KENWORTH T600 Recalls

Nov 29, 2005 – ON CERTAIN TRUCKS EQUIPPED WITH THE BENDIX ELECTRONIC STABILITY CONTROL (ESP) SYSTEM, THE SYSTEM USES MULTIPLE SENSORS AND AN ELECTRONIC CONTROL UNIT (ECU) TO CONTROL VEHICLE UNDER STEER, OVER-STEER, AND ROLLOVER SITUATIONS. THE SYSTEM RELIES ON VEHICLE SENSORS TO BE FUNCTIONING AND ALIGNED PROPERLY. THE STEERING ANGLE SENSOR HAS THE POTENTIAL TO BE MISALIGNED WITH THE STEERING COLUMN SHAFT, THEREBY PROVIDING INCORRECT INFORMATION TO THE BENDIX ECU.

May 19, 2005 – ON CERTAIN TRUCKS AND TRACTORS EQUIPPED WITH AIRGLIDE HIGH-ARTICULATION REAR SUSPENSIONS, THE C65-1006 SWAY BAR USED IN THIS REAR SUSPENSION MAY EXPERIENCE A REDUCTION IN FATIGUE LIFE DUE TO EITHER A MANUFACTURING PROCESS OR A HIGH INDUCED STRESS DURING AN EXTREME SUSPENSION ARTICULATION EVENT.

Apr 28, 2005 – ON CERTAIN HEAVY DUTY CLASS 8 TRUCKS, THE SUSPENSION HAS TRANSVERSE BEAM CASTINGS THAT MAY FRACTURE UNDER NORMAL LOADS. IF A CASTING BREAKS WHEN THE VEHICLE IS TRAVELING ON A ROADWAY THERE IS THE POTENTIAL FOR PIECES OF THE CASTING TO BECOME PROJECTILES AND THE SUSPENSION'S TRANSVERSE BEAM MAY DROP DOWN LOW ENOUGH TO CONTACT THE ROAD SURFACE.

Dec 10, 2004 – ON CERTAIN TRUCKS, THE POWER FEED HARNESS P92-1993 TERMINALS WERE NOT PROPERLY CRIMPED.

Nov 02, 2004 – ON CERTAIN TRUCKS, SOME OF THE HUCK BOLTS ON THE CAB MAY NOT HAVE BEEN PROPERLY INSTALLED.

Sep 13, 2004 – ON CERTAIN TRUCKS BUILT WITH THE OPTIONAL DANA SPL DRIVELINE, THE U-JOINT FASTENERS AT THE OUTPUT YOKE OF THE TRANSMISSION WERE NOT PROPERLY TIGHTENED.

Jul 21, 2004 – ON CERTAIN TRUCKS EQUIPPED WITH A COMBINATION OF CATERPILLAR C11/C13 ENGINES AND AN OPTIONAL LEECE NEVILLE BRUSHLESS ALTERNATOR, A CHAFFING POINT MAY EXIST BETWEEN A HEAT SHIELD ON THE ENGINE AND THE WIRING FOR THE ALTERNATOR.

Jul 15, 2004 – CERTAIN TRUCKS FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 120, 'TIRE SELECTION AND RIMS FOR MOTOR VEHICLES OTHER THAN PASSENGER CARS.' THE TIRE PRESSURE WAS OMITTED FROM THE VEHICLE'S CERTIFICATION LABEL.

Apr 12, 2004 – CERTAIN TRUCKS EQUIPPED WITH EATON FULLER ULTRASONIC TRANSMISSIONS FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 102, "TRANSMISSION SHIFT LEVER SEQUENCE, STARTER INTERLOCK AND TRANSMISSION BRAKING EFFECT." THE CAB TRANSMISSION HARNESS COULD HAVE BEEN INCORRECTLY WIRED DURING PRODUCTION INSTALLATION.

Aug 05, 2003 – ON CERTAIN HEAVY DUTY TRUCKS, THE MAIN CAB WIRING HARNESS WAS INCORRECTLY CONNECTED TO THE 50 AMP CIRCUIT BREAKER INSTEAD OF THE 135 AMP BREAKER.