KENWORTH T800 Recalls

Jul 05, 2007 – ON CERTAIN TRUCKS BUILT WITH CUMMINS ISM C876 ENGINES, THE ELECTRONIC CONTROL MODULE FAILS TO RECOGNIZE INPUTS OF THE VEHICLE ELECTRONIC CONTROL UNIT OR FROM A DRIVER ACTUATED DASH SWITCH THEREBY INCREASING THE RISK OF UNINTENDED (OR UNEXPECTED) ELEVATED EXHAUST TEMPERATURES.

Jun 28, 2007 – ON CERTAIN TRUCKS EQUIPPED WITH CATERPILLAR C11, C13 OR C15 ENGINES, THE OIL FILL CAP CAN BECOME DISLODGED DUE TO CAP DAMAGE OR IMPROPER INSTALLATION AND BECOME LODGED IN THE U-JOINT OF THE STEERING DRIVELINE AND STEERING GEAR.

Jun 26, 2007 – ON CERTAIN TRUCKS, THE REMOVABLE TOW HITCH ,WHEN USED TO TOW OR LIFT A VEHICLE, CAN FAIL DUE TO DEFECTIVE MATERIAL IN THE TOW HITCH.

Apr 18, 2007 – CERTAIN TRUCK EQUIPPED WITH BEHR CABLES, THE CABLES WERE INSTALLED INCORRECTLY AND ARE TOO LONG.

Apr 10, 2007 – ON CERTAIN TRUCKS, IF THE IGNITION SWITCH IS TURNED ON PRIOR TO INITIAL START UP IN THE MANUFACTURING PLANT OR DURING THE FILTER REPLACEMENT IN THE FIELD, A SMALL FLAME WILL IGNITE WHEN THE FUEL IS ADDED TO PRIME THE SYSTEM.

Mar 22, 2007 – ON CERTAIN TRUCKS, THE AXLE HOUSINGS MAY HAVE BEEN MANUFACTURED WITH STEEL THAT WAS OUT OF SPECIFICATION WHICH COULD RESULT IN A FATIGUE FAILURE OVER TIME.

Mar 16, 2007 – ON CERTAIN TRUCKS, THE WIRING, PARTS, OR TRANSMISSION PROGRAMMING REQUIRED FOR THE AUTO NEUTRAL FEATURE TO FUNCTION AS DESIGNED WERE EITHER NOT INSTALLED, CONNECTED, OR PROGRAMMED PROPERLY.

Mar 09, 2007 – CERTAIN TRUCKS FAIL TO COMPLY WITH THE BRAKE TIMING REGULATORY REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 121, "AIR BRAKE SYSTEMS." THE BRAKE VALVE WAS MOVED TO THE OPPOSITE RAIL, INCREASING THE LENGTH OF THE AIR LINE, WHICH IN TURN INCREASED THE WHEELBASE REQUIRING A DUAL RELAY VALVE SYSTEM. THE VEHICLES WERE MANUFACTURED WITH A SINGLE VALVE SYSTEM.

Mar 02, 2007 – CERTAIN TRUCKS FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 121, "AIR BRAKE SYSTEMS." THE TRAILER LIGHT LINE MAY HAVE BEEN ROUTED USING TOO TIGHT OF A BEND RADIUS. THIS ROUTING METHOD COULD CAUSE THE WIRES WITHIN THE HARNESS PLUG TO BE PULLED AWAY FROM THE CHASSIS PLUG RESULTING IN AN INTERMITTENT OR COMPLETE ELECTRICAL POWER LOSS TO THE TRAILER.

Nov 30, 2006 – ON CERTAIN TRUCKS, AN RA529 KING PIN RELEASE AIR VALVE WAS MANUFACTURED WITH THE INTERNAL SPOOL INSTALLED BACKWARDS. THIS RESULTS IN THE AIR OPTION OF THE KING PIN RELEASE SYSTEM BEING INOPERABLE. TO CORRECT THIS SITUATION, THE VEHICLE'S AIR LINES WERE REVERSED RATHER THAN REPLACING THE VALVE.