SATURN Recalls

Nov 07, 2007 – ON CERTAIN PASSENGER VEHICLES EQUIPPED WITH A 2.2L 4-CYLINDER ENGINE, LINKS IN THE ENGINE'S TIMING CHAIN CAN SEPARATE.

Sep 26, 2007 – CERTAIN PASSENGER VEHICLES FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 207, "SEATING SYSTEMS." AND STANDARD NO. 210, "SEAT BELT ASSEMBLY ANCHORAGES." THESE VEHICLES MAY HAVE ONE TO FOUR INBOARD SEAT STUD FASTENERS THAT DO NOT MEET SPECIFICATION FOR STRENGTH.

Feb 21, 2007 – ON CERTAIN VEHICLES, THE SENSING AND DIAGNOSTIC MODULE (SDM), WHICH CONTROLS THE FUNCTION OF FRONT AIR BAGS, MAY NOT OPERATE PROPERLY. AS A RESULT, THE FRONT AIR BAGS MAY FAIL TO DEPLOY IN A FRONTAL CRASH. ALSO, THE AIR BAG WARNING LAMP ON THE INSTRUMENT PANEL MAY FAIL TO PROVIDE WARNING THAT THE SYSTEM IS INOPERATIVE.

Mar 23, 2006 – CERTAIN PRO-A MOTORS CORNER LAMPS, TURN SIGNALS, AND HEADLIGHTS SOLD AS REPLACEMENT LAMPS FOR USE ON CERTAIN PASSENGER VEHICLES LISTED ABOVE. SOME COMBINATION LAMPS THAT ARE NOT EQUIPPED WITH AMBER SIDE REFLECTORS FAIL TO CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT.

Dec 07, 2005 – CERTAIN TRUCKS AND SPORT UTILITY VEHICLES FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 110, "TIRE SELECTION AND RIMS." THESE VEHICLES WERE SHIPPED WITH TIRE AND LOADING INFORMATION LABELS LISTING AN INACCCURATE VEHICLE CAPACITY WEIGHT.

Jun 20, 2005 – CERTAIN SPORT UTILITY VEHICLES FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 135, 'PASSENGER CAR BRAKE SYSTEMS.' TO MEET THE STANDARD, THE VEHICLE MUST NOT MOVE FOR FIVE MINUTES WHEN STOPPED ON A STEEP HILL WITH THE PARKING BRAKE APPLIED AND THE VEHICLE IN NEUTRAL (N). SOME OF THESE VEHICLES FAILED THIS TEST.

Jun 02, 2005 – ON CERTAIN SEDANS AND WAGONS, THE PLASTIC HOUSING IN THE REAR TAIL LAMP ASSEMBLY CAN BECOME DISTORTED IF THE BRAKE LAMPS REMAIN ON FOR AN EXTENDED TIME.

Apr 20, 2005 – CERTAIN WAGONS FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 210, "SEAT BELT ASSEMBLY ANCHORAGES." THE SEAT BELT ANCHOR MAY SEPARATE FROM THE FLOOR OF THE VEHICLE BEFORE HOLDING THE REQUIRED TEST LOAD FOR THE REQUIRED TIME.

Feb 18, 2005 – ON CERTAIN MINIVANS, THE OUTBOARD RELEASE HANDLE ON THE IMPACT-SIDE SECOND-ROW BUCKET SEAT MAY BE ACTUATED AND THE REAR LATCHES MAY UNLATCH EARLY IN A SIDE IMPACT CRASH. THIS WAS DISCOVERED IN A SIDE IMPACT TEST RUN BY GM, UNDER CONDITIONS SIMILAR TO NHTSA'S NEW CAR ASSESSMENT PROGRAM (NCAP) SIDE IMPACT TEST.

Nov 16, 2004 – CERTAIN PASSENGER VEHICLES HAVE A CONDITION IN WHICH THE TURN SIGNAL LAMP AND DAYTIME RUNNING LAMP (DRL) ON EITHER FRONT SIDE CAN STOP WORKING BECAUSE OF LOSS OF CONTACT BETWEEN THE BULB AND SOCKET.