2002 CHEVROLET AVALANCHE Complaints

The contact owns a 2002 Chevrolet Avalanche. The contact stated while attempting to stop the vehicle, the brake pedal was firm, and vehicle kept accelerating unintendedly. Several warning lights were illuminated. The vehicle was taken to an independent mechanic to be diagnosed. The contact was informed that the failure was due to a faulty ABS module. The vehicle had not been repaired. The manufacturer was made aware of the failure and determined that the vehicle was not included in a recall because he was not located in a salt State. The failure mileage was unknown.

The contact owns a 2002 Chevrolet Avalanche. The contact stated that while driving at an undisclosed speed, the ABS and oil warning lights illuminated. Additionally, the speedometer, the 4-wheel drive function, parking brake, and headlights failed to operate as needed. The instrument panel light failed to illuminate, the gear shifter did not display the selected gear, the sub-frame was corroded, and the wheel hub bearing assembly was fractured. The vehicle was not diagnosed nor repaired by an independent mechanic or dealer. The manufacturer was not made aware of the failure. The failure mileage was approximately 142,000.

BRAKE LINES ARE MADE OUT OF DEFECTIVE MATERIALS GM KNOWS THEY HAVE A PROBLEM THE LINES RUST OUT PREMATURELY . THE FIRST ONE BLEW OUT I WAS BACKING IN A PARKING SPACE PEDAL WENT TO THE FLOOR. THE SECOND ONE BLEW AT A TRAFFIC LIGHT PUSHED ON THE BRAKE WENT THRU THE RED LIGHT DODGED TRAFFIC .THE THIRD ON THE INTERSTATE TRAFFIC WAS STOPPING SUDDENLY PUSHED ON THE PEDAL ANOTHER BRAKE LINE BROKE WENT TO THE FLOOR AND I MANAGED TO HIT THE MEDIAN CROSS THE MIDDLE AND GET IT STOPPED BEFORE A HEAD ON COLLISION WITH THE TRAFFIC HEADING THE OTHER DIRECTION ON INTERSTATE 81 . THE REST OF THE UNDER SIDE IS RUST AND CORROSION FREE ONLY THE BRAKE LINES ARE RUSTED OUT ! .THAT BEING SAID GM HAS A REPAIR KIT WITH COATED LINES THEY ALWAYS HAVE IN STOCK BECAUSE THEY KNOW ITS A MAJOR PROBLEM !!! I GOT A REPAIR ESTIMATE FROM MY LOCAL DEALERSHIP $1580.00 I AM REPLACING ALL STEEL LINES . PLEASE MAKE THEM RECALL THIS IS GOING TO KILL SOMEONE

WHEN TRAVELING AT LOW SPEEDS, >5MPH, THE ABS ACTIVATES AND VEHICLE CONTINUES ON TO THE POINT OF ENTERING TRAFFIC. THIS OCCURS FREQUENTLY AND WITHOUT WARNING, AT STOP SIGNS AND EVEN JUST PULLING OUT OF PRIVATE DRIVEWAY INTO TRAFFIC. MY LOCAL MECHANIC RAN A DIAGNOSTIC TEST AND INDICATED THAT A FRONT SPEED SENSOR WAS AT FAULT. AFTER INVESTIGATING NUMEROUS SITES, I FOUND THAT THERE WAS A RECALL ISSUED FOR THE EXACT PROBLEM ON THE '02 AVALANCHE AS WELL AS OTHER SIMILAR CHASSIS TRUCKS FROM '99-'02. AND THESE WERE INCLUDED IN A RECALL OF OVER 1,353,700 TRUCKS UNDER THE NHTSA CAMPAIGN # 05V379000. THE REPORT STATED TO CONTACT GM AND REQUEST AUTHORIZATION FOR THE RECOMMENDED REPAIR. WHEN I DID THAT, THE REPRESENTATIVE STATED THAT THERE WERE NO OPEN RECALLS ACCORDING TO THE VIN. HOW DOES GM DETERMINE WHICH VIN IS AFFECTED? IS THE NHTSA MONITORING GM'S SELECTION PROCESS? I'VE OWN THE VEHICLE SINCE 6/05, AND THE ABOVE RECALL WAS INITIATED 9/05, BUT I'VE NEVER RECEIVED ANY TYPE OF NOTICE THAT MY VEHICLE MAY OR MAY NOT BE AFFECTED AND TO BRING IT TO A GM DEALER FOR INSPECTION. I'VE HAD ONE HUB ASSEMBLY REPLACED YEARS AGO AT MY OWN EXPENSE, (I WAS TOLD I HAD A BAD BEARING BUT THEY HAD THE REPLACEMENT PART ONLY CAME ASSEMBLED AS THE BEARING, HUB AND SENSOR). THE DESIGNER MUST ALSO HAVE BEEN THE SUPPLIER. IT'S GOOD THAT THERE IS THE NHTSA TO TRY AND KEEP THESE MANUFACTURERS ACCOUNTABLE FOR THE SAFETY OF THE CARS THEY PRODUCE, BUT WITH MORE AUTOMATION IN THE INDUSTRY TO CUT COSTS, YOU NOW HAVE 1 WORKER OVERSEEING WHAT IT TOOK 10 TO DO. MORE AND MORE MISTAKES ARE BOUND TO HAPPEN. OUR SAFETY IS WORTH MORE THEN THEIR CORPORATE JETS AND LAVISH LIFESTYLES.

