VOLVO VH Recalls

Sep 17, 2004 – ON CERTAIN TRUCKS EQUIPPED WITH VALEO WIPER SYSTEMS, THE WIPER MOTOR MAY BE SUSCEPTIVE TO SALT INTRUSION THAT COULD POSSIBLY LEAD TO A CONDITION WHERE THE CONNECTOR OVERHEATS TO A POINT WHERE THE CONNECTOR COULD IGNITE.

Aug 12, 2004 – CERTAIN TRUCKS FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 207, 'SEATING SYSTEMS.' THE BENCH SEAT, AS INSTALLED, DOES NOT THE SEAT PULL REQUIREMENTS OF THE STANDARD.

Feb 13, 2004 – ON CERTAIN HEAVY-DUTY CLASS 8 TRUCKS, THE ASSEMBLED ENGINE PRE-HEATER JUMPER WIRING HARNESS WAS INCORRECTLY ASSEMBLED.

Feb 13, 2004 – ON CERTAIN HEAVY-DUTY CLASS 8 TRUCKS, THE PINCH BOLT ATTACHING THE STEERING DRAG LINK TO THE PITMAN ARM MAY NOT HAVE BEEN SUFFICIENTLY TIGHTENED.

May 30, 2003 – ON CERTAIN HEAVY DUTY TRUCKS EQUIPPED WITH JOST INTERNATIONAL JSK 37U SERIES FIFTH WHEELS, A FATIGUE CRACK CAN DEVELOP IN THE BRACKET PIN WELD UNDER CERTAIN LOADING CONDITIONS.

Mar 20, 2003 – CERTAIN HEAVY DUTY CLASS 8 TRUCKS EQUIPPED WITH AN OPTIONAL TWO-MAN PASSENGER BENCH SEAT FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 210, "SEAT BELT ASSEMBLY ANCHORAGES." ON THE TWO-MAN PASSENGER BENCH SEAT INBOARD (CENTER) POSITION, SEAT BELT D-RING MOUNTING BRACKET WELDNUT, THE WELD IS NOT SUFFICIENT TO MEET THE SEAT BELT PULL REQUIREMENTS .

Nov 25, 2002 – ON CERTAIN HEAVY DUTY CLASS 8 TRUCKS WITH VOLVO B-RIDE REAR SUSPENSION, THE FORWARD AND/OR REAR DRIVE AXLE UPPER AXLE SEAT COULD BREAK ALLOWING THE AFFECTED AXLE TO SHIFT OUT OF ALIGNMENT.

Aug 15, 2002 – ON SOME HEAVY DUTY CLASS 8 VEHICLES EQUIPPED WITH ARVINMERITOR AXLE ASSEMBLIES WHICH MAY HAVE BEEN MANUFACTURED WITH TRW MODEL 20EDL BALL SOCKETS, THE TIE ROD BALL-SOCKET BEARINGS HAVE A BELOW SPECIFICATION CASE DEPTH AND/OR HARDNESS WHICH CAN LEAD TO PREMATURE WEAR OUT OF THE SOCKET IN SOME APPLICATIONS.

Jun 13, 2002 – ON CERTAIN HEAVY DUTY CLASS 8 AXLE BACK VEHICLES, THE TELESCOPING STEERING SHAFT IN SOME DRIVING SITUATIONS COULD BOTTOM OUT AND SIDE LOAD THE STEERING GEAR INPUT SHAFT WHENEVER THE ADJUSTABLE STEERING COLUMN IS ADJUSTED TO THE LOWER POSITION.

Feb 11, 2002 – ON CERTAIN HEAVY DUTY TRUCKS EQUIPPED WITH MERITOR WABCO PNEUMATIC ANITLOCK BRAKE SYSTEM (ABS) VALVE PACKAGES, THE ASSEMBLY BOLTS ON THESE VALVE PACKAGES WERE NOT TIGHTENED CORRECTLY.