VOLVO VH Recalls

Oct 23, 2007 – ON CERTAIN TRUCKS EQUIPPED WITH A SAF HOLLAND SIMPLEX FIFTH WHEEL, THE LEVER ARM PIVOT BOLT MAY HAVE BEEN OVER TIGHTENED. AN OVER TIGHTENED PIVOT BOLT CAN DISTORT THE PIVOT BOLT SPACER SLEEVE, WHICH MAY PREVENT THE FIFTH WHEEL LATCH JAW FROM CLOSING AND LATCHING SECURELY AROUND THE TRAILER KING PIN.

Sep 10, 2007 – ON CERTAIN TRUCKS, THE HOOD RESTRAINT CYLINDER DOES NOT CONTAIN ENOUGH DAMPENING TO ADEQUATELY RESTRAIN THE HOOD.

Aug 07, 2007 – ON CERTAIN TRUCKS, AN UNPROTECTED LEAD IN THE THERMOSWITCH OF THE HEATER MAY MAKE CONTACT WITH ANOTHER POST POSSIBLY CREATING A SHORT CIRCUIT, WHICH CAN RESULT IN CONTINUOUS OPERATION OF THE HEATING ELEMENT.

Jul 24, 2007 – ON CERTAIN TRUCKS, THE NUT USED TO RETAIN THE STEERING SHAFT MAY OR MAY NOT BE A LOCK NUT THAT HAS THE LOCKING FEATURE. A LOCK NUT IS REQUIRED TO PROVIDE ADDITIONAL RESISTANCE TO ENSURE THAT THE NUT DOES NOT COME LOOSE.

Jun 14, 2006 – ON CERTAIN TRUCKS, THE WHEEL SPACER MAY BECOME DISTORTED FROM HEAT WHICH POTENTIALLY COULD LEAD TO A LOSS OF CLAMP THAT MAY RESULT IN LOOSE WHEEL NUTS.

Apr 04, 2006 – ON CERTAIN HEAVY DUTY CLASS 8 TRUCKS EQUIPPED WITH DANA STEERING SHAFTS, THERE IS A POTENTIAL THAT THE STEERING SHAFT PINCH BOLT HOLE MAY BE INCORRECTLY LOCATED. THE PINCH BOLT FITS INTO A GROOVE IN THE STEERING GEAR INPUT SHAFT TO ENSURE THAT THE STEERING SHAFT DOES NOT SEPARATE FROM THE STEERING GEAR IF THE PINCH BOLT COMES LOOSE.

Jan 26, 2006 – ON CERTAIN TRUCKS EQUIPPED WITH D12D ENGINES, THE EXHAUST GAS RECIRCULATION (EGR) COOLER INLET PIPES OR THE PIPES THAT CONNECT THE EGR VALVES TO THE COOLER MAY CRACK OR BREAK.

Jul 07, 2005 – ON CERTAIN HEAVY DUTY CLASS 8 TRUCKS, EQUIPPED WITH HOLLAND AIR SUSPENSION SYSTEMS, A TRANSVERSE BEAM CASTING MAY FRACTURE UNDER NORMAL LOADS. IF A CASTING BREAKS WHEN THE VEHICLE IS TRAVELING ON A ROADWAY THERE IS THE POTENTIAL FOR PIECES OF THE CASTING TO BECOME PROJECTILES AND THE SUSPENSION?S TRANSVERSE BEAM MAY DROP DOWN LOW ENOUGH TO CONTACT THE ROAD SURFACE.

Apr 28, 2005 – CERTAIN TRUCKS EQUIPPED WITH AN AUXILIARY LIFT AXLE FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 121, 'AIR BRAKE SYSTEMS.' AN AUXILIARY AIR TANK REQUIRED FOR THE AUXILIARY LIFT AXLE WAS NOT INSTALLED.

Apr 22, 2005 – ON CERTAIN HEAVY DUTY CLASS 8 TRUCKS EQUIPPED WITH ACCURIDE ALUMINUM WHEELS, THE WHEELS WERE NOT PROPERLY PRE-STRESSED. THIS ALLOWS CRACKS TO DEVELOP OVER TIME.