CHEVROLET S10 Recalls

Apr 28, 2003 – ON CERTAIN MINIVANS, PICKUP TRUCKS, AND SPORT UTILITY VEHICLES WITH CERTAIN MODEL-ENGINE COMBINATIONS, THE WINDSHIELD WIPER MOTOR MAY FAIL DUE TO CRACKED SOLDER JOINTS ON THE CONTROLLER CIRCUIT BOARD. THE WINDSHIELD WIPERS COULD WORK INTERMITTENTLY OR NOT AT ALL.

Nov 13, 2000 – VEHICLE DESCRIPTION: ELECTRIC PASSENGER VEHICLES AND PICKUP TRUCKS CONTAINING A NICKEL METAL HYDRIDE (NIMH) BATTERY PACK. THESE VEHICLES CONTAIN SOFTWARE WITHIN THE BATTERY PACK MODULE INTENDED TO DISABLE THE VEHICLE FROM BEING DRIVEN IF THE ELECTRICAL RESISTANCE WITH THE BATTERY PACK EXCEEDS A PRESCRIBED VALUE. AFFECTED VEHICLES WILL ILLUMINATE THE "SERVICE NOW" AND "REDUCED PERFORMANCE" TELLTALES AND CONTINUE TO FUNCTION IN A REDUCED PERFORMANCE MODEL INSTEAD OF BEING DISABLED.

Sep 08, 2000 – VEHICLE DESCRIPTION: LIGHT DUTY PICKUP TRUCKS AND SPORT UTILITY VEHICLES. SOME OF THESE VEHICLES WERE BUILT WITH INCORRECT PAYLOAD INFORMATION ON THE VEHICLE CERTIFICATION LABEL. THE PAYLOAD SHOWN ON THE LABEL IS GREATER THAN THE MAXIMUM VALIDATED PAYLOAD. IF THE VEHICLE WERE LOADED TO THE INCORRECTLY LABELED PAYLOAD, IT MAY NOT RIDE AND HANDLE IN THE MANNER THAT THE DRIVER EXPECTS.

Aug 11, 2000 – VEHICLE DESCRIPTION: LIGHT DUTY PICKUP TRUCKS AND SPORT UTILITY VEHICLES. THESE VEHICLES FAIL TO COMPLY WITH THE REQUIREMENTS OF FMVSS NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT." THE DAYTIME RUNNING LIGHTS BUILT WITH A CANDELA VALUE GREATER THAN 3,000 CANNOT BE MOUNTED HIGHER THAN 864MM ABOVE THE ROAD SURFACE.

Aug 07, 2000 – VEHICLE DESCRIPTION: PASSENGER VEHICLES, LIGHT DUTY TRUCKS, SPORT UTILITY VEHICLES, AND MINI VANS EQUIPPED WITH TRW SEAT BELT BUCKLE ASSEMBLIES. THE BUCKLE BASE OF THESE SEAT BELT ASSEMBLIES WERE NOT PROPERLY HEAT TREATED AND THEREFORE DO NOT PASS THE LOAD BEARING REQUIREMENT OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 209, "SEAT BELT ASSEMBLIES."

Jun 16, 2000 – VEHICLE DESCRIPTION: ELECTRIC PICKUP TRUCKS. A CONDITION IN WHICH THE FUEL-FIRED HEATER FILL PIPE GROUND STRAP CONTACTS THE REAR PASSENGER SIDE BRAKE PIPE.

Mar 03, 2000 – VEHICLE DESCRIPTION: GENERATION 1 ELECTRIC LIGHT DUTY PICKUP TRUCKS. THESE VEHICLES WERE BUILT WITH A CHARGE PORT ASSEMBLY THAT COULD FAIL DURING A CHARGING EVENT.

Feb 28, 2000 – VEHICLE DESCRIPTION: LIGHT DUTY PICKUP TRUCKS EQUIPPED WITH 4-WHEEL DISC BRAKES. SOME OF THESE VEHICLES HAVE AN ANTILOCK BRAKE SYSTEM (ABS) MOTOR CONTAINING AN OUT-OF-SPECIFICATION SPRING CLIP. THIS CLIP COULD ALLOW THE MOTOR BEARING TO BECOME MISALIGNED. IF MISALIGNMENT OCCURS, EVENTUALLY THE ABS WOULD BE NON-FUNCTIONAL.

Aug 11, 1999 – VEHICLE DESCRIPTION: S -TRUCKS EQUIPPED WITH 2 WHEEL DRIVE. THESE VEHICLES MAY HAVE HAD THE RIGHT-HAND ANTILOCK BRAKE SYSTEM (ABS) MODULE FEED PIPE AND/OR BRAKE CROSSOVER PIPE TUBE NUTS TIGHTENED WITHOUT SEATING THE PIPE-FLARED-ENDS ENOUGH TO WITHSTAND NORMAL ASSEMBLY AND VEHICLE INPUTS WITHOUT PARTIALLY UNSEATING. THIS DOES NOT COMPLY WITH REQUIREMENTS OF FMVSS NO. 105, "HYDRAULIC SERVICE BRAKE NORMAL, EMERGENCY, AND PARK BRAKING PERFORMANCE."

Jul 19, 1999 – THIS IS NOT A SAFETY RECALL IN ACCORDANCE WITH THE SAFETY ACT. HOWEVER, IT IS DEEMED A SAFETY IMPROVEMENT CAMPAIGN BY THE AGENCY. VEHICLE DESCRIPTION: CERTAIN LIGHT DUTY PICKUP TRUCKS, SPORT UTILITY VEHICLES, OR MINIVANS EQUIPPED WITH 3-SENSOR ABS (ANTILOCK BRAKING SYSTEM) EBC4 UNITS.