INTERNATIONAL HARVESTER 4700 Recalls

Nov 22, 1996 – THE DRIVE AXLE HOUSINGS CONSIST OF A PLATE STEEL CENTER SECTION AND TWO FORGED SPINDLES, ONE OF WHICH IS WELDED TO EACH END OF THE CENTER SECTION. EACH SPINDLE CONTAINS A KEYWAY SLOT IN WHICH THE LOCKING TAB FOR THE WHEEL BEARING NUT LOCKING MECHANISM IS INSERTED. THE LENGTH OF THE KEYWAY SLOT MAY NOT BE LONG ENOUGH TO ACCOMMODATE THE TAB CAUSING THE TAB TO BE DEFORMED OR DAMAGED DURING INSTALLATION.

Aug 20, 1996 – THE STEERING COLUMN USED WAS INCORRECTLY MANUFACTURED. THE TUBE PORTION OF THE STEERING COLUMN HAS A WELDED END WITH A SPECIFIED LENGTH OF 5.5 INCHES. A 3.5 INCH WELDED END WAS USED BY MISTAKE. WITH THE SHORTER END, IT IS POSSIBLE THERE IS INSUFFICIENT ENGAGEMENT OF THE MALE END INTO THE TUBE PORTION AND SEPARATION OF THE COLUMN COULD OCCUR.

Nov 22, 1994 – AT LOW AMBIENT TEMPERATURE, WITH THE PARKING BRAKE APPLIED ABD THE ENGINE RUNNING, PRESSURE CAN BUILD UP SUFFICIENTLY TO PARTIALLY PRESSURIZE THE BRAKE CHAMBER WHICH CONTROLS THE DDM PARK BRAKE AT THE REAR OF THE TRANSMISSION ALLOWING THE PARKING BRAKE TO PARTIALLY RELEASE.

Oct 07, 1994 – THE BASE OF THE ELECTRONIC ACCELERATOR PEDAL IS MADE OF DIE CAST ALUMINUM. THE BASE MOUNTS DIRECTLY TO THE CAB FIREWALL. THE CAB FIREWALL IS NOT RIGID ENOUGH OR FLAT ENOUGH AT THE MOUNTING SURFACE, CAUSING STRESS ON THE ACCELERATOR BASE THAT WILL CAUSE THE MOUNTING PADS ON THE BASE OF THE PEDAL ASSEMBLY TO FAIL AND TOTALLY SEPARATE FROM THE FIREWALL.

Aug 02, 1994 – FOUR COMPRESSION BACKPLATE RETAINING FASTENERS ON THE TURBO-CHARGER WERE TORQUED ONLY HAND TIGHT. THIS ALLOWS THE FASTENERS TO LOOSEN, AND CAUSES OIL TO LEAK INTO THE COMPRESSOR AIR SIDE OF THE TURBO-CHARGER WHICH, WHEN COUPLED WITH THE HEAT PRECIPITATED BY THE COMPRESSOR AND THE MIXING ACTION OF THE COMPRESSOR WHEEL, CAN RESULT IN AN AIR/OIL MIXTURE THAT FUELS THE ENGINE.

May 21, 1993 – THE PRESSURE RELIEF VALVE WAS OMITTED IN THE AIR TANK. THE AIR TANK IS THE RESERVOIR FOR THE AIR SUSPENSION AND IS NOT BRAKE RELATED. WITHOUT THE PRESSURE RELIEF VALVE, THERE IS NO BACK-UP SYSTEM TO LIMIT AIR PRESSURE IN THE AIR SUSPENSION SYSTEM.