERTAIN TYPE OF ERRATIC SENSOR SIGNAL.

Aug 02, 2000 – VEHICLE DESCRIPTION: SCHOOL BUSES. THESE VEHICLES FAIL TO COMPLY WITH THE REQUIREMENTS OF FMVSS 565, "VEHICLE IDENTIFICATION NUMBER REQUIREMENTS." THE VEHICLES HAVE THE WRONG MODEL YEAR CODE IN THE VEHICLE IDENTIFICATION NUMBER (VIN).