SUZUKI GSX-R1000 Recalls

Oct 04, 2018 – Suzuki Motor of America, Inc. (Suzuki) is recalling certain 2017-2018 Suzuki DL650A, DL650XA, GSX-R1000, GSX-R1000R, and 2018 GSX-S750 motorcycles. During installation, the fuel pump O-ring may have been twisted, reducing the sealing performance and possibly resulting in a fuel leak.

Jan 22, 2018 – Suzuki Motor of America, Inc. (Suzuki) is recalling certain 2017-2018 GSX-R1000, GSX-R1000A, GSX-R1000RA, and GSX-R1000RZA motorcycles. When upshifting between first and second gear, if the rider fails to engage second gear, a neutral condition will exist and may cause very high engine RPM. If the rider then shifts into second gear without disengaging the clutch, the motorcycle?s chain may stretch or break.

Oct 07, 2014 – Suzuki Motor of America, Inc. (Suzuki) is recalling certain model year 2011-2014 GSX-R750 and 2009-2014 GSX-R1000 motorcycles. If a gear is missed while upshifting, the strain applied to the drive chain after the next shift may cause the rear axle to move, damaging the left-side drive chain adjuster.

Oct 18, 2013 – Suzuki Motor of America, Inc. (Suzuki) is recalling certain model year 2004-2013 GSX-R600 and GSX-R750, and model year 2005-2013 GSX-R1000 motorcycles. In combination with older brake fluid, corrosion of the brake piston inside of the front brake master cylinder generates gas that may result in a reduction of fluid pressure transmission to the front brake.

May 21, 2012 – SUZUKI IS RECALLING CERTAIN MODEL YEAR 2012 GSX-R1000 MOTORCYCLES. DUE TO LOOSE BOLTS THE SIDE STAND INTERLOCK SWITCH MAY FAIL.

Jan 16, 2009 – AMERICAN SUZUKI (SUZUKI) IS CONDUCTING A SAFETY IMPROVEMENT CAMPAIGN INVOLVING 26,082 MY 2005-2006 GSX-R1000 MOTORCYCLES. CRACKING OR BREAKAGE OF THE MOTORCYCLE FRAME CAN OCCUR IN CERTAIN EXTREME SITUATIONS WHERE UNUSUALLY HIGH STRESS IS PLACED ON THE FRAME. REPEATED HARD LANDINGS FROM HAZARDOUS MANEUVERS SUCH AS EXTREME OR EXTENDED WHEELIES OR OTHER STUNTS MAY GENERATE SUFFICIENT STRESS TO CAUSE THIS PROBLEM.

Aug 15, 2007 – ON CERTAIN MOTORCYCLES, EACH TIME THE IGNITION SWITCH IS TURNED OFF, THE ENGINE CONTROL MODULE (ECM) PRE-SETS THE POSITION OF THE IDLE SPEED CONTROL (ISC) VALVE FOR SUBSEQUENT ENGINE STARTING BY OPENING THE VALVE COMPLETELY AND THEN CLOSING IT TO A START-UP POSITION.