AUDI Complaints

At approximately 43,044 miles, my 2021 Audi A7 55 TFSI e quattro (PHEV) was diagnosed with a failed N632 coolant changeover valve — a component of the PHEV thermal management heating circuit. The vehicle has a complete, documented service history with no maintenance gaps. The N632 is an electronically controlled valve that routes coolant between the combustion and hybrid/electric circuits and is essential for cabin heating in EV mode, battery pre-conditioning, and engine warm-up. Failure of this valve can result in loss of cabin heat, coolant leaks into the engine bay, and potential cascade of electrical faults if coolant migrates into the wiring harness. The repair estimate is $1,700. The factory warranty, Audi Care plan, and third-party extended service contract (United Car Care Protection Plus) have all denied coverage. This failure on a low-mileage PHEV with full service history suggests a premature component defect in Audi's PHEV thermal management system. I am requesting NHTSA investigate whether this constitutes a pattern of failure across 2021 Audi PHEV vehicles.

A vehicle was taken to a collision repair facility following minor front-end damage. At intake, the repair facility documented visible exterior damage but did not perform or document an underbody inspection, which is necessary to assess high-voltage battery integrity in electric vehicles. After the vehicle entered teardown, the repair facility later claimed that the high-voltage battery was damaged and recommended that the vehicle be declared a total loss. This determination was made without documented evidence of required OEM diagnostic procedures and without initial intake documentation supporting battery damage. The sequence and timing of documentation raises concern that the battery damage determination was made after teardown rather than through proper inspection protocols. A subsequent manufacturer-level evaluation did not support the claim of battery damage. This situation presents a safety concern regarding whether proper high-voltage battery inspection and handling procedures are being followed by collision repair facilities. Misidentifying or improperly handling high-voltage battery conditions in electric vehicles can pose safety risks, including potential thermal events, improper classification of vehicle safety, or unsafe return to service. This complaint is submitted to request review of whether proper safety and OEM procedures were followed in evaluating the high-voltage battery, and whether this reflects a broader safety issue in electric vehicle collision repair practices.

While normal driving the screen infotainment system or MMI turns off and takes a few minutes to come back up. When it comes back up it does not remember the user and asks for a PIN code. This is very disruptive as it happens while driving and is not safe to drive while it is rebooting It also happens randomly and there is no pattern to it , can happen once or twice or not happen for a given drive period

Component/System: Windshield washer fluid monitoring system (level sensor and warning). Observed Behavior: The system provides no advance or “low level” warning. The only alert occurs when the reservoir is completely empty, with no intermediate notification of low fluid. Failure Mode / Functional Impact: Washer function is lost suddenly without prior warning. The driver is not given an opportunity to refill fluid before the system becomes non-functional. Safety Risk: Loss of washer fluid prevents clearing road spray, salt, or debris from the windshield, causing immediate degradation of forward visibility. This is most critical during highway driving, winter conditions, and repeated washer use. The absence of advance warning creates a foreseeable risk of reduced visibility while operating the vehicle. ADAS Impact: The vehicle uses a forward-facing camera behind the windshield for driver assistance features. When the windshield becomes contaminated and cannot be cleaned due to depleted washer fluid, camera visibility may be impaired. This may reduce performance or temporarily disable features such as lane keeping, lane departure warning, and traffic sign recognition, resulting in simultaneous degradation of driver visibility and certain assistance systems. Reproduction / Confirmation: An authorized Audi dealer confirmed this behavior as normal and consistent with design. Audi customer care supported this position. Inspection History: The vehicle has been inspected by an authorized Audi dealer. No inspection by police or insurance representatives. Warnings Prior to Failure: No warnings, messages, or symptoms appear prior to complete depletion. The only alert occurs when the system is empty. Requested Evaluation: Evaluation is requested as to whether this design adequately supports driver visibility and safe operation, and whether any modification exists or is planned to provide earlier warning.

Purchased a used 2022 Audi E-Tron GT with an open NHTSA safety recall for high-voltage battery fire risk (Recall 24V726 / Audi 931A). The recall remedy had not been performed at time of purchase. The selling dealer completed a pre-delivery inspection two weeks prior to sale with full knowledge of the open recall. Within 7 weeks of purchase, the vehicle entered limited performance mode (turtle mode) while driving and had to be towed. A high-voltage coolant pump was diagnosed faulty and replaced. Days later, the vehicle powered down completely while driving. Fault codes indicated an implausible signal from the HV battery controller. The battery management controller (J840) was replaced. After replacement, additional faults were found. The HV battery switch box (SX6) was also diagnosed faulty and replaced. The vehicle was out of service approximately 18 days for this event alone. Within 11 months of purchase, the vehicle developed water intrusion in the trunk area traced to a faulty spoiler motor sealing surface. This caused corrosion to the center tail lamp connector, electrical shorts to all three tail lamps, and required repair of six wiring harness connections. A body electrical wiring repair was also documented in service history prior to purchase, suggesting a pre-existing sealing defect. Total: 9 dealer visits and 50+ days out of service in under 14 months. All repairs performed under manufacturer warranty. The open safety recall was not completed until 8 months after purchase.

