HONDA Recalls

Mar 26, 2008 – HONDA IS RECALLING 38,934 MY 2006-2007 VT600 AND MY 2007-2008 VT750 AND VTX1300 MOTORCYCLES. THE MOTORCYCLES MAY HAVE AN IMPROPERLY MANUFACTURED FUEL CONTROL VALVE DIAPHRAGM AND THE FUEL VALVE MAY DRIP FUEL.

Feb 05, 2008 – HONDA IS RECALLING 2,032 HITCH STYLE BIKE RACKS SOLD AS AFTERMARKET FOR USE ON MY 2003-2007 AND SOME MY 2008 HONDA PILOT, RIDGELINE, AND ACURA MDX VEHICLES. A PINCH BOLT EXISTS BETWEEN THE BIKE ARM BRACKET AND THE UPRIGHT ASSEMBLY OF THE "HITCH" STYLE BICYCLE RACK.

Dec 17, 2007 – CERTAIN MOTORCYCLES HAVE AN IMPROPER WELDED VENT PIPE IN THE BOTTOM OF THE FUEL TANK. DUE TO VIBRATION THE IMPROPERLY WELDED TANKS MAY CRACK AND DRIP FUEL.

Dec 11, 2007 – CERTAIN CURVED TEMPERED REPLACEMENT GLASS MANUFACTURED BY HANGZHOU SAFETY GLASS LTD AND SUPPLIED TO SAFELITE BY AUTO TEMP INC., IDENTIFIED AS DOT-430, AND SOLD FOR USE ON CERTAIN DOMESTIC AND FOREIGN VEHICLES MAY NOT BREAK INTO SMALL PIECES AS EXPECTED OF TEMPERED GLASS AND FAILS TO CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 205, "GLAZING MATERIALS."

Dec 03, 2007 – ON CERTAIN VEHICLES ORIGINALLY SOLD IN OR CURRENTLY REGISTERED IN THE STATES OF CONNECTICUT, DELAWARE, ILLINOIS, INDIANA, IOWA, KENTUCKY, MAINE, MARYLAND, MASSACHUSETTS, MICHIGAN, MINNESOTA, MISSOURI, NEW HAMPSHIRE, NEW JERSEY, NEW YORK, OHIO, PENNSYLVANIA, RHODE ISLAND, VERMONT, VIRGINIA, WEST VIRGINIA , WISCONSIN AND THE DISTRICT OF COLUMBIA. THE WIRE HARNESS FOR THE OCCUPANT DETECTION SYSTEM (ODS) AND THE OCCUPANT POSITION DETECTION SYSTEM (OPDS) IS ROUTED UNDERNEATH THE CARPET ON THE DRIVER'S SIDE FLOORBOARD. IN AREAS WHERE ROAD SALT IS USED, SALT FROM THE SNOW ON THE DRIVER'S SHOES WILL MELT AND MAY PENETRATE THE CARPET AND LEAK INTO THE WIRE HARNESS. IF THE HARNESS IS EXPOSED TO SALT BRINE, CORROSION MAY OCCUR AND THE WIRE MAY BREAK CAUSING THE SRS INDICATOR LIGHT TO ILLUMINATE. A FAILURE OF THE ODS AND OPDS MAY NOT DETECT THE PRESENCE OF A CHILD SEAT OR AN OUT-OF-POSITION PASSENGER AND DEPLOYMENT OF BOTH THE FRONT SEAT PASSENGER'S FRONTAL AND SIDE AIR BAGS WILL NOT BE SUPPRESSED.

Nov 21, 2007 – ON CERTAIN VEHICLES, THE HOLE IN THE SHEETMETAL FRONT BULKHEAD THAT SERVES AS THE BASE AND PIVOT POINT FOR THE HOOD SUPPORT ROD WAS NOT PUNCHED TO SPECIFICATION. THE HOOD SUPPORT ROD MAY FAIL TO HOLD THE HOOD IN POSITION DUE TO INSUFFICIENT STRENGTH.

Nov 01, 2007 – ON CERTAIN COMPRESSED NATURAL GAS (CNG) VEHICLES, IN THE EVENT OF A SEVERE INTERIOR FIRE IN THE AREA OF THE REAR SEAT, THE CNG TANK MAY BE HEATED UNEVENLY, PREVENTING THE PRESSURE RELIEF DEVICE FROM VENTING THE CONTENTS OF THE TANK AS DESIGNED.

Sep 05, 2007 – ON CERTAIN VEHICLES, THE WHEEL SPEED SENSOR HOUSING USES AN O-RING SEAL TO PREVENT LEAKAGE TO OR FROM THE WHEEL BEARING. IF ASSEMBLED IMPROPERLY, THE O-RING MAY NOT SEAL PROPERLY ALLOWING WATER TO ENTER THE WHEEL BEARING AND EVENTUALLY CAUSE DAMAGE TO THE BEARING, ESPECIALLY IN AREAS WHERE USE OF ROAD SALT IS PREVALENT. IF THE DRIVER CONTINUES TO DRIVE WITH THIS CONDITION IT IS POSSIBLE FOR THE WHEEL BEARING TO BECOME LOOSE, WHICH COULD CAUSE THE BEARING TO FAIL.

Sep 05, 2007 – ON CERTAIN SEDAN AND HYBRID (CNG) VEHICLES, DURING ASSEMBLY, THE TELESCOPIC STEERING COLUMN MECHANISM MAY HAVE BEEN OVER-LUBRICATED WITH SILICONE GREASE. OVER TIME, SOME OF THIS EXTRA GREASE MAY DRIP ON THE BRAKE LIGHT SWITCH CAUSING THE SWITCH TO FAIL.

Aug 27, 2007 – CERTAIN FEDERAL-MOGUL AFTERMARKET FUEL PUMPS SOLD UNDER THE BRAND NAMES OF CARTER, ACCUFLOW, NAPA, TRUFLOW, PARTS DEPO, AND PARTS MASTER, SHIPPED BETWEEN AUGUST 2006 AND JULY 2007 FOR USE ON THE VEHICLES LISTED ABOVE. THE FUEL PUMP DIAPHRAGM IN CERTAIN PRODUCTION RUNS MAY HAVE BEEN IMPROPERLY INSTALLED OR INADEQUATELY TESTED WHICH MAY CAUSE THE FUEL PUMP TO LEAK.