INFINITI QX Recalls

Mar 19, 2014 – Nissan North America, Inc. (Nissan) is recalling certain model year 2014 Infiniti QX80 vehicles manufactured December 2, 2013, through January 27, 2014, and equipped with 20 inch wheels. In the affected vehicles, the Certification label incorrectly lists the Gross Axle Weight Rating (GAWR) as 4,497 lb instead of the correct 4,343 lb. As such, the vehicles do not comply with Part 567 "Certification Regulation."

Oct 17, 2013 – Nissan is recalling certain model year 2013-2014 Nissan Pathfinder vehicles manufactured April 18, 2012, through September 20, 2013; model year 2013 Infiniti JX35 vehicles manufactured September 15, 2011, through January 16, 2013; and model year 2014 Infiniti QX60 vehicles manufactured January 17, 2013, through September 20, 2013. In the affected vehicles, during light braking on rough roads, the antilock brake system (ABS) brake pressure output software may lead to an increase in stopping distance.

Feb 24, 2012 – NISSAN IS RECALLING CERTAIN MODEL YEAR 2011-2012 JUKE, INFINITI QX AND INFINITI M VEHICLES. THE FUEL PRESSURE SENSORS MAY NOT HAVE BEEN TIGHTENED TO THE CORRECT SPECIFICATION. AS A RESULT, THE FUEL PRESSURE SENSOR MAY LOOSEN DUE TO HEAT AND VIBRATION CAUSING FUEL TO LEAK.

Apr 20, 2011 – NISSAN IS RECALLING CERTAIN MODEL YEAR 1996-2004 PATHFINDER AND MODEL YEAR 1997-2003 INFINITI QX4 VEHICLES ORIGINALLY SOLD, OR CURRENTLY REGISTERED IN, CONNECTICUT, DELAWARE, IOWA, ILLINOIS, INDIANA, MASSACHUSETTS, MAINE, MARYLAND, MICHIGAN, MINNESOTA, MISSOURI, NEW HAMPSHIRE, NEW JERSEY, NEW YORK, OHIO, PENNSYLVANIA, RHODE ISLAND, VERMONT, WASHINGTON D.C., WEST VIRGINIA AND WISCONSIN. IN AREAS OF THE COUNTRY IN WHICH HEAVY CONCENTRATIONS OF ROAD SALT ARE USED, A MIXTURE OF SNOW/WATER AND SALT MAY ENTER AN ASSEMBLY LOCATION HOLE IN THE UPPER STRUT HOUSING, CAUSING WATER TO COLLECT AT THE MATING SURFACE OF THE STRUT HOUSING PANEL AND THE INNER HOOD LEDGE ASSEMBLY. OVER TIME, THIS SNOW/WATER AND SALT INTRUSION MAY RESULT IN CORROSION OF THE STRUT TOWER HOUSING IN SOME SUBJECT VEHICLES.

Oct 28, 2010 – NISSAN IS RECALLING CERTAIN MODEL YEAR 2004-2006 ARMADA, TITAN, INFINITI QX56 AND MODEL YEAR 2005-2006 FRONTIER, PATHFINDER AND XTERRA VEHICLES. THE INTELLIGENT POWER DISTRIBUTION MODULE (IPDM) ASSEMBLY CONTAINS AN ENGINE CONTROL MODULE (ECM) RELAY THAT HAS A DIODE FOR ELECTRICAL CURRENT NOISE REDUCTION. THE ECM RELAY MAY ALLOW SILICON VAPOR TO FORM AND, OVER TIME, THE SILICON EVAPORATES FROM THE DIODE MOLDING WHICH CAUSES SILICON OXIDE TO DEVELOP ON THE ECM RELAY CONTACT DUE TO ARCING.