I am reporting a safety-related defect involving my 2025 Audi vehicle. Shortly after leasing the vehicle in 09/2025, I experienced electrical and system malfunctions while driving, including warning lights, intermittent adaptive cruise control malfunctions, erratic acceleration, sputtering, and sudden braking without warning. These issues occurred during normal driving and raised safety concerns. On 11/03/2025, the vehicle failed to start and required multiple jump starts, displaying multiple system errors including a check engine light and malfunctioning displays. During a brief attempt to drive, the steering wheel began vibrating, additional warnings appeared, and the vehicle behaved as if on rough terrain despite normal pavement. The vehicle was towed to the dealership on 11/04/2025. While there, Audi’s Technical Assistance Center (TAC) and engineers were involved, and I was informed that internal technical guidance was issued related to this issue, indicating it may not be isolated. After more than two weeks, I was told the vehicle was repaired. On 11/19/2025, immediately after pickup, it malfunctioned again at highway speed. During lane changes, the vehicle resisted steering input and attempted to keep me in the lane despite signaling, creating a loss-of-control situation that required abrupt correction. A rear crash assist malfunction warning also appeared. I returned the vehicle the same day. Although it may start and run, I do not believe it is safe to operate due to the prior loss-of-control event and continued system instability. I have been asked to drive it again to reproduce the issue, which I do not feel is safe. This may involve a defect in driver assistance and electronic control systems.

Shortly after purchasing in 2025 I began having occasional issues with the door locks. Eventually the issue would self resolve but now I have experienced at least 2 times in last month being locked inside the vehicle and unable to exit without climbing into the passenger seat. I have not taken it in for repairs yet due to cost concerns but I am worried about this dangerous situation.

I was driving home from the farmers market with my two young kids. I was turning left at a busy intersection when the engine died and an engine warning flashed on the dash (I don't recall the exact message; it sounded catastrophic). There were no "check engine" or any other warning messages prior to the incident. I was able to restart the car immediately and give it a lot of gas to get out of the intersection - thank goodness - but didn't feel it was safe to drive the full 1 mile home, as there are several inopportune locations for an engine to die along the route, so I parked it in a residential neighborhood and walked home with my kids. My instinct there seems correct as it would not start again thereafter. I got it towed on the Monday and the mechanic called me to tell me that a piston had broken off in the engine and there is complete engine failure. I've attached a photo he took. This is a car we've had for 5 months with only 47,000 miles on it, regular service according to Carfax, and full/clean oil. No error messages or warnings prior. It was really scary to be in a busy intersection with a dead engine and young kids in the car.

A metal bracket on the back left side of the driver seat snapped suddenly while driving straight and at a constant speed. Since this part is broken the seat is no longer connected to the track in that corner. The car is drivable for me because I am tall and sit with the seat at its lowest height setting. When turning or breaking quickly the seat moves, and it would obviously be a safety issue if I get into an accident. If the seat is adjusted higher it is not supported in that corner and it leans back. Yesterday I dropped it off at the dealer service center and they said it is the seat frame. I have not heard back from them yet. I am the first owner of this car, and it has not been in any serious accidents (I hit a deer once roughly 2 years ago). I am not unusually heavy.

Since the day of delivery, this 2025 Audi S5 has experienced daily electronic and safety system failures. At least once per day, on startup, the vehicle throws 10 or more warning codes disabling safety-critical systems including blind spot monitoring, lane departure warning, forward collision avoidance, rear traffic alert, and adaptive lighting. These failures occur without warning and persist for varying durations before clearing on their own. Additionally, on 5 occasions the adaptive cruise control refused to activate, displaying a false "door open" warning with all doors and trunk confirmed closed. On 4 occasions the power trunk failed to latch using the electronic controls. The 360-degree parking camera system intermittently stops rendering surroundings, displaying only the vehicle graphic with no camera feed. The vehicle was brought to the selling dealer for service. After one hour, the dealer stated no issue was found. A battery diagnostic was requested based on a documented case of an identical 2025 S5 with the same symptoms traced to a faulty 12V battery. The dealer declined to cover the diagnostic under warranty. The service manager later acknowledged these are known platform issues and confirmed a software update is expected from the manufacturer in July 2026. The vehicle already has the latest available software update (TSB 2079690, KD2, version 03.10.00/C) installed and the problems persist. The dealer has confirmed there is no current fix available. These failures put the driver and other road users at risk, as safety systems are non-functional during the error state with no indication of when they will restore.