FORD F-650 SD Recalls

Dec 15, 2009 – FORD IS RECALLING MODEL YEARS 2009 F-650 AND F-750 TRUCKS. THE CHASSIS WIRE HARNESS MAY HAVE BEEN ASSEMBLED WITHOUT A CONNECTOR SEAL IF THIS SEAL IS MISSING, THE CONNECTOR TERMINALS MAY CORRODE AFFECTING THE PROPER ILLUMINATION OF THE VEHICLE'S REAR BRAKE LAMPS, TAIL LAMPS, TURN SIGNAL LAMPS OR TRAILER LAMPS (IF EQUIPPED.) ALSO, THE FUNCTION OF THE ANTI-LOCK BRAKE SYSTEM MAY BE AFFECTED.

Nov 19, 2009 – CUES, INC. IS RECALLING CERTAIN MODEL YEAR 2007-2009 SERVICE VEHICLES BUILT ON VARIOUS CHASSIS EQUIPPED WITH CARRIER AIRV CEILING UNITS, MODEL NOS. 68RV0010BA, 68RV0012CA, AND 68RV0010EA. THE HEATER ELEMENT IN THESE ASSEMBLIES MAY BE DEFECTIVE WHICH COULD CAUSE THE UNIT TO CREATE SMOKE OR SPARKS.

Aug 25, 2008 – FORD IS RECALLING 2,811 MY 2008-2009 F-650 AND F-750 TRUCKS EQUIPPED WITH C7 OR C9 CATERPILLAR DIESEL ENGINES. THE FUEL PUMP OUTLET CHECK PLUG MAY BE CRACKED WHICH COULD CAUSE FUEL TO SPRAY AND LEAK.

Nov 20, 2007 – ON CERTAIN TRUCKS EQUIPPED WITH CATERPILLAR C7 OR C9 DIESEL ENGINES, A FUEL PUMP FAILURE WILL DILUTE THE ENGINE OIL WITH FUEL AND MAY CAUSE THE TURBOCHARGER TO FAIL AND CAUSE LOSS OF THROTTLE CONTROL WITH WARNING.

Jun 05, 2007 – ON CERTAIN TRUCKS BUILT WITH DANA REAR AXLES, THE REAR AXLE MAY HAVE A HOUSING THAT WAS BUILT USING STEEL THAT WAS THINNER THAN SPECIFIED.

Sep 19, 2005 – ON CERTAIN MEDIUM DUTY CHASSIS CAB VEHICLES EQUIPPED WITH HYDRAULIC BRAKES, THE DRIVE LINE PARK BRAKE ANCHOR BOLT MAY BE SUSCEPTIBLE TO FATIGUE LOADING. THE BOLT COULD FRACTURE OVER TIME DUE TO INSUFFICIENT CLAMP LOAD AS A RESULT OF IMPROPER ANCHOR BOLT PLATING.

May 04, 2005 – ON CERTAIN CAB CHASSIS VEHICLES EQUIPPED WITH ACCURIDE ALUMINUM WHEELS, THE WHEELS WERE NOT PROPERLY PRE-STRESSED. THIS ALLOWS CRACKS TO DEVELOP OVER TIME.

Aug 28, 2003 – CERTAIN MEDIUM DUTY CHASSIS CABS FAIL TO COMPLY TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 121, "AIR BRAKE SYSTEMS." THE AIR BRAKE LINES MAY BE MISROUTED BETWEEN THE PRIMARY AND SECONDARY RESERVOIR TANKS OF THE AIR BRAKE SYSTEM.

Aug 05, 2003 – CERTAIN MEDIUM DUTY CHASSIS CABS FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 120, "TIRE SELECTION AND RIMS FOR MOTOR VEHICLES OTHER THAN PASSENGER CARS." THE TIRE PLACARD LABEL AND INCOMPLETE VEHICLE LABEL MAY HAVE INCORRECT METRIC (KPA) TIRE PRESSURE INFORMATION (TIRE INFLATION PRESSURE SHOWN IN ENGLISH UNITS (PSI) IS CORRECT), AND TRANSPOSED TIRE SIZE AND RIM SIZE INFORMATION.