INTERNATIONAL Recalls

May 21, 2003 – ON CERTAIN HEAVY DUTY TRUCKS EQUIPPED WITH DANA SPICER E-12021 12,000 LB., E-1202W 12,000 LB., OR E-1002W 10,000 LB. FRONT NON-DRIVE STEER AXLES, THE TAPERED BORE THAT CONNECTS THE DRAG LINK TO THE STEERING WAS MACHINED TOO LARGE. THE CLEARANCE BETWEEN A CORRECTLY SIZED DRAG LINK BALL STUD AND THE OVERSIZED TAPERED BORE IS SUFFICIENTLY GREAT ENOUGH TO ALLOW THE DRAG LINK BALL STUD TO FATIGUE AND BRAKE, OR ALLOW THE CASTLE NUT TO BACK ITSELF OFF AND CAUSE THE DRAG LINK TO DISCONNECT.

May 21, 2003 – ON CERTAIN HEAVY AND MEDIUM DUTY TRUCKS AND BUSES EQUIPPED WITH TRUCK HUB UNITS MANUFACTURED BY SKF EXCLUSIVELY FOR USE ON ARVINMERITOR'S FF98X SERIES NON-DRIVE STEER AXLES, THE HUB UNIT BEARINGS CAN WEAR PREMATURELY.

May 01, 2003 – ON CERTAIN HEAVY DUTY TRUCKS EQUIPPED WITH CATERPILLAR ENGINES, A SINGLE BANK TYPE EXHAUST CLAMP WAS INSTALLED ON THE TAIL PIPES INSTEAD OF A DOUBLE BAND TYPE CLAMP.

Apr 29, 2003 – CERTAIN HEAVY DUTY TRUCKS FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 104, "WINDSHIELD WIPING AND WASHING SYSTEMS." DUE TO THE DESIGN OF THE WINDSHIELD WASHER PUMP MOTOR CIRCUIT, THE SYSTEM'S ABILITY TO FUNCTION IS IMPAIRED WHEN IT IS FULL OF FROZEN WATER AND THE PUMP MOTOR SHAFT IS LOCKED OR FROZEN (CANNOT ROTATE).

Apr 03, 2003 – ON CERTAIN HEAVY DUTY TRUCKS, A BRASS FITTING CONNECTS THE DOUBLE CHECK VALVE TO THE BRAKE RELAY VALVE. WITH CERTAIN INPUTS TO THE VEHICLE, THE WEIGHT OF THE CHECK VALVE ON THE FITTING CAN CAUSE THE ASSEMBLY TO RESONATE. THE SUBJECT VIBRATION CAN CAUSE EXCESSIVE STRAIN LEVELS IN THE FITTING, WHICH COULD EVENTUALLY FATIGUE AND FAIL.

Mar 06, 2003 – ON CERTAIN HEAVY DUTY TRUCKS BUILT WITH A CATERPILLAR ENGINE WITH A 4 DEGREE TILT, THE STARTER FIELD-STUD MAY CONTACT THE FRAME RAIL BECAUSE OF VARIATIONS IN THE AIR GAP BETWEEN THE FIELD STUD AND THE FRAME RAIL. SHOULD THE STARTER FIELD STUD CONTACT THE FRAME RAIL, THERE WOULD BE A DIRECT FULL BATTERY SHORT TO THE FRAME (GROUND) WHEN THE STARTER IS IN THE CRANKING MODE.

Mar 06, 2003 – CERTAIN HEAVY DUTY TRUCKS FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 104, "WINDSHIELD WIPING AND WASHING SYSTEMS." THE WINDSHIELD WASHER WIPER SWITCH MAY NOT FUNCTION PROPERLY WHEN THE ENGINE IS RUNNING WITH ALL ACCESSORIES OFF, INCLUDING THE WINDSHIELD WIPERS, AND THE WASH FUNCTION IS ACTIVATED. WASHER FLUID MAY SQUIRT BRIEFLY OR NOT AT ALL ONTO THE WINDSHIELD.

Mar 06, 2003 – ON CERTAIN HEAVY DUTY TRUCKS BUILT WITH A DETROIT ENGINE AND A LEECE NEVILLE ALTERNATOR. THE ELECTRICAL TERMINAL AT THE ALTERNATOR END OF THE CABLE THAT RUNS FROM THE STARTER TO THE BATTERY STUD ON THE ALTERNATOR MAY BREAK OFF, DUE TO VIBRATION IN THE CABLE.

Mar 06, 2003 – ON CERTAIN HEAVY DUTY TRUCKS BUILT WITH INTERNATIONAL CODE 16SCH (LOWER BUNK WEBBING RESTRAINT). FOUR BOLTS HOLD THE BUNK WEBBING RESTRAINT LATCH BRACKETS TO THE BUNK BASE. THESE BOLTS WERE SUPPOSED TO BE GRADE 8 BOLTS BUT GRADE 5 BOLTS WERE INSTALLED.

Mar 06, 2003 – ON CERTAIN HEAVY DUTY TRUCKS EQUIPPED WITH BOSTROM DRIVER SEAT MODELS 910, 910SC, OR 914 AND INTERNATIONAL'S PARKING BRAKE CODE 04036, IF SOMEONE OUTSIDE THE CAB ADJUSTS/SLIDES THE DRIVER'S SEAT TO ITS MOST FORWARD POSITION, WITH THE PARKING BRAKE SET, THE SEAT WILL CONTACT AND RELEASE THE PARKING BRAKE LEVER.