Jul 22, 2010 – NISSAN IS RECALLING MODEL YEAR 2008 NISSAN ARMADA AND INFINITI QX56 VEHICLES MANUFACTURED FROM FEBRUARY 7, 2007 THROUGH FEBRUARY 14, 2007. THESE VEHICLES FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 201, "PROTECTION IN INTERIOR IMPACT." AN OUT-OF-SPECIFICATION A-PILLAR FINISHER MIGHT IMPEDE THE CORRECT INFLATION OF THE SIDE CURTAIN AIR BAG NEAR THE UPPER PORTION OF THE B-PILLAR.

Jul 06, 2010 – NISSAN IS RECALLING FORTY-SIX CERTAIN MODEL YEAR 2002 PATHFINDER AND INFINITI QX4 VEHICLES MANUFACTURED FROM AUGUST 24, 2001 THROUGH AUGUST 28, 2001. THE AIR BAG INFLATOR CONTAINS PROPELLANT WAFERS THAT ARE REQUIRED TO PROPERLY DEPLOY THE FRONT PASSENGER AIR BAG. DUE TO IMPROPER PROPELLANT WAFER INSTALLATION DURING THE AIR BAG INFLATOR ASSEMBLY PROCESS, SOME AIR BAG INFLATORS MAY BE MISSING ONE OF THE WAFERS. AS A RESULT, THE REMAINING WAFERS IN THE INFLATOR USED FOR THE DEPLOYMENT OF THE FRONT PASSENGER AIR BAG MAY, OVER TIME, BREAK UP INTO POWDER DUE TO NORMAL VIBRATION EXPERIENCED WHILE DRIVING. THIS CAUSES THE COMBUSTION RATE OF THE PROPELLANT TO INCREASE INSIDE THE INFLATOR, WHICH CAN LEAD TO INTERNAL PRESSURE RISING SUDDENLY DURING AIR BAG DEPLOYMENT.

May 20, 2010 – NISSAN IS RECALLING CERTAIN FRONT AND REAR LOWER LINKS, P/NOS. 54501ZQ00A, 54500ZQ00A, 551A1ZQ00A, 551A0ZQ00A , 54501EA00A, 54500EA00A, 551A1EA500, 551A0EA500, 54501ZR00A, AND 54500ZR00A, SOLD BETWEEN NOVEMBER 25, 2009 AND MAY 14, 2010 AS REPLACEMENT PARTS FOR MODEL YEAR 2004 THROUGH 2010 TITAN, ARMADA, AND QX56, AND MODEL YEARS 2005 THROUGH 2010 FRONTIER, XTERRA, AND PATHFINDER VEHICLES. THE LOWER CONTROL LINK ASSEMBLY HAS TWO CYLINDRICAL COLLARS FORMING THE INBOARD ATTACHMENT POINTS TO THE CHASSIS. DUE TO AN IMPROPER WELDING PROCESS SOME COLLARS MAY CONTAIN WELDS THAT DO NOT MEET STRENGTH SPECIFICATIONS.

May 14, 2010 – NISSAN IS RECALLING CERTAIN MODEL YEAR 2010 TITAN, ARMADA, QX56, FRONTIER, XTERRA, AND PATHFINDER VEHICLES MANUFACTURED FROM NOVEMBER 19, 2009 THROUGH MARCH 3, 2010. THE LOWER CONTROL LINK ASSEMBLY HAS TWO CYLINDRICAL COLLARS FORMING THE INBOARD ATTACHMENT POINTS TO THE CHASSIS. DUE TO AN IMPROPER WELDING PROCESS SOME COLLARS MAY CONTAIN WELDS THAT DO NOT MEET STRENGTH SPECIFICATIONS.

Mar 03, 2010 – NISSAN IS RECALLING CERTAIN MODEL YEAR 2005-2009 TITAN, ARMADA, AND INFINITI QX56 VEHICLES. THE INSTRUMENT PANEL FUEL GAUGE MAY INACCURATELY DISPLAY THAT THE VEHICLE STILL HAS SOME FUEL, TYPICALLY ABOUT ONE QUARTER TANK, WHEN THE FUEL TANK IS EMPTY.