WHILE DRIVING AT 65 MPH THE ENGINE CUT OUT. COULD BE THE CRANKSHAFT POSITION SENSOR. THE TRUCK IS A 2500 WITH AN 8.1L ENGINE. SIMILAR ISSUES THAT THE 2001 WAS RECALLED FOR. SAME ENGINE AND CPS AS THE 2001 BUT NOT INCLUDED IN THE ORIGINAL RECALL. THIS HAS HAPPENED SEVERAL TIMES AT VARIOUS SPEEDS.

WHILE DRIVING MY TRUCK AND TOWING A TRAILER, I LOST ALMOST ALL MY BRAKING POWER. HAD TO DOWN SHIFT AND USE THE EMERGENCY BRAKE TO STOP. FOUND THAT A BRAKE LINE FROM THE MASTER CYLINDER TO THE ANTI-LOCK BRAKE MODULE (WHICH IS MOUNTED UNDER THE DRIVERS SEAT, GREAT PLACE) HAD RUSTED THROUGH AND BLEW OUT. FOUND ALL THE BRAKE LINES ARE SEVERELY CORRODED IN THIS AREA AND NEED TO BE REPLACED. LOOKS LIKE GM USED INFERIOR METAL BRAKE LINES IN CONSTRUCTING THE VEHICLE AND LOCATED THE ANTI-LOCK BRAKE MODULE IN AN AREA THAT GETS SEVERE EXPOSURE TO THE ELEMENTS. THE VEHICLE WAS TOTALLY RENDERED UNSAFE WITH THE RUPTURE OF ONE BRAKE LINE, WHICH INDICATES THE SYSTEM AS A WHOLE IS A FAULTY DESIGN. I WAS VERY LUCK TO HAVE BEEN ABLE TO STOP AND NOT HIT ANOTHER VEHICLE. *TR

BRAKE PEDAL WENT TO THE FLOOR UPON BRAKING. HAD TO DOWNSHIFT TO LOW GEAR AND APPLY WHAT LITTLE BRAKE I HAD LEFT TAKING APPROXIMATELY 200 FEET TO STOP. LUCKILY THERE WAS NO VEHICLE IN FRONT OF ME OR IT WOULD HAVE BEEN A REAR END COLLISION. SLOWLY RETURNED HOME ABOUT A MILE AWAY AND UPON FURTHER INSPECTION FOUND THE HARD BRAKE LINE RIGHT FRONT PASSENGER SIDE HAD BURST. NO PRIOR WARNING TO LOSS OF BRAKES. *TR

APPLIED BRAKES TO STOP AND PEDAL WENT TO FLOOR. UPON INSPECTION FOUND BRAKE LINE RUPTURED DUE TO EXCESSIVE CORROSION. VEHICLE REQUIRED 100% REPLACEMENT OF ALL BRAKE LINES. *TR

CLEAR DRY DAY. ACCIDENT OCCURRED WHEN VEHICLE HIS A SIDE OF A BUILDING. AIR BAGS DID NOT DEPLOY RESULTING IN INJURY. *TR

THE BRAKE LINE THAT GOES THE LENGTH OF THE TRUCK FROM THE FRONT TO THE REAR BRAKES CORRODED THROUGH AND RESULTED IN THE FAILURE OF THE BRAKES ON MY TRUCK. I HAD TO STEER OFF THE ROAD AND INTO SOME BRUSH AND A DRAINAGE DITCH TO STOP THE VEHICLE AND AVOID HITTING CARS IN FRONT OF ME. *